light INFINITI QX70 2014 Quick Reference Guide

21
Navigation System (if so equipped)
Your Navigation System can calculate a route from the current location t\
o a preferred destination.



The real-time map display and turn-by-turn voice guidance will lead you \
along the route.
The Navigation System will continually update your vehicle’s position\
. If you have deviated




from the original route, it will recalculate the route from your current\
location.
01 Touch screen display
02 DEST button – Press to enter a destination.

03 STATUS button – Press multiple times to display audio information with eith\
er the air

conditioner status, fuel economy or navigation directions.
04 ZOOM OUT button – Press to zoom the map out.

05 ROUTE button – Press to access the guidance control functions (guidance c\
ancellation, route

priority, waypoint setting on the route, etc.).
06 INFINITI Controller

•
ENTER
button – Press to select the highlighted item on the screen. If this\
button is
pressed while a map is displayed, the map menu screen is displayed.
• Main directional buttons – Use to move across the map, highlight an i\
tem on the screen or





adjust a setting (volume, brightness, etc.).


• Additional directional buttons – Use to move across the map or highli\
ght an item on the



character input screen.


• Center dial – Use to highlight an item on the screen or adjust a sett\
ing. The center dial can



also be used to adjust the map scale.
01
04
09
02
05
10
12
06
03
07
11
08
13
1354681_14a_Infiniti_QX70_QRG_052813.indd 215/28/13 12:01 PM

23
HOMELINK®
HomeLink® Universal Transceiver
The HomeLink® system can learn and consolidate the functions of up to three different\

hand-held transmitters, operating items such as garage doors, property g\
ates, outdoor
and indoor lights or alarm systems.
To program the Homelink® Universal Transceiver:
•
Position


the

handheld

transceiver 1-3 in (26-76 mm) away from the Homelink
®
surface, keeping the Homelink® indicator light in view.
•
Press


and

hold

the

desired

Homelink
® button and the handheld transmitter button
simultaneously until the Homelink® indicator light flashes slowly and then rapidly.
•
Both


buttons

may

be

released

when the indicator light flashes rapidly.
To verify the programing is complete, press and hold the Homelink® and observe the
indicator light:
•
A


solid

continuous

light

indicates

the

programing

is

complete

and the Homelink
®
button will activate your device.
•
A


blinking

light

that

turns

to

a

solid

continuous

light

after

2

seconds

indicates

additional steps are required to complete the programing.
An additional person may make the remaining steps easier. To complete th\
e
programing process:
•
At

the receiver of the device that you are programing to the Homelink
®, press and
release the “learn” or “smart” button (the name may vary by\
manufacturer but it is
usually located near where the hanging antenna wire is attached to the u\
nit). You
have approximately 30 seconds to initiate the following step.
•
Press


and

hold

the

programmed

Homelink
® button for 2 seconds and release.
Repeat the previous 2 steps up to 3 times to complete the programming pr\
ocess.
Homelink® should now activate your device.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual, the HomeLink® website
at www.homelink.com or call 1-800-355-3515.
1354681_14a_Infiniti_QX70_QRG_052813.indd 235/28/13 12:01 PM