brake fluid INFINITI Q70 2019 Towing Guide
[x] Cancel search | Manufacturer: INFINITI, Model Year: 2019, Model line: Q70, Model: INFINITI Q70 2019Pages: 25, PDF Size: 0.38 MB
Page 14 of 25

 
 
 
 
 
2019 INFINITI Towing Guide  
 
 
13
in different configurations to adjust the tongue load and load transfer and hitch ball 
height.  On some tandem axle trailers an incorrect hitch height can result in uneven 
trailer  axle loading. 
 
  WARNING- Towing can significantly alter the handling and performance 
characteristics of your vehicle. Moreover, it puts increased strain on the engine and 
drivetrain. Therefore, it is always a good idea to approach towing from the standpoint 
of safety — whether you are purchasing equipment or actually pulling the trailer.  
 
  WARNING- Always make sure your vehicle’s towing capacity is adequate for the 
trailer you intend to tow. Be certain that you have all of the proper equipment needed 
for safe towing, such as safety chains/cables, electric trailer brakes, electric trailer 
brake controller, breakaway switch, and extended rear view mirrors.  Make certain 
your equipment conforms to all federal, state or local regulations to help ensure 
against the possibility of a serious accident and personal injury or death.  
 
You should follow a more frequent maintenance schedule and check fluid levels, 
pressures, tire condition, etc., more often when on the road. See your vehicle owner’s 
manual for details. 
LOADING YOUR TRAILER 
 
  WARNING- Taking the time to load and balance your trailer properly will improve 
overall handling and minimize the strain on your tow vehicle. Incorrectly, loaded trailers 
tend to sway or swing from side to side, upsetting vehicle handling which could result in 
a serious accident, personal injury or death. Careful loading and balancing, and a 
weight distribution hitch and sway-control device can help eliminate these problems. 
 
As mentioned earlier, conventional trailer tongue load must fall between 10-15% of the 
total trailer weight, or within the limits of the maximum trailer tongue load specified by 
the trailer manufacturer. 
 
 WARNING- Excessive trailer tongue load can actually push down the tow vehicle in 
back, lifting the front wheels to a point where traction, steering response, and braking 
may be severely reduced. which could result in an accident, personal injury or death. 
Too little trailer tongue load or negative load can lift the trailer tongue upwards on the 
trailer ball causing instability, which may lead to swaying, “tail wagging,” or jackknifing 
which could result in an accident, personal injury or death. 
 
With this in mind, proper loading is extremely 
important. When loading a trailer, 60% of 
the total cargo weight should be positioned 
in the front portion of the trailer and 40% in 
the back. Then the load should be adjusted 
until the proper tongue load ratio is 
achieved. 
 
 
 
 
60%40%
TOWING SAFETY  
Page 18 of 25

 
 
 
 
 
2019 INFINITI Towing Guide  
 
 
17
  WARNING- Do not use or rely upon the Back-up Collision Intervention system (BCI)       
when towing a trailer.  The BCI system cannot function properly when objects are 
obstructing the radar sensor beams.   
 
PARK SMART
 
A tow vehicle and trailer can be an unwieldy combination in a small area, so always 
try to park where you will have a relatively easy time maneuvering. Once parked, 
always block the wheels on both the tow vehicle and the trailer.   
 
Parking on a slope is not recommended. If, however, you must park on a slope and 
your vehicle is equipped with an automatic transmission, there are some precautions 
you should take:  
 Turn the wheels of the tow vehicle towards the side of the road away from the 
center of the road, and apply the parking brake and only then move the gear lever 
into PARK.   
 Next, block/chock the wheels once the tow vehicle and trailer are in position and 
are being held by the vehicle’s brake. 
  
 CAUTION-If you move the lever into PARK before blocking the wheels and applying 
the parking brake, it may be difficult to later shift out of PARK. Transmission damage 
may also occur. 
 
PASS CAREFULLY 
As mentioned in the introduction to this section, because of the added weight of the 
trailer, acceleration capability is reduced and you will require a longer distance to 
pass another vehicle. Be certain you have sufficient time and space to pass safely. 
 
 
  WARNING- Never attempt to pass on hills or when going around curves.  Doing so 
could cause a loss of vehicle control and result in accident, property damage or 
personal injury. Because the trailer does not follow the exact path as the tow vehicle 
on turns, safely passing and cornering while towing takes considerably more distance 
and turning space than normal. Be certain you have sufficient time and space to pass 
safely, remember, the length of the trailer must also pass the other vehicle before you 
can safely change lanes.  
 
HILLS – UPGRADES 
If your vehicle is equipped with an automatic transmission, it is designed to select 
automatically the correct gear for the best towing comfort and performance as the 
incline increases. To maintain speed or avoid up and down shifts, manually shift to a 
lower gear as needed. The added weight of a trailer places an increased load on the 
engine and cooling system, so monitor your coolant temperature gauge and 
automatic transmission fluid temperature gauge (if equipped) carefully. At the first sign 
of overheating, pull to the side of the road. See IF YOUR ENGINE OVERHEATS later in this 
section for more information.