brake light INFINITI Q70 2014 Quick Reference Guide

4
Forest Air® System (if so equipped)
This system helps keep the air inside your vehicle



clean using an automatic air intake and ventilation




system that monitors air quality with outside and




inside sensors.
Automatic humidity control prevents over-drying of



the passenger compartment and fogging of the




windshield.
w hen the system is ON, the defroster



may automatically turn on.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (sect\
ion 4)” of your Owner’s Manual.
Blind Spot Warning (BSW) and Blind Spot Intervention™ (BSI) (if so equipped)
The Blind Spot w arning (BS w ) system alerts the



driver when another vehicle moves into the vehicle’s




blind spot area.
An indicator light 01 near the outside mirror will

illuminate if the radar sensors detect a vehicle in



the detection zone.
The Blind Spot Intervention™ (BSI) system can assist



the driver in returning the vehicle to the center of the




traveling lane by applying individual brake pressure



to the left or right wheels for a short period of time.
The indicator light 02 will first illuminate in orange and
then turn green before turning off. This indicates that



the Blind Spot

w
arning (BS w ) and Blind Spot Intervention (BSI) systems are operational.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
02
new system features
1276460_14a_Infiniti_Q70_QRG_102813.indd 410/28/13 2:30 PM

8
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent k ey system allows you to lock
or unlock your vehicle, open your trunk and start
the engine. It is important to make sure the Intelligent
k

ey is with you (that is, in your pocket or purse).
The operating range of the Intelligent k ey is within
31.5 in (80 cm) from each request switch.
To lock the vehicle, push either door handle request s witch
01
once or press the
button
02 on the key fob.
To unlock the vehicle, perform one of the following procedures:

•
Push either door handle request switch
01 once; the corresponding

door will unlock. Push the door handle request switch 01 again within

1 minute; all other doors will unlock, or
•

Press the
button
03 on the key fob to unlock the driver’s side door.

Press the
button again; all other doors will unlock.
To open the trunk, press the hOLD button
04 for more than 1 second.
The Intelligent
k ey can also be used to activate the panic alarm by pressing
and holding the
button
05 for more than 1 second. Once activated, the

panic alarm and headlights will stay on for a period of time.
INTELLIGENT
k
EY BATTERY
d
ISC
h ARGE
If the battery of the Intelligent
k ey is discharged or
environmental conditions interfere with the Intelligent
k

ey operation, start the engine according to the
following procedure:



1.

Move the shift lever to the
P (P AR k) position.



2.

Firmly apply the foot brake.



3.

Touch the ignition switch with the Intelligent

k ey
and a chime will sound.



4.

w
ithin 10 seconds after the chime sounds, push the ignition switch while \
depressing the
brake pedal and the engine will start.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, “Starting a\
nd driving (section 5)” and the
“Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
01
02
03
04
05
1276460_14a_Infiniti_Q70_QRG_102813.indd 810/28/13 2:30 PM

11
Starting/Stopping the Engine
It is important to make sure the INFINITI Intelligent
k

ey is with you (that is, in your pocket or purse).
d epress the brake pedal.
Press the ignition switch S t AR t /S t OP button to start
the engine.
TURNING THE ENGINE OFF
Move the shift lever to the P (PAR k ) position and
apply the parking brake.
Press the ignition switch S t AR t /S t OP button to turn the engine off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
Headlight Control Switch
hEAdLIGhT CONTROL
Turn the headlight control switch to the position
01 to turn on the front parking, side marker, tail, license

plate and instrument panel lights. Turn the switch to
the
position
02 to turn on the headlights.
AUTOLIG
h
T SYSTEM
The autolight system will automatically turn the headlights on when it i\
s dark and off when it is
light. The system will keep the headlights on for a period of time after\
you turn the ignition off
and all doors are closed.
To activate the autolight system, turn the headlight control switch to t\
he AU t O position
03
then push the ignition switch to ON position. To deactivate the autolight system, turn the
headlight control switch to the OFF,
position
01 or
position
02 .
h

