light JEEP CHEROKEE 2017 KL / 5.G User Guide

FRONT VIEW
Front View
1 — Hood/Engine Compartment
2 — Windshield
3 — Headlights4 — Wheels/Tires
5 — Exterior Mirrors
6 — Doors
10 GRAPHICAL TABLE OF CONTENTS

REAR VIEW
Rear View
1 — Rear Lights
2 — Rear Windshield Wiper
3 — Liftgate
2
GRAPHICAL TABLE OF CONTENTS 11

▫Security System Manual Override ............36
 DOORS ...............................36
▫ Manual Door Locks ......................36
▫ Power Door Locks ......................37
▫ Keyless Enter-N-Go — Passive Entry .........38
▫ Automatic Unlock Doors On Exit ............42
▫ Child-Protection Door Lock System —
Rear Doors ............................42
 SEATS ................................43
▫ Manual Seats — If Equipped ...............43
▫ Power Seats — If Equipped ................45
▫ 60/40 Split Folding Rear Seat With Fold-Flat
Feature ..............................47
▫ Driver Memory Seat — If Equipped ..........50
▫ Front Heated Seats — If Equipped ...........53
▫ Front Ventilated Seats — If Equipped .........53
 HEAD RESTRAINTS ......................54
▫ Reactive Head Restraints — Front Seats ........55▫
Rear Head Restraints .....................56
 STEERING WHEEL .......................57
▫ Tilt/Telescoping Steering Column ............57
▫ Heated Steering Wheel — If Equipped .........58
 MIRRORS ..............................59
▫ Inside Day/Night Mirror — If Equipped ......59
▫ Electrochromic Mirror ....................59
▫ Outside Mirrors ........................60
▫ Heated Mirrors — If Equipped .............62
▫ Illuminated Vanity Mirrors — If Equipped .....62
▫ Sun Visor “Slide-On-Rod” Feature —
If Equipped ...........................62
 EXTERIOR LIGHTS .......................63
▫ Headlight Switch .......................63
▫ Automatic Headlights — If Equipped .........63
▫ Headlights On With Wipers (Available With
Automatic Headlights Only) ...............64
▫ Headlight Time Delay ....................64
16 GETTING TO KNOW YOUR VEHICLE

▫Lights-On Reminder .....................64
▫
Daytime Running Lights (DRL) — If Equipped . . .64
▫ Fog Lights — If Equipped .................65
▫ Multifunction Lever .....................65
▫ Turn Signals ...........................66
▫ Lane Change Assist — If Equipped ..........66
▫ High/Low Beam Switch ..................66
▫ Flash-To-Pass ..........................66
▫ Automatic High Beam Headlamp Control —
If Equipped ...........................66
▫ Battery Saver Feature ....................67
 INTERIOR LIGHTS .......................67
▫ Front Map/Reading Lights .................67
▫ Instrument Panel Dimmer Control ...........68
▫ Ambient Light Control — If Equipped .........69
▫ Dome Light Position .....................69
▫ Interior Light Defeat (Off) ..................69 ▫
Parade Mode (Daytime Brightness Feature) .....69
 WINDSHIELD WIPERS AND WASHERS ........70
▫ Windshield Wiper Operation ................70
▫ Rain Sensing Wipers — If Equipped ..........72
▫ Windshield Wiper De-Icer — If Equipped ......73
▫ Intermittent Wiper System .................74
▫ Rear Window Features ...................74
 CLIMATE CONTROLS .....................76
▫ Manual Climate Control Without A
Touchscreen Overview ....................76
▫ Climate Controls With A Touchscreen .........82
▫ Automatic Temperature Control (ATC) —
If Equipped ...........................92
▫ Operating Tips .........................93
 WINDOWS .............................95
▫ Power Window Controls ..................95
▫ AUTO-Down Feature ....................95
3
GETTING TO KNOW YOUR VEHICLE 17

To Unlock The Doors And Liftgate
Push the interior door unlock button on the door panel.
Push and release the unlock button on the key fob once to
unlock the driver’s door or twice within five seconds to
unlock all doors and the liftgate.
The turn signal lights will flash to acknowledge the unlock
signal. The illuminated entry system will be activated.
Key Fob With Emergency Key
1 — Emergency Key
2 — Key Fob
Key Fob
3
GETTING TO KNOW YOUR VEHICLE 21

1st Push Of Key Fob Unlock Button
This feature lets you program the system to unlock either the
driver’s door or all doors on the first push of the unlock
button on the key fob. To change the current setting, refer to
“Uconnect Settings” in “Multimedia” for further information.
NOTE:If the vehicle is equipped with Passive Entry, refer
to “Keyless Enter-N-Go — Passive Entry” located in
“Doors” in “Getting To Know Your Vehicle” for further
information.
To Lock The Doors And Liftgate
Push and release the lock button on the key fob to lock all
doors and liftgate.
The turn signal lights will flash and the horn will chirp to
acknowledge the signal. Refer to “Uconnect Settings”
located in “Multimedia” for further programmable infor-
mation.
If the vehicle is equipped with Passive Entry, refer to
“Keyless Enter-N-Go — Passive Entry” located in “Doors”
in “Getting To Know Your Vehicle” for further information. Vehicles Equipped With Keyless Enter-N-Go —
Passive Entry
If one or more doors are open, or the liftgate is open, the
doors will lock. The doors will unlock again automatically
if the key is left inside the passenger compartment, other-
wise the doors will stay locked.
Key Fob Battery Replacement
The recommended replacement battery is one CR2032
battery.
NOTE:
•
Perchlorate Material — special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate
• Do not touch the battery terminals that are on the back
housing or the printed circuit board.
22 GETTING TO KNOW YOUR VEHICLE

3. Remove the battery by turning the back cover over(battery facing downward) and tapping it lightly on a
solid surface such as a table or similar, and then replace
the battery. When replacing the battery, match the + sign
on the battery to the + sign on the inside of the battery
clip, located on the back cover. Avoid touching the new
battery with your fingers. Skin oils may cause battery
deterioration. If you touch a battery, clean it with
rubbing alcohol.
4. To assemble the key fob case, snap the two halves together.
Separating Case With A CoinBattery Replacement
24 GETTING TO KNOW YOUR VEHICLE

WARNING!
•Do not start or run an engine in a closed garage or
confined area. Exhaust gas contains Carbon Monox-
ide (CO) which is odorless and colorless. Carbon
Monoxide is poisonous and can cause serious injury
or death when inhaled.
• Keep key fobs away from children. Operation of the
Remote Start System, windows, door locks or other
controls could cause serious injury or death.
Remote Start Abort Message On The Instrument
Cluster Display — If Equipped
The following messages will display in the instrument
cluster display if the vehicle fails to remote start or exits
remote start prematurely:
• Remote Start Aborted — Door Open
• Remote Start Aborted — Hood Open
• Remote Start Aborted — Fuel Low
• Remote Start Aborted — Liftgate Open
• Remote Start Disabled — Start Vehicle To Reset •
Remote Start Aborted — Too Cold
• Remote Start Aborted — Time Expired
The message will stay active until the ignition is turned to
the ON/RUN position.
To Enter Remote Start Mode
Push and release the REMOTE START buttonon the
key fob twice within five seconds. The vehicle doors will
lock, the parking lights will flash, and the horn will
chirp twice (if programmed). Then, the engine will start,
and the vehicle will remain in the Remote Start mode for
a 15-minute cycle.
NOTE:
• If an engine fault is present or fuel level is low, the
vehicle will start and then shut down in 10 seconds.
• The park lamps will turn on and remain on during
Remote Start mode.
• For security, power window and power sunroof opera-
tion (if equipped) are disabled when the vehicle is in the
Remote Start mode.
30 GETTING TO KNOW YOUR VEHICLE

Remote Start Windshield Wiper De–Icer Activation
— If Equipped
When remote start is active and the outside ambient tem-
perature is less than 40° F (4.4° C), the Windshield Wiper
De-Icer will be enabled. Exiting remote start will resume
previous operation, except if the Windshield Wiper De-Icer is
active. The Windshield Wiper De-Icer timer and operation
will continue.
General Information
The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2.
This device must accept any interference received, includ-
ing interference that may cause undesired operation.
NOTE:Changes or modifications not expressly approved
by the party responsible for compliance could void the
user ’s authority to operate the equipment.
SENTRY KEY
The Sentry Key Immobilizer system prevents unauthorized
vehicle operation by disabling the engine. The system does
not need to be armed or activated. Operation is automatic,
regardless of whether the vehicle is locked or unlocked.
The system uses a key fob, keyless push button ignition
and a RF receiver to prevent unauthorized vehicle opera-
tion. Therefore, only key fobs that are programmed to the
vehicle can be used to start and operate the vehicle. The
system will not allow the engine to crank if an invalid key
fob is used to start and operate the vehicle. The system will
shut the engine off in two seconds if an invalid key fob is
used to start the engine.
After turning the ignition switch to the ON/RUN position,
the Vehicle Security Light will turn on for three seconds for
a bulb check. If the light remains on after the bulb check, it
indicates that there is a problem with the electronics. In
addition, if the light begins to flash after the bulb check, it
indicates that someone used an invalid key fob to start the
engine. Either of these conditions will result in the engine
being shut off after two seconds.
32 GETTING TO KNOW YOUR VEHICLE

If the Vehicle Security Light turns on during normal vehicle
operation (vehicle running for longer than 10 seconds), it
indicates that there is a fault in the electronics. Should this
occur, have the vehicle serviced as soon as possible by an
authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not compatible
with some aftermarket remote starting systems. Use of
these systems may result in vehicle starting problems
and loss of security protection.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics.
Replacement Keys
NOTE: Only key fobs that are programmed to the vehicle
electronics can be used to start and operate the vehicle.
Once a key fob is programmed to a vehicle, it cannot be
programmed to any other vehicle.
CAUTION!
• Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle unattended.
• For vehicles equipped with Keyless Enter-N-Go —
Ignition, always remember to place the ignition in
the OFF position.
NOTE: Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of programming
a blank key fob to the vehicle electronics. A blank key fob
is one that has never been programmed.
When having the Sentry Key Immobilizer System serviced,
bring all vehicle keys with you to an authorized dealer.
Customer Key Programming
Programming key fobs may be performed at an authorized
dealer.
3
GETTING TO KNOW YOUR VEHICLE 33