Fluid capacity JEEP PATRIOT 2014 1.G Owners Manual

Inflation Pressure
This is the cold tire inflation pressure for your vehicle for
all loading conditions up to full GAWR.
Curb Weight
The curb weight of a vehicle is defined as the total weight
of the vehicle with all fluids, including vehicle fuel, at full
capacity conditions, and with no occupants or cargo
loaded into the vehicle. The front and rear curb weight
values are determined by weighing your vehicle on a
commercial scale before any occupants or cargo are
added.
Overloading
The load carrying components (springs, tires, wheels,
etc.) of your vehicle will provide satisfactory service as
long as you do not exceed the GVWR.The best way to figure out the total weight of your
vehicle is to weigh it when it is fully loaded and ready for
operation. Weigh it on a commercial scale to ensure that
it is not over the GVWR.
Overloading can cause potential safety hazards and
shorten useful service life. Heavier suspension compo-
nents do not necessarily increase the vehicle’s GVWR.
Loading
To load your vehicle properly, first figure out its empty
weight. Store heavier items down low and be sure you
distribute their weight as evenly as possible. Stow all
loose items securely before driving. Improper weight
distribution can have an adverse effect on the way your
vehicle steers and handles, and the way the brakes
operate.5
STARTING AND OPERATING 417

WARNING!
Riding the brakes can lead to brake failure and
possibly a collision. Driving with your foot resting or
riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You would not have your full
braking capacity in an emergency.
Brake Master Cylinder
The fluid level in the master cylinder should be checked
when performing under hood services, or immediately if
the brake system warning light is on.
Be sure to clean the top of the master cylinder area before
removing the cap. If necessary, add fluid to bring the
fluