automatic transmission fluid JAGUAR XK 2013 1.G Quick Start Guide

JAGUAR XK JAGUAR XK JAGUAR XK
JAGUAR XK JAGUAR XK JAGUAR XK
Warning lamps Warning lamps Displayed on the instrument panelDisplayed on the instrument panel Electric parking brake Electric parking brake See page 7, item See page 7, item 12
Transmission See page 7, item See page 7, item 9
Starting and drivingStarting and driving
8 9
Apply manually when stationary in Park, Drive or • Reverse by pulling up the parking brake switch.
Can be manually released when the engine is • running and the foot brake is applied. Press the parking brake switch down to release.
If manually applied whilst in Drive or Reverse, the • parking brake will automatically release when the accelerator is applied.
Releases automatically when the gear selector is • moved from Park.
Gearshift interlock
The ignition must be on and the foot brake depressed before the selector can be rotated from the Park position. Maintain brake pressure until a gear is selected.
Instrument pack message centre
The current gear selection will be displayed at the top of the message centre.
Sport mode
To move from Drive to Sport, press the gear selector down and rotate. Automatic gear changing continues but the gearshift points are modified for full use of the engine’s power.
Manual gear changes
The steering wheel paddles allow manual gear changing with either Drive or Sport selected.
• To shift down, briefly pull the left-hand paddle.
• To shift up, briefly pull the right-hand paddle.
When the paddles are used in Drive, gear selection will revert to automatic mode if use of the paddles is not maintained.
With Sport selected, continuous manual operation is initiated if the paddles are used.
DO NOT use the recess in the electric parking brake as a storage area.
If the engine is switched off with Neutral selected, automatic selection of P is delayed for 10 minutes. Do NOT use this feature during vehicle recovery.
P R N D S
STARTENGINESTOP
Auto headlamps and wipers Auto headlamps and wipers See page 7, items See page 7, items 1 and 3and 3and
Auto high beam
1. When AUTO is selected on the lighting control the side lamps and headlamps will turn on automatically when ambient light fades. With the control in the low beam position, high beam will activate automatically when ambient light falls below a pre set level. Vehicle speed must be above 40 km/h (25 mph).
Exit delay
2, 3, 4. The headlamps can be set to temporarily light your way when you exit the car at night. Rotate the control for exit delay periods of 30 seconds, 60 seconds or 120 seconds.
1
432
MA
X
MIN
MAX
MIN
6
5
7
Auto Wipers
Automatic wipers are activated by a rain sensor. When the wiper control is moved up to the first position the wipers will operate automatically as required. Sensitivity can be adjusted.
5. First stop for auto position.
6. Rain sensor maximum sensitivity.
7. Rain sensor minimum sensitivity.
Automatic car wash
Before entering an automatic car wash, turn the wipers off to deactivate the rain sensor. Otherwise, the wipers will operate during the washing process and may be damaged.
Braking system fault or brake fluid low
Braking system fault or brake fluid low. USA only
Dynamic stability control. Flashes when DSC is operating
DSC switched off, Trac DSC on
Automatic speed limiter active
Seat belt reminder
Low tire pressure
Anti-lock braking system fault.
Anti-lock braking system fault. USA only
Engine malfunction
Air bag fault
Rear fog lamp on
Forward alert active
Adaptive cruise control active
In both D and S mode, automatic operation can be reinstated by pulling the right-hand paddle for two seconds.