lumbar support ISUZU AXIOM 2002 Service Repair Manual

8G±4SEATS
Power Seat Assembly
Power Seat Assembly and Associated Parts
750R200009
Legend
(1) Headrest
(2) Guide Holder
(3) Seat Back Frame Assembly
(4) Connecting Pipe
(5) Seat Back Pad
(6) Seat Heater (Required Option)
(7) Reclining Device Cover
(8) Reclining Device
(9) Outer Side Cover
(10) Reclining Switch Knob
(11) Slide Switch Knob
(12) Power Lumbar Switch (Driver's Side)
(13) Power Seat Switch
(14) Seat Cushion Frame Assembly(15) Power Seat Harness
(16) Adjuster Bracket Rear Cover
(17) Outer Seat Adjuster Assembly
(18) Adjuster Bracket Front Cover
(19) Front Cover
(20) Sliding Motor Cable
(21) Inner Seat Adjuster Assembly
(22) Seat Cushion Pad
(23) Seat Cushion Assembly/Seat Cushion Trim
Cover
(24) Seat Belt Buckle Assembly
(25) Inner Side Cover
(26) Power Lumbar Support Assembly (Driver's
Side)
(27) Seat Back Assembly/Seat Back Trim Cover

SEATS8G±5
Removal
1. Remove the adjuster bracket rear cover and the fixing
bolts on the rear side of the seat adjuster assembly.

Before removal, slide the power seat assembly
forward.
2. Remove the adjuster bracket front cover and the
fixing bolts on the front side of the seat adjuster
assembly.

Before removal, slide the power seat assembly
backward.
3. Disconnect the battery ground cable.
4. Remove the power seat assembly.

Disconnect the power seat harness connectors and
the seat belt warning connector of the driver side.
CAUTION: When raising power seat assembly (1),
use the handle (2) not the cable (3). A bent cable
causes noise to occur during power seat operation.

Please grip the handle (4).

Don't grip the cable (5).
750R200012
5. Pull the switch knobs out.
6. Remove the outer side cover.

Remove the two fixing screws and disconnect the
power seat switch connector.
7. Remove the power seat switch.

Remove the two fixing screws.
8. Remove the power lumber switch.

Remove the two fixing screws and connectors.
9. Remove the inner side cover.
10. Remove the headrest.
11. Remove the reclining device (2).

Flip up the seat back trim cover (1) in order to
remove the reclining device fixing bolts.

Disconnect the reclining motor harness connector
(3).
760R100037
12. Remove the reclining device covers.
13. Remove the trim cover and pad (Seat back side).
14. Remove the seat heater and connector (seat back
side).
15. Remove the power lumbar support assembly.
16. Remove the guide holder.

Pull the guide holder out by holding the bottom end
of it from the seat back assembly.
17. Remove the seat adjuster assembly.

Remove the four fixing bolts and disconnect the
sliding motor connector.
18. Remove the sliding motor cable (2).

Remove the nuts of each side.
CAUTION: Be sure to maintain the same position for
both outer and inner seat adjust assembly (1).
760R100038