wheel INFINITI QX30 2017 Workshop Manual

•The distance between objects viewed in the
rear view differs from actual distance be-
cause a wide-angle lens is used.
•The displayed lines on the rear view will
appear slightly off to the right because the
rear view camera is not installed in the rear
center of the vehicle.
Front view Rear view
Front and rear views:
Guiding lines, which indicate the vehicle width and
distances to objects with reference to the vehicle
body line
A, are displayed on the monitor.
Distance guide lines:
Indicate distances from the vehicle body:
•Red line1: approx.1.5 ft (0.5 m)
•Yellow line2: approx. 3 ft (1 m)
•Green line3: approx. 7 ft (2 m)
•Green line4: approx. 10 ft (3 m)
Vehicle width guide lines
5:
Indicate the approximate vehicle width when
backing up.Predicted course lines
6:
Indicate the predicted course when operating the
vehicle. The predicted course lines will be dis-
played on the monitor when the steering wheel is
turned. The predicted course lines will move
depending on how much the steering wheel is
turned and will not be displayed while the steer-
ing wheel is in the straight ahead position.
The front view will not be displayed when the
vehicle speed is above 10 km/h (6 MPH).
NOTE
When the monitor displays the front view and
the steering wheel turns about 90 degrees or
less from the neutral position, both the right and
left predicted course lines
6are displayed.
When the steering wheel turns about 90 degrees
or more, a line is displayed only on the opposite
side of the turn.
SAA1840ZSAA1896Z
Display screen, heater and air conditioner, and audio system4-27

Backing up near a projecting object
The predicted course linesAdo not touch the
object in the display. However, the vehicle may
hit the object if it projects over the actual
moving course.
Backing up behind a projecting
object
The positionCis shown farther than the
position
Bin the display. However, the posi-
tion
Cis actually at the same distance as theposition
A. The vehicle may hit the object
when backing up to the position
Aif the object
projects over the actual moving course.
HOW TO PARK WITH PREDICTED
COURSE LINES
WARNING
•If the tires are replaced with different sized
tires, the predicted course lines may not be
displayed correctly.
•On a snow-covered or slippery road, there
may be a difference between the predicted
course lines and the actual course.
•The displayed lines will appear slightly off
to the right because the rear view camera is
not installed in the rear center of the ve-
hicle.
•If the battery is disconnected or becomes
discharged, the predicted course lines may
be displayed incorrectly. If this occurs,
please perform the following procedures:
–Turn the steering wheel from lock to lock
while the engine is running.
–Drive the vehicle on a straight road for
more than 5 minutes.
SAA1923SAA1980
4-30Display screen, heater and air conditioner, and audio system

•When the steering wheel is turned with the
ignition switch in the ACC position, the pre-
dicted course lines may be displayed
incorrectly.
The vehicle width and predicted course lines
are wider than the actual width and course.
1. Visually check that the parking space is safe
before parking your vehicle.2. The rear view of the vehicle is displayed on
the screenAas illustrated when the shift
lever is moved to the R (Reverse) position.
SAA1897
Display screen, heater and air conditioner, and audio system4-31

3. Slowly back up the vehicle adjusting the
steering wheel so that the predicted course
lines
Benter the parking spaceC.4. When the rear of the vehicle enters the
parking space
C, maneuver the steering
wheel to make the vehicle width guide lines
Dparallel to the parking spaceC.
5. When the vehicle is parked in the space
completely, press the P (Park) button and
apply the parking brake.
HOW TO SWITCH THE DISPLAY
The view on the Around View Monitor screen
can be switched by pressing the
button or by changing the shift lever position.
Press thebutton:
When thebutton is pushed while a
screen other than a camera screen is displayed,
the Around View Monitor operates and the front
view and bird’s-eye view are displayed. Push
thebutton to switch the display to
the front view and front-side view screen.
ADJUSTING THE SCREEN
1. Push the

CENTER VENTILATORS
Open/close the ventilators by turning the con-
trol wheel.
Adjust the air flow direction of the ventilators by
moving the center knob (up/down, left/right)
until the desired position is achieved.
SIDE VENTILATORS
Open/close the ventilators by turning the con-
trol wheel.
Adjust the air flow direction of the ventilators by
moving the center knob (up/down, left/right)
until the desired position is achieved.
REAR VENTILATORS (IF EQUIPPED)
Open/close the ventilators by turning the con-
trol wheel.
Adjust the air flow direction of the ventilators by
moving the center knob (up/down, left/right)
until the desired position is achieved.
NAA1636CenterNAA1637SideNAA1635Rear
VENTILATORS
4-42Display screen, heater and air conditioner, and audio system

