alarm JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual GRAND CHEROKEE 2002 WJ / 2.G JEEP JEEP https://www.carmanualsonline.info/img/16/7175/w960_7175-0.png JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual

Page 311 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual (1) Turn the ignition switch to the On position
(transmission in Park/Neutral).
(2) Use the DRBIIItand select THEFT ALARM,
SKIM, then MISCELLANEOUS.
(3) Select PCM REPLACED (GAS ENGINE).
(4) Enter sec

Page 390 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual HORN
TABLE OF CONTENTS
page page
HORN SYSTEM
DESCRIPTION..........................1
OPERATION............................2
DIAGNOSIS AND TESTING - HORN SYSTEM . . . 2
HORN
DESCRIPTION.................

Page 391 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual connector pin-out information and location views for
the various wire harness connectors, splices and
grounds. Following are general descriptions of the
remaining major components in the horn system.

Page 453 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual LICENSE PLATE LAMP UNIT
REMOVAL.............................18
INSTALLATION.........................19
LEFT MULTI-FUNCTION SWITCH
DESCRIPTION.........................19
OPERATION......................

Page 593 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual CONTROL/CENTRAL TIMER MODULE -
DESCRIPTION).
²Combination Flasher (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/COMBINA-
TION FLASHER - DESCRIPTION).
²Door Ajar Switch (Refer to 8 - ELECTRICA

Page 594 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual switch, or when the ªLockº button on the Remote
Keyless Entry (RKE) transmitter is depressed. The
powerlock switch will not initiate the pre-arming
sequence if the key is in the ignition switch. Whe

Page 595 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual tion feature of the ITM can be disabled by depressing
the ªLockº button on the RKE transmitter three
times or cycling the key in the driver door cylinder
from the center to lock position within fift

Page 602 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual INSTALLATION - HOOD AJAR SWITCH
STRIKER
(1) Align the three integral retainers of the hood
ajar switch striker with their mounting holes in the
inner hood panel reinforcement (Fig. 4).
(2) Using hand

Page 603 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual The ITM microprocessor continuously monitors
inputs from its on-board motion sensor as well as
inputs from the BCM and the alarm siren module.
The ITM motion sensor transmits ultrasonic signals
into t

Page 604 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual the two rear latch receptacles of the mounting
bracket above the headliner.
(5) Push upward firmly and evenly on the rear
edge of the ITM trim cover until the two rear latch
features of the module are
Page:   1-10 11-20 next >