heater INFINITI QX30 2017 User Guide

•When cleaning the seat, never use gaso-
line, benzine, thinner, or any similar mate-
rials.
•If any malfunctions are found or the heated
seat does not operate, turn the switch off
and have the system checked. It is recom-
mended you visit an INFINITI retailer for this
service.
The front seats are warmed by built-in heaters.
The switches are located on the center console
and can be operated independently, for the
left-hand side seat and for the right-hand side
seat.
The three red indicator lights in the button
indicate the heating level you have selected The
system automatically switches from level 3 to
level 2 after approximately eight minutes The
system automatically switches from level 2 to
level 1 after approximately ten minutes. The
system automatically switches off approxi-
mately 20 minutes after it is set to level 1
1. Turn the ignition switch to the ON position.
NOTE
The seat heater can only be activated when
the ignition switch is in the ON position.2. Start the engine.
3. Select the heat range:
•To switch on: press button1repeatedly
until the desired heating level is set.
•To switch off: press button1repeatedly
until all the indicator lights turn off.
NOTE
If the battery voltage is too low, the seat heating
may switch off.
NIC2634
2-70Instruments and controls

Opening and closing
Manual control:
To close the sunshade, press and hold the
“CLOSE” side of the switch
1To stop the
sunshade from closing fully, release the switch.
To open the sunshade press and hold the
“OPEN” side of the switch
2To stop the
sunshade from opening fully, release the
switch.
Automatic operation
:
To fully open or close the sunshade automati-
cally, press briefly on the open or close side of
the switch and then release. To stop the sun-
shade from opening or closing, press either
side of the switch.
Auto-reverse function
:
When the control unit detects something caught
by the sunshade, the sunshade will open auto-
matically.
NOTE
The auto-reverse function remains active
whether the sunshade is being closed manually
or automatically.If the battery cable is disconnected, the clock
will need to be re-adjusted to the correct time.
ADJUSTING TIME
Set the time using the INFINITI controller and
the [Settings] menu available in the central
display (seeClock settingsin the4. Display
screen, heater and air conditioner, and audio
systemsection).
NOTE
On vehicles fitted with a navigation system, the
clock is automatically updated via GPS. The ini-
tial clock setting may be incorrect.
In the center console (LHD) Rear console Lug-
gage compartment
The power outlet is used for powering electrical
accessories such as a cellular telephone.
An emergency cut-off ensures that the on-board
voltage does not drop too low. If the on board
voltage is too low, the power to the sockets is
automatically cut. This ensures that there is
sufficient power to start the engine.
NSD619NIC2690
CLOCK POWER OUTLET
Instruments and controls2-75

4 Display screen, heater and air conditioner,
and audio system
Safety precautions......................4-2
Center multi function control panel............4-2
INFINITI Controller.....................4-2
Steering wheel mounted controls...........4-3
USB connection ports..................4-3
Starting system......................4-4
Touch panel operation..................4-5
Operating menu screen.................4-7
Scrolling message or list................4-7
Selecting item.......................4-7
Adjusting volume and settings.............4-8
How to input letters and numbers...........4-8
How to operate display.................4-9
Menu button operation.................4-10
System status screen..................4-10
Items to be set initially.................4-11
Additional system information.............4-16
RearView monitor (if so equipped)............4-17
RearView Monitor system operation.........4-18
How to read the displayed lines...........4-18
Difference between predicted and actual
distances.........................4-19
How to park with predicted course lines......4-20
Adjusting the screen..................4-22
RearView Monitor setting...............4-23
RearView Monitor system limitations........4-23System maintenance..................4-24
Around View Monitor (if so equipped).........4-25
Around View Monitor system operation.......4-26
Difference between predicted and actual
distances.........................4-29
How to park with predicted course lines......4-30
How to switch the display...............4-32
Adjusting the screen..................4-32
Around View Monitor setting.............4-33
Around View
®Monitor system limitations.....4-34
System maintenance..................4-36
Sonar function settings (if so equipped)......4-37
Moving Object Detection (if so equipped).......4-38
MOD system operation.................4-39
MOD setting.......................4-40
MOD system limitations................4-40
MOD malfunction....................4-41
System maintenance..................4-41
Ventilators..........................4-42
Center ventilators....................4-42
Side ventilators.....................4-42
Rear ventilators (if equipped).............4-42
Heater and air conditioner.................4-43
Air conditioning system................4-44
Automatic climate control (2–zone).........4-48
Servicing air conditioner................4-52

WARNING
•Do not adjust the heater and air conditioner
controls or audio controls while driving so
that full attention may be given to vehicle
operation.
•Do not use this system if you notice any
abnormality, such as a frozen screen or lack
of sound. Continued use of the system may
result in accident, fire or electric shock.
•If you noticed any foreign objects entering
the system hardware, spilled liquid on the
system, or noticed smoke or fumes coming
out from the system, or any other unusual
operation is observed, stop using the sys-
tem immediately. It is recommended that
you contact the nearest INFINITI retailer. Ig-
noring such conditions may lead to an acci-
dent, fire or electric shock.
•Do not disassemble or modify this system.
If you do, it may lead to an accident, fire, or
electric shock.
•Park the vehicle in a safe location and apply
the parking brake to view the images on the
front center display screen.
CAUTION
Do not use the system when the engine is not
running for extended periods of time to pre-
vent battery discharge.
INFINITI CONTROLLER
1

