clock INFINITI QX56 2006 Factory Manual PDF

WW-46
REAR WIPER AND WASHER SYSTEM
Revision: November 20092006 QX56
7. CHECK COMBINATION SWITCH INPUT SIGNAL
Select "BCM" on CONSULT-II. With "WIPER" data monitor, make
sure "RR WIPER INT", "RR WIPER ON" turn ON-OFF according to
operation of wiper switch.
OK or NG
OK >> Replace BCM. Refer to BCS-20, "BCM" .
NG >> Check the wiper switch. Refer to WW-6, "
COMBINA-
TION SWITCH READING FUNCTION" .
Rear Wiper Stop Position Is IncorrectEKS00BEJ
1. CHECK AUTO STOP SWITCH INPUT SIGNALS
Select "BCM" on CONSULT-II. With "WIPER" data monitor, make
sure "RR WIPER STOP" and "RR AUTO STOP 2" turn ON-OFF
according to wiper operation.
OK or NG
OK >> Replace BCM. Refer to BCS-20, "BCM" .
NG >> GO TO 2.
2. CHECK AUTO STOP CIRCUITS FOR SHORT TO GROUND
1. Turn ignition switch to OFF.
2. Disconnect BCM and rear wiper motor connectors.
3. Check continuity between BCM harness connector terminals and ground.
OK or NO
OK >> GO TO 3.
NO >> Repair harness or connector. When wiper switch is in
INT position
: RR WIPER INT ON
When wiper switch is in
ON position : RR WIPER ON
SKIA4243E
When wiper switch is OFF
and arm on stop : RR WIPER STOP ON
: RR AUTO STOP 2 ON
When wiper switch is ON and arm in position A : RR WIPER STOP OFF
: RR AUTO STOP 2 ON
When wiper switch is ON counterclockwise sweep : RR WIPER STOP OFF
: RR AUTO STOP 2 OFF
When wiper switch is ON and arm in position B : RR WIPER STOP ON
: RR AUTO STOP 2 OFF
When wiper switch is ON clockwise sweep : RR WIPER STOP OFF
: RR AUTO STOP 2 OFF
When wiper switch is ON and arm in position A : RR WIPER STOP ON
: RR AUTO STOP 2 OFF
WKIA1418E
Terminals
Continuity
Connector Terminal
M18 26
Ground No
M19 44
WKIA2096E