IG
h
BEAM SELECT
Push the headlight control switch forward 04 to

select the high beam function. The blue indicator light
illuminates in the instrument panel. Pull the
headlight switch back to the original position to
select the low beam. The blue indicator light
will extinguish.
Pull and release the headlight control switch 05 to

flash the headlight high beams on and off.
FOG LIG
h
T S
w
ITC
h
The headlights must be on and the low beams
selected for the fog lights to operate.
Turn the switch (inside collar) to the position
06
to turn the fog lights on.
Turn the switch (inside collar) to the
OFF position to
turn the fog lights off.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
03
01
02
04
05
06
1276460_14a_Infiniti_Q70_QRG_102813.indd 1110/28/13 2:31 PM

15
Conventional (Fixed Speed) Cruise Control
The cruise control system enables you to set a
constant cruising speed once the vehicle has reached
25 MP
h (40 km/h).
The system will automatically maintain the set speed
until you tap the brake pedal, accelerate, cancel or
turn the system off.
To activate the cruise control, push the ON/OFF
switch
01 . The
CRUISE
indicator light in the

instrument panel will illuminate.
To set cruising speed, accelerate the vehicle to the desired speed, push\
the COAS t /SE t
switch
02 and release. The
CRUISE SE
t indicator light
in the instrument panel will

illuminate. Take your foot off the accelerator pedal. Your vehicle will \
maintain the set speed.
To reset at a faster cruising speed, push and hold the ACCEL/RES switch
03 . when the
vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the COAS t /SE t switch
02. Release the
switch when the vehicle slows to the desired speed.
To cancel the preset speed, push the CANCEL switch
04 .
To turn off cruise control, push the ON/OFF switch
01 . Both the CRUISE indicator light and
the SE
t
indicator light in the instrument panel will extinguish.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
03
02
04
USB/iPod® Interface
The USB jack 01 is located in the center console under

the arm rest.
w hen a compatible USB memory device or iPod® is

plugged into the USB jack, compatible audio and
video files stored on the device can be played
through the vehicle’s audio system and
front display.
For more information, refer to the “Monitor, climate, audio, phone
and voice recognition systems (section 4)” of your Owner’s Manual.
01
1276460_14a_Infiniti_Q70_QRG_102813.indd 1510/28/13 2:31 PM

16
first drive features
Intelligent Cruise Control (ICC) System (if so equipped)
vEhICLE-TO-vEhICLE dISTANCE CONTROL MOdE
To set v ehicle-To- v ehicle d istance Control mode,



press the
CRUISE ON/OFF button
01 for less than
1.5 seconds. The
CRUISE indicator light
02
will illuminate.
Accelerate to the desired speed.
Push down on the COAS t /SE t switch
03 and release
it. Cruise control will be set to the desired speed.
Press the distance button 04 repeatedly to change

the set distance between long, middle and short.
w hen a vehicle is not detected ahead of you in the



lane, the set distance, and set vehicle speed indicator




lights will illuminate 05 in set mode.

w hen a vehicle is detected ahead of you in the lane, the vehicle ahead
detection, set distance and set vehicle speed indicator lights will
illuminate
06 in set mode.
To reset at a faster cruising speed, push and hold the
ACCEL/RES switch
07 . when the vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the
COAS t /SE t switch
03 . Release



the switch when the vehicle slows to the desired speed.
To cancel the preset speed, push the CANCEL switch
08 or tap the brake pedal. The set
vehicle speed indicator 05 will extinguish.
To turn off cruise control, press the
CRUISE ON/OFF button
01 . The CRUISE indicator light

02 in the instrument panel will extinguish.
To set conventional (fixed speed) cruise control mode:
w hile cruise control is off, press the CRUISE ON/OFF
button
01 and hold it down for more
than 1.5 seconds. The CRUISE
indicator light will illuminate.
Accelerate to the desired speed.
Push down on the
COAS t /SE t switch and release it. The SE t indicator light will illuminate.



Cruise control should be set to the desired speed.
To switch between the two cruise control modes:
w hen one of the two cruise modes is in use, you must turn the system off \
and then turn it on



again to select the other cruise control mode.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
0205
06
0807
03
01
04
1276460_14a_Infiniti_Q70_QRG_102813.indd 1610/28/13 2:31 PM