check engine light JAGUAR XJ 1994 2.G ZF Automatic Transmission Manual

ZF Automatic Transmissions Service Manual
No engine braking
Manual gearchange 3rd to 2nd
inoperative Clutch 'Cl' or
Clutch 'E' faulty
Speed sensor faulty.
MV2 faulty.
a
Renew transmission
Check TCM Diagnostics
1 renew
speed sensor.
Renew valve block.
a
0
Problem
Vo 'kick-down' change
Light throttle speeds only
Light throttle gear change too
hard
1st to
2nd, 2nd to 3rd and 3rd to
4th changes too long
Full load and 'kick
-down'
changes too long
Full load and 'kick
-down'
changes too hard ~
Possible Cause
'Kick-down'
switch out of adjustment 1
full throttle stop adjustment.
'Kick
-down' switch faulty.
'Kick
-down' switch connector or wiring
Fa u Ity.
TCM faulty
Valve block bolt torque incorrect.
Modulation pressure too high.
Damper faulty.
Clutch plates faulty.
Valve block bolt torque incorrect.
Damper faulty.
PRSV faulty.
PRSV wire earthed.
Modulation valve seized.
Pressure regulator valves
1 and 2 seized.
mve block bolt torque incorrect.
Modulation pressure too low.
Clutch plates faulty.
Valve block bolt torque incorrect.
Modulation pressure too low.
Clutch plates faulty.
Action
Adjust as per Engine Set Up
procedure on JDS.
Renew 'kick
-down' switch.
Rectify.
Check TCM
Reset to correct torque.
Renew valve block.
Renew valve block.
Renew gear unit.
Reset to correct torque.
Renew valve block.
Renew valve block.
Renew harness.
Renew valve block.
Renew valve block.
Reset to correct torque.
Renew valve block.
Renew transmission.
Reset to correct torque.
Renew valve block.
Renew transmission.
issue 1 August 1994 65