Steering wheel mounted audio
control buttons
1System on/off: Push to turn on/off the
audio system.
2Volume control: Push the upper <+> or
lower <-> buttons to increase or decrease
the volume.
INFINITI controller AUDIO button
Push

•[Phonebook]:
Select a telephone number from the
phonebook.
The telephone number must be trans-
ferred to the phonebook from the cellular
phone prior to using this method.
Phone and text message settingsearlier
in this section
•[Dial Number]:
Input the phone number manually using
the keypad displayed on the screen.
Touch [
] to call the number.
How to input letters and numbersearlier
in this section
3. The number will be dialed and the screen
will change to the call in progress screen.
Receiving a call
When you received a phone call, a notification
message is displayed on the touch screen dis-
play with a ring tone.
Taking a call:
To answer a call, take one of the following
actions.
•Push<>on the steering wheel.
•Push<>on the INFINITI controller
(models without navigation system).
•Touch [Answer].
Reject a call:
To reject a call, touch [Decline].Receiving a call while on the line to another
person
:
When another phone call is received while on
the line to another person, a message box
informing you of the incoming call will appear
on the display.
Available items
Available
itemsAction
[Answer] Take the second call and put the first call
on hold.
[Decline] Reject the second call and keep the first
call on line.
NAA1654NAA1655
Display screen, heater and air conditioner, and audio system4-89

During a call
There are various options available during a
call. Select one of the following options dis-
played on the screen if necessary.Available items
Avail-
able
itemsAction
[Switch
Call]*Answer another incoming call. The person
you are talking to will be placed on hold.
Push once more to speak to the person
on hold again.
[Hang
Up]This disconnects the person you are cur-
rently connected to and will connect you
to the person who is on hold.
[Mute]/
[Cancel
Mute]When muted, your voice will not be heard
by the person on the other end of the line.
[Hold
Call]**Place the call on hold.
[Enter
Digits]Using the touch tone, send digits to the
connected party for using services such
as voicemail.
[Use
Handset]Transfer the call to the cellular phone.
[End All
Calls]*Hang up all calls including the ones that
were on hold.
*: Available when multiple lines are connected.
**: Available when a single line is connected.
•To adjust the volume of the person’s voice to
be louder or quieter, push<->/<+>on the
steering wheel or turn >on the
audio main button, while talking on the
phone.
•Touch [Mute] if you do not want your voice to
be heard by the person on the other end of
the line.
NAA1721
4-90Display screen, heater and air conditioner, and audio system

HANDS-FREE TEXT MESSAGING
ASSISTANT
WARNING
•Use the text messaging feature after park-
ing your vehicle in a safe location. If you
have to use the feature while driving, exer-
cise extreme caution at all times so full at-
tention may be given to vehicle operation.
CAUTION
•This feature is disabled if the connected
device does not support the Message Ac-
cess Profile (MAP). Refer to the owner’s
manual for your phone for further details
and instructions.
Laws in some jurisdictions may restrict the use
ofText-to-Speech. Check local regulations be-
fore using this feature.
The text messaging assistant system allows the
sending and receiving of the text messages
through the vehicle interface.
Receiving a message
When the cellular phone connected to the vehicle
receives a text message, a notification is dis-
played on the display accompanied by a tone.
To check the message, touch [Check Now]. Touch
[Later] to save the message to be checked later.
Using the text message function with iPhone
R. If you would like to use the text message
function with your iPhone, please make the
below steps.
1) Connect iPhone
Rto the Bluetooth®
Hands-Free Phone System.
2)
Disconnect iPhoneRfrom vehicle setting
menu.
3) Turn “Show Notification” ON from
Bluetooth® setting menu on your iPhone
R.
4) Connect iPhone
Rfrom vehicle setting
menu.
Displaying received message list
1. To display the phone menu screen, take one
of the following actions:
•Push

Received message screen
Touching [Check Now] on the new message
notification screen or selecting a message from
the message list will show details of the re-
ceived message on the display.
Available actions:
•[Next]:
Touch to read the next message.
•[Previous]:
Touch to read the previous message.
•[Reply]:
A reply template can be selected.
Sending a text messagelater in this section
•[Play]/[Stop]:
Touch [Play] to have the hands-free phone
system read out the received message.
Touch [Stop] to stop reading.
•[Add Template]:
The received text message can be added to
the template (text list).
•[Call]:
If the sender of the message is registered in
the Phonebook, touch this menu to make a
call to the sender.
•After the message is read out, a message
box will appear and an action can be se-
lected.
[Reply] Create a reply message.
Sending a text messagelater in this sec-
tion
[Next] Have the system read out the next message.
•If the sender’s name and address is regis-
tered in the Phonebook, the name of the
sender is displayed as sender information on
the screen.
Sending a text message
To display the phone menu screen, take one of
the following actions:
•Push