lumbar support JAGUAR XK 2013 1.G Quick Start Guide

JAGUAR XK JAGUAR XK JAGUAR XK
JAGUAR XK JAGUAR XK JAGUAR XK
Seat adjustment Seat adjustmentDriving position memoryDriving position memory
Convertible topConvertible top
Door mirrors adjustment Door mirrors adjustment
Steering column adjustments Steering column adjustments See page 7, item See page 7, item 18
Comfort adjustments
4
Operating note
The controls for seat heating and cooling are accessed via the touch screen.
123
45
Note: Seat adjustment may vary dependent upon vehicle Note: Seat adjustment may vary dependent upon vehicle Note:specification.
The control panel is on the door.
Cushion length.1.
Lumbar support.2.
Seat back angle.3.
Side bolster adjustment.4.
Seat forwards and back, cushion height and cushion 5. angle.
Electronic steering column lock
The lock will disengage automatically when the correct Jaguar Smart Key is inside the vehicle.
Steering wheel adjustment
Turn the control to • COLUMN then move the control to adjust the height and reach.
Exit mode
With the control set to • AUTO, the steering column will move to provide greater clearance for exiting when the driver’s door is opened.
Entry mode
After the driver’s door is closed and the START/STOP button is pressed the column will return to its previous position.
2
1
1Door mirror adjustment
Press to select a mirror. 1.
Use to adjust the mirror position.2.
Powerfold mirrors
• Press both buttons 1 simultaneously to fold the mirrors inward. Press again to unfold.
The mirrors can be programmed to unfold/fold automatically at vehicle unlock/lock. See your Owner’s Handbook.
Mirror dip when reversing
Reverse dip can be enabled or disabled via the touch screen. From the Home screen, select Vehicle, then Veh.settings, then Parking.
When you have found your ideal driving position, the vehicle can memorise the settings for future use.
Press the 1.M button. The red LED will illuminate for a five second period.
Press button 2.1, 2, or 3 to store your current driving position.
The LED will extinguish and a chime will sound to confirm that the settings have been memorised. If the ignition is on, the message centre will display a confirmation message.
Recalling a seat position
To recall a memorised seat position simply press and hold button 1, 2, or 3 until the seat has finished moving.
Operating note
A seat position will only be memorised during the five second period that the LED is illuminated.
An existing memory setting can be over-written with a new memory position.
Convertible top operation
• DO NOT press the engine START/STOP button while the top is operating. Doing so will cause the system to lose its position memory.
• DO NOT operate the top while the vehicle is in motion. Doing so may damage the top and/or its operating mechanism.
• DO NOT open the luggage compartment while the top is operating. This will cause the operation to stop.
The vehicle must be stationary with the engine running.
Note: The luggage separator MUST be in the correct position before the top will retract.
• To open, press and hold the REAR of switch 1 in the overhead console.
An audible chime indicates start of opening. Rear windows will open, the top unlatches and starts to move. Front windows will fully lower. When the process is complete another audible chime will be given.
• Release the switch.
1
• To close, press and hold the FRONT of switch 1.
Once again an audible chime is given and the windows will lower before the roof moves back into position. When the process is complete another audible chime will be given.
• Release the switch.
5
JJM189630121.indd 4-5JJM189630121.indd 4-5JJM189630121.indd 4-509/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:1909/03/2011 10:10:19