Push again to display the Display View Bar and
the display views.
Push and hold to hear the current guidance for
a programmed route.
<
>(models without navigation system).
Push to display the hands-free phone operation
screen.
When you receive a phone call, push this switch
to answer the call.
2

1USB/iPod connection port:
Connect to play media from an iPod
R,
iPhone
Ror a USB memory device.
When using INFINITI InTouch Apps with
an iPhone
R, connect via a USB cable.
Refer to the device manufacturer’s owner
information regarding the proper use
and care of the device.
CAUTION
•Depending on the size and shape of USB
device, the console lid may not fully close.
Do not force the console lid closed as this
may damage the USB device.NOTE
•Even when iPodsRor iPhonesRare
connected to both of the two USB/iPod
Rconnection ports, the system recognizes only
one of the connected iPods
Ror iPhonesRat a time.
•Only one of the two connected USB devices
can be operated by the voice recognition
system.
STARTING SYSTEM
The system starts when the ignition switch is
placed in the ACC or ON position.
Start-up warning (models with
navigation system)
For this system, when the ignition switch is
placed in the ACC or ON position, the start-up
screen is displayed.
Touch [OK] after reading and agreeing to the
message. If you do not agree to the message,
some of Infiniti InTouch
TMfunctions will be
disabled.NOTE
•Do not keep the INFINITI InTouch system
turned on with the engine stopped. Doing so
may discharge the vehicle battery. When you
use INFINITI InTouch, always keep the engine
running.
•Once you select [Decline] on the start-up
screen, the [OK]/[Decline] screen will not be
displayed for 30 days.
NAA1628
4-4Display screen, heater and air conditioner, and audio system

TOUCH PANEL OPERATION
CAUTION
•The glass screen on the liquid crystal dis-
play may break if it is hit with a hard or
sharp object. If the glass screen breaks, do
not touch it. Doing so could result in an
injury.
•To clean the display, use a soft, dry cloth. If
additional cleaning is necessary, use a
small amount of neutral detergent with a
soft cloth. Never use a rough cloth, alcohol,
benzine, thinner or any kind of solvent or
paper towel with a chemical cleaning agent.
They will scratch or deteriorate the panel.
•Do not splash any liquid such as water or
car fragrance on the display. Contact with
liquid will cause the system to malfunction.
WARNING
•ALWAYS give your full attention to driving.
•Avoid using vehicle features that could dis-
tract you. If distracted, you could lose con-
trol of your vehicle and cause an accident.
Screen illustrations
•The illustrations in this manual are repre-
sentatives of various models and may not be
identical with the design and specifications
of your vehicle.
•Icons and menu items displayed on the
screen may be abbreviated or omitted from
the screen illustrations when appropriate.
The omitted icons and menu items are de-
scribed as dotted lines as illustrated.
Basic touch panel operation methods are ex-
plained here.
5GH0158XZ
Display screen, heater and air conditioner, and audio system4-5

•Touch
Select and execute the selected key on the
screen.
•Swipe
Menu screen pages will skip to the next page.
•Drag
Drag the scroll bar up or down to scroll the
menu screen.
NAA1783
NAA1707
NAA1724
4-6Display screen, heater and air conditioner, and audio system

OPERATING MENU SCREEN
1Touchto scroll to the previous
page.
2Touch the preferred icon to execute a
function and display the next screen.
3Touchto scroll to the next page.
4Indicates the position of the currently
displayed page out of the total number
of available pages.
A swipe gesture can also be used to move
quickly between screens.
SCROLLING MESSAGE OR LIST
1Drag the scroll bar up or down to scroll
the message or list up or down.
2Touch the preferred item.
3If a listed item name is not completely
displayed (due to length), touchto
display the hidden part of the name.
4Touch []or[] to scroll the
message or list one item at a time.
Touch [
]or[] to skip to the
next page.
SELECTING ITEM
Touch an item to select it.
Touch [
] to return to the previous screen.
NAA1729NAA17255GH0030XZ
Display screen, heater and air conditioner, and audio system4-7

ADJUSTING VOLUME AND SETTINGS
Level of volume, brightness, etc. can be ad-
justed.Touch adjustment keys, such as [+]/[-], [L]/[R],
etc., to adjust each item. Each time a key is
touched, the indicator moves along the bar.
HOW TO INPUT LETTERS AND
NUMBERS
The keyboard screen differs depending on the
model and specification.
Character (letters and numbers) input
screen
Alphanumeric characters can be entered using
the keyboard.
The designs and the displayed items may vary
depending on the type of screen.
1Touch a character on the displayed key-
board. The selected character is entered.
2Entered characters are displayed.
3Touch [Delete] to delete the last charac-
ter entered.
Touch and hold [Delete] to delete all the
characters entered.
4The symbol keys are displayed by touch-
ing [Symbols]. The alphabet keys are
displayed by touching [A-Z].
5Touch [Space] to enter a space.
6Touchorto move the cur-
sor.
7Touch [CAPS] to toggle between upper
and lower case letters.
NAA1730NAA1710NAA1711
4-8Display screen, heater and air conditioner, and audio system