four wheel drive JAGUAR S TYPE 1999 1.G Powertrain Manual

V6 Engine AJ-V6/AJ28
38
J.303.1348
Generator
The 120AH generator is fitted with a special casing
to enable it to be bolted directly to the engine via
three fixing points.
On the manual transmission vehicles, sudden
deceleration may result in generator momentum
driving the belt against the engine which is
slowing down, with possible effects on the life of
the drive belt. The generator pulley fitted to the
manual transmission vehicle incorporates a clutch
mechanism which allows it to freewheel in the
reverse drive (anti-clockwise) direction. Note that
a special tool is required to remove the pulley.
To improve generator control on all
engine/transmission variants, the generator now
has a four pin connector to provide two new
sensing signals:
¥ pin S is directly connected to the battery to
provide voltage feedback to the regulator
¥ the regulator senses field current and
produces a PWM signal from pin FR to the
PCM to indicate the generator duty cycle.
D.303.1350
DRIVE BELT TENSIONER
GENERATOR
D.303-1350
Drive Belt Tensioner
The drive belt tensioner is a similar type to that
fitted to the V8 engines. An index on the
tensioned arm rotates with wear against three
markings on the tensioner spring cap which
indicate the minimum and maximum lengths for a
new belt and the point at which the belt must be
replaced.
Replace Belt
Belt Wear
Indicator
New Belt Maximum Length
New Belt Minimum Length
Manual
transmission
pulleyAutomatic
transmission
pulley
J.303.1348