battery replacement JEEP COMMANDER 2007 1.G Owners Manual

Transmitter Battery Service
The recommended replacement battery is one CR2032
battery.
NOTE:Do not touch the battery terminals that are on
the back housing or the printed circuit board.
1. With the transmitter buttons facing down, remove the
small screw, and separate the two halves of the transmit-
ter. Make sure not to damage the rubber gasket during
removal.
2. Remove and replace the battery. Avoid touching the
new battery with your fingers. Skin oils may cause
battery deterioration. If you touch a battery, clean it with
rubbing alcohol.
Separating Transmitter Halves
24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

MAINTAINING YOUR VEHICLE
CONTENTS
Engine Compartment – 3.7L...............355
Engine Compartment – 4.7L...............356
Engine Compartment – 5.7L...............357
Onboard Diagnostic System — OBD II........358
▫Loose Fuel Filler Cap Message............359
Emissions Inspection And Maintenance
Programs............................359
Replacement Parts......................361
Dealer Service.........................361Maintenance Procedures..................362
▫Engine Oil..........................362
▫Drive Belts — Check Condition And Tension . . 365
▫Spark Plugs.........................366
▫Spark Plug Wires.....................366
▫Engine Air Cleaner Filter................366
▫Catalytic Converter....................367
▫Crankcase Emission Control System........369
▫Maintenance-Free Battery................369
7

Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off the
ignition key or start the engine. This means that your
vehicle’s OBD system isnot readyand you shouldnot
proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or start
the engine. This means that your vehicle’s OBD system
isreadyand you can proceed to the I/M station.
If your OBD system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
360 MAINTAINING YOUR VEHICLE

Special Additives...................... 387
Torque Converter...................... 262
Autostick............................. 258
Auxiliary Electrical Outlet (Power Outlet)...... 162
Auxiliary Power Outlet................... 162
Battery............................... 369
Emergency Starting..................... 348
Keyless Transmitter Replacement (RKE)....... 24
Saving Feature (Protection)............... 120
Belts, Drive............................ 365
Belts, Seat.............................. 38
Body Mechanism Lubrication............... 373
B-Pillar Location........................ 284
Brake Assist System...................... 136
Brake Control System, Electronic............. 135
Brake System........................... 381
Anti-Lock (ABS)....................135,275
Hoses.............................. 382Master Cylinder....................... 382
Parking............................. 274
Warning Light........................ 176
Brake/Transmission Interlock............... 256
Break-In Recommendations, New Vehicle........ 67
Bulb Replacement....................... 401
Camera, Rear........................... 149
Capacities, Fluid........................ 402
Caps, Filler
Fuel................................ 314
Radiator (Coolant Pressure)............... 378
Car Washes............................ 389
Carbon Monoxide Warning............68,152,310
Cargo Area Features...................... 165
Cargo Compartment...................... 165
Luggage Carrier....................... 168
Cargo Load Floor........................ 165
Catalytic Converter...................... 367
INDEX 439
10