JEEP PATRIOT 2012 1.G Owners Manual

JEEP PATRIOT 2012 1.G Owners Manual PATRIOT 2012 1.G JEEP JEEP https://www.carmanualsonline.info/img/16/7137/w960_7137-0.png JEEP PATRIOT 2012 1.G Owners Manual
Trending: fuel, oil pressure, length, odometer, brake rotor, fuel cap, low beam

Page 161 of 505

JEEP PATRIOT 2012 1.G Owners Manual System can be reactivated by pushing the Electronic
Speed Control ON/OFF button and resetting the desired
vehicle set speed.
To Activate
Push the ON/OFF button. The Cruise Indicator Light in
the instr

Page 162 of 505

JEEP PATRIOT 2012 1.G Owners Manual To Resume Speed
To resume a previously set speed, push the RES (+)
button and release. Resume can be used at any speed
above 20 mph (32 km/h).
To Vary The Speed Setting
When the Electronic Speed Contr

Page 163 of 505

JEEP PATRIOT 2012 1.G Owners Manual On steep hills, a greater speed loss or gain may occur so
it may be preferable to drive without Electronic Speed
Control.
WARNING!
Electronic Speed Control can be dangerous where the
system cannot mai

Page 164 of 505

JEEP PATRIOT 2012 1.G Owners Manual NOTE:HomeLinkis disabled when the Vehicle Secu-
rity Alarm is active.
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.For

Page 165 of 505

JEEP PATRIOT 2012 1.G Owners Manual Programming A Rolling Code
For programming garage door openers that were manu-
factured after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where t

Page 166 of 505

JEEP PATRIOT 2012 1.G Owners Manual 3. Simultaneously press and hold both the Homelink
button you want to program and the hand-held transmit-
ter button.
4. Continue to hold both buttons and observe the indi-
cator light. The Homelink

Page 167 of 505

JEEP PATRIOT 2012 1.G Owners Manual 2. Press and hold the desired HomeLinkbutton until
the indicator light begins to flash after 20 seconds.Do not
release the button.
3.Without releasing the buttonproceed with “Program-
ming A Rollin

Page 168 of 505

JEEP PATRIOT 2012 1.G Owners Manual Reprogramming A Single HomeLinkButton
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired Ho

Page 169 of 505

JEEP PATRIOT 2012 1.G Owners Manual 4. Watch for the HomeLinkindicator to change flash
rates. When it changes, it is programmed. It may take up
to 30 seconds or longer in rare cases. The garage door
may open and close while you are pro

Page 170 of 505

JEEP PATRIOT 2012 1.G Owners Manual Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes. Note that all
c
Trending: transmission oil, wheel size, spare tire, coolant level, warning light, automatic transmission, change wheel