reset JEEP COMPASS 2007 1.G User Guide

NOTE:Tighten the gas cap about 1/4 turn until you
hear one click. This is an indication that cap is properly
tightened.
If the gas cap is not tighten properly, the Malfunction
Indicator Light will come on. Be sure the gas cap is
tightened every time the vehicle is refueled.
WARNING!
A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on the
ground while filling.
Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose or improperly installed, a “GASCAP”
message will be displayed in the Odometer/Trip Odom-
eter in the instrument cluster. Refer to “Instrument
Cluster Description” in Section 4 of this manual. Tighten
the fuel filler cap properly and press the odometer/trip
odometer reset button to turn the message off. If the
problem continues, the message will appear the next time
the vehicle is started. Refer to “Onboard Diagnostic
System — OBDII” in Section 7 of this manual for more
information.
STARTING AND OPERATING 283
5

sound is heard. This is an indication that the gas cap is
properly tightened. Press the odometer reset button to
turn the message off. If the problem persists, the message
will appear the next time the vehicle is started. This
might indicate a damaged cap. If the problem is detected
twice in a row, the system will turn on the Malfunction
Indicator Light (MIL). Resolving the problem will turn
the MIL light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states, which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
318 MAINTAINING YOUR VEHICLE

Transmitter Battery Service
(Remote Keyless Entry).................... 29
Transmitter, Garage Door Opener (HomeLink) . . 132
Transmitter Programming
(Remote Keyless Entry).................... 27
Transporting Pets........................ 72
Tread Wear Indicators.................... 266
Trip Odometer.......................... 173
Trip Odometer Reset Button................ 171
Turn Signals......................122,167,358
UConnect™ (Hands-Free Phone).............. 83
Understanding Your Instrument Panel......... 164
Uniform Tire Quality Grades................ 389
Universal Transmitter..................... 132
Unleaded Gasoline....................... 277
Vacuum/Vapor Harnesses................. 338
VanityMirrors ........................... 82Variance, Compass....................... 183
Vehicle Identification Number (VIN)............ 6
Vehicle Loading......................256,284
Vehicle Modifications/Alterations.............. 7
Vehicle Storage......................... 354
Vehicle Theft Alarm (Security Alarm).......... 30
Warning Lights
(Instrument Cluster Description)............. 166
Warnings and Cautions..................... 6
Warranty Information..................... 387
Washer, Adding Fluid..................127,158
Washers, Windshield..................... 125
Washing Vehicle......................... 345
Wheel Alignment and Balance............... 268
Wheel and Wheel Trim.................... 347
Wheel and Wheel Trim Care................ 347
WindBuffeting ......................... 149
Window Fogging........................ 227
INDEX 407
10