clock INFINITI QX 2011 User Guide

Clock Format (24h) :
When this item is turned to ON, the 24-hour
clock is displayed. When this item is not turned
to ON, the 12-hour clock is displayed.
Offset (hour)/(min) :
Adjust the time by increasing or decreasing per
hour or per minute.
Daylight Saving Time :
Turn this item to ON for daylight saving time
application.
Time Zone :
Choose the time zone from the following
●Pacific
● Mountain
● Central
● Eastern
● Atlantic
● Newfoundland
● Hawaii
● Alaska
Language & Units settings
The Language & Units settings display will
appear when pushing the SETTING button.
Select the “Others” key to show the “Language
& Units” key.
Select Language :
Select the “Select Language” key. Choose “Eng-
lish”, “Français” or “Español” for your favorite
display appearance.
If you select the “Français” key, the French
language will be displayed, so please use the
French Owner’s Manual. To obtain a French
Owner’s Manual, see “OWNER’S MANUAL/ SER- VICE MANUAL ORDER INFORMATION” in the “9.
Technical and consumer information” section.
Select Units :
Select the “Select Units” key. Choose “US”
(Mile, °F, MPG) or “Metric” (km, °C, L/100 km)
for your favorite display appearance.
Voice Recognition settings
For details about the “Voice Recognition” set-
tings, see “INFINITI VOICE RECOGNITION SYS-
TEM” later in this section.
CAMERA settings
The “CAMERA” screen will appear when push-
ing the SETTING button, selecting the “Camera”
key with the INFINITI controller and pushing the
ENTER button.
For the details about the camera system opera-
tion, see “AROUND VIEW™ MONITOR SET-
TINGS” later in this section.
SAA2490
Monitor, climate, audio, phone and voice recognition systems4-17

CAUTION
Do not insert the jack rod straight as it is de-
signed to be inserted at an angle as shown.
9. Seat the T-shaped end of the jack rod intothe T-shaped opening of the spare wheel
winch. Apply pressure to keep the jack
rod engaged in the spare wheel winch
and turn the jack rod counterclockwise to
lower the spare wheel. 10. Once the spare wheel is completely low-
ered, remove the jack rod and reach
under the vehicle to remove the hanging
plate.
11. Carefully slide the spare wheel from un- der the rear of the vehicle.
After preparing the spare tire, to remove the
rod, pull out the rod while moving the rod to the
right and left with the screw of the extension
facing the side.
CAUTION
When storing the wheel, make sure that the
hanging plate is in the center of the wheel and
then lift it up into the storage area.
SCE0916SCE0377
6-6In case of emergency

1. Place the jack directly under the jack-uppoints as illustrated.
The jack should be used on level firm ground.
2. Loosen each wheel nut one or two turns by turning counterclockwise with the
wheel nut wrench. Do not remove the
wheel nuts until the tire is off the ground.
Jack-up point
SCE0875
SCE0876
6-8In case of emergency

Engine oil and filter
1. Place a large drain pan under the drainplug.
2. Remove the oil filler cap.
3. Remove the drain plug
1with a wrench
and completely drain the oil.
CAUTION
Be careful not to burn yourself, as the engine oil
is hot.
●Waste oil must be disposed of properly.
● Check your local regulations.
4. (Perform steps 4 to 7 only when the
engine oil filter change is needed.)
Loosen the oil filter2with an oil filter
wrench. Remove the oil filter by turning it by
hand.
5. Wipe the engine oil filter mounting sur- face with a clean rag.
CAUTION
Be sure to remove any old rubber gasket re-
maining on the mounting surface of the engine.
Failure to do so could lead to engine damage.
6. Coat the gasket on the new filter with clean engine oil.
7. Screw in the oil filter clockwise until a slight resistance is felt, then tighten ad-
ditionally more than 2/3 turn.
Oil filter tightening torque:11 to 15 ft-lb
(15 to 21 N·m)
8. Clean and re-install the drain plug with a
new washer. Securely tighten the drain
plug with a wrench.
Drain plug tightening torque:22 to 29 ft-lb
(29 to 39 N·m)
Do not use excessive force.
9. Refill engine with recommended oil and install the oil filler cap securely.
CAUTION
The dipstick must be inserted in place to pre-
vent oil spillage from the dipstick hole while
filling the engine with oil.
See “CAPACITIES AND RECOMMENDED FUEL/ LU-
BRICANTS” in the “9. Technical and consumer
information” section for drain and refill capacity.
The drain and refill capacity depends on the oil
temperature and drain time. Use these specifica-
tions for reference only. Always use the dipstick
to determine the proper amount of oil in the
engine.
10. Start the engine and check for leakage around the drain plug and the oil filter.
Correct as required.
SDI2528
8-10Maintenance and do-it-yourself

Child restraints................. 1-30
Booster seats ................ 1-47
LATCH system ................ 1-32
Precautions on child restraints ......1-30
Top tether strap ............... 1-34
Child safety ................... 1-28
Child safety rear door lock ...........3-6
Chimes Audible reminders ............. 2-20
Seat belt warning light and chime ....2-16
Circuit breaker, Fusible link ..........8-22
Cleaning exterior and interior .......7-2, 7-4
Climate control Automatic climate control ......4-31, 4-34
Clock ....................... 2-51
Coat hooks ................... 2-59
Cockpit ......................2-2
Cold weather driving .............5-101
Compact Disc (CD) player
(See audio system) ............... 4-57
Console box ................... 2-57
Controller, Center multi-function control
panel .......................4-3
Controls Control panel button ............4-3
INFINITI Controller ..............4-3
Coolant Capacities and recommended
fuel/lubricants ................9-2
Changing engine coolant ..........8-8
Checking engine coolant level .......8-8
Corrosion protection ...............7-6
Cruise control .................. 5-37
Fixed speed cruise control
(on ICC system) ............... 5-58
Intelligent cruise control (ICC) system . . 5-39 Cup holders
................... 2-54
D
Daytime running light system .........2-39
Dimensions ....................9-9
Distance Control Assist (DCA) system ....5-62
Distance Control Assist (DCA) system warning
light ....................... 2-13
Dot matrix liquid crystal display .......2-21
Drive belts .................... 8-17
Drive positioner ................. 3-30
Driving Cold
weather driving ........... 5-101
Driving with automatic transmission . . . 5-15
On-pavement and off-road driving .....5-6
Precautions when starting and driving . . 5-2
Safety precautions ..............5-8
Dual head restraint DVD system .......4-83
E
Economy, Fuel ................. 5-83
Elapsed time .................. 2-27
Emission control information label ......9-11
Emission control system warranty ......9-29
Engine Before starting the engine .........5-13
Break-in schedule ............. 5-83
Capacities and recommended
fuel/lubricants ................9-2
Changing engine coolant ..........8-8
Changing engine oil and filter .......8-9
Checking engine coolant level .......8-8Checking engine oil level
..........8-9
Coolant temperature gauge . . .......2-7
Emergency engine shut off .........5-12
Engine block heater ............5-102
Engine compartment check locations . . . 8-6
Engine cooling system ...........8-7
Engine oil ...................8-9
Engine oil and oil filter
recommendation ...............9-6
Engine oil replacement indicator .....2-25
Engine oil viscosity .............9-6
Engine serial number ............9-10
Engine specifications ............9-8
Engine start operation indicator .....2-23
If your vehicle overheats ..........6-13
Oil pressure gauge .............2-8
Protection mode ............... 5-14
Starting the engine ............. 5-13
Entry/exit function, Automatic drive
positioner .................... 3-30
Event Data Recorders (EDR) ..........9-32
Exhaust gas (carbon monoxide) ........5-2
Extended storage switch ............8-23
F
F.M.V.S.S./C.M.V.S.S. certification label . . . 9-11
Filter Air cleaner housing filter ..........8-18
Changing engine oil and filter . . .....8-9
Flashers
(See hazard warning flasher switch) . ....2-43
Flat tire ......................
6-2
Flat towing ................... 9-28
Flexible seating ................. 1-16
10-2