driver seat adjustment JEEP GRAND CHEROKEE 2012 WK2 / 4.G SRT Owners Manual
[x] Cancel search | Manufacturer: JEEP, Model Year: 2012, Model line: GRAND CHEROKEE, Model: JEEP GRAND CHEROKEE 2012 WK2 / 4.GPages: 572, PDF Size: 8.69 MB
Page 104 of 572
Voice Command — If Equipped........... 141
▫Voice Command System Operation........ 141
▫Commands........................ 142
▫VoiceTraining ...................... 146
Blind Spot Monitoring — If Equipped....... 146
▫Rear Cross Path..................... 152
▫Modes Of Operation.................. 154
Seats.............................. 155
▫Power Seats — If Equipped............. 156
▫Passenger’s Power Seat................ 158
▫Power Lumbar — If Equipped........... 159
▫Manual Front Seats Forward/Rearward
Adjustment........................ 160▫Manual Front Passenger Seatback
Adjustment — Recline................. 161
▫Front Passenger Seat Fold-Flat Feature — If
Equipped.......................... 162
▫Heated Seats — If Equipped............ 162
▫Ventilated Seats — If Equipped.......... 165
▫Head Restraints..................... 166
▫60/40 Split Rear Seat.................. 170
▫Reclining Rear Seat................... 172
Driver Memory Seat — If Equipped........ 173
▫Setting Memory Positions And Linking
Remote Keyless Entry Transmitter To
Memory........................... 174
▫Memory Position Recall................ 175
102 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 162 of 572
Push the switch rearward to decrease the lumbar sup-
port. Pushing upward or downward on the switch will
raise and lower the position of the support.Manual Front Seats Forward/Rearward
Adjustment
Some models may be equipped with manual front driver
or passenger seats. The seats can be adjusted forward or
rearward by using a bar located by the front of the seat
cushion, near the floor.
Power Lumbar Switch
Adjustment Bar
160 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 178 of 572
3. Press and release the memory S (SET) button located
on the driver’s door.
4. Within five seconds, press and release MEMORY
button 1 on the driver’s door.
5. Within five seconds, press and release the UNLOCK
button on the RKE transmitter.
To disable another RKE transmitter linked to either
memory position, repeat steps 1 through 5 for each RKE
transmitter.
NOTE:Once programmed, all RKE transmitters linked
to memory can be easily enabled or disabled at one time.
Refer to “Electronic Vehicle Information Center (EVIC)/
Customer-Programmable Features” in “Understanding
Your Instrument Panel” for further information.Easy Entry/Exit Seat
This feature provides automatic driver’s seat positioning
which will enhance driver mobility out of and into the
vehicle.
There are two possible Easy Entry/Exit adjustments
available:
•The seat cushion will move rearward approximately
2.5 in (60 mm), if the starting position of the seat is
greater than or equal to 2.67 in (68 mm) forward of the
rear seat stop when the key is removed from the
ignition switch. The seat will then move forward
approximately 2.5 in (60 mm) when the key is placed
into the ignition and turned out of the LOCK position.
•The seat will move to the position located 0.3 in
(8 mm) forward of the rear stop if the starting position
is between 0.9 to 2.67 in (23 to 68 mm) forward of the
rear stop when the key is removed from the ignition
switch. The seat will move forward to the memory/
176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE