JEEP COMMANDER 2006 1.G Owners Manual

JEEP COMMANDER 2006 1.G Owners Manual COMMANDER 2006 1.G JEEP JEEP https://www.carmanualsonline.info/img/16/7062/w960_7062-0.png JEEP COMMANDER 2006 1.G Owners Manual
Trending: oil level, four wheel drive, power steering, steering, headlamp, check engine, tow

Page 141 of 440

JEEP COMMANDER 2006 1.G Owners Manual If the “ESP/BAS Warning Lamp” comes on
continuously with the engine running, a mal-
function has been detected in either the ESP or
the BAS system, or both. If this light remains on
after several

Page 142 of 440

JEEP COMMANDER 2006 1.G Owners Manual Rear Park Assist Sensors
The four Rear Park Assist Sensors, located in the rear
fascia, monitor the area behind the vehicle that is within
the sensors’ field of view. The monitored area seems oval
i

Page 143 of 440

JEEP COMMANDER 2006 1.G Owners Manual When the obstacle is detected at a distance of about 59
inches (150 cm) from the rear fascia, the outermost LEDs
of the warning display will be ON with increased bright-
ness. Along with the LED, a ha

Page 144 of 440

JEEP COMMANDER 2006 1.G Owners Manual Enable/Disable the Rear Park Assist System
The Rear Park Assist System can be enabled and disabled
with a switch located in the switch bank of the instru-
ment panel.When the switch is pressed to disa

Page 145 of 440

JEEP COMMANDER 2006 1.G Owners Manual Service the Rear Park Assist System
When the Rear Park Assist System is defective, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display theSERVICE PARK
ASS

Page 146 of 440

JEEP COMMANDER 2006 1.G Owners Manual WARNING!
•Drivers must be careful when backing up even when
using the Rear Park Assist System. Always check
carefully behind your vehicle, look behind you, and
be sure to check for pedestrians, anim

Page 147 of 440

JEEP COMMANDER 2006 1.G Owners Manual ADJUSTABLE PEDALS — IF EQUIPPED
This feature allows both the brake and accelerator pedals
to move toward the driver to provide improved position
with the steering wheel. The adjustable pedal system

Page 148 of 440

JEEP COMMANDER 2006 1.G Owners Manual •The pedals can be adjusted while driving.
•The pedalscannotbe adjusted when the vehicle is in R
(Reverse) or when the Speed Control is ON. A message
will be displayed in the Electronic Vehicle In

Page 149 of 440

JEEP COMMANDER 2006 1.G Owners Manual To Activate
Press the ON·OFF button to turn the system ON. To turn
the system OFF, press the ON·OFF button again. The
system should be turned OFF when not in use. The
CRUISE indicator light in the i

Page 150 of 440

JEEP COMMANDER 2006 1.G Owners Manual To Vary the Speed Setting
When the Speed Control is ON, speed can be increased
by pressing and holding the RES·ACCEL button. When
the button is released, a new set speed will be estab-
lished.
Tappin
Trending: differential, warning, change key battery, spare tire location, ad blue, ECO mode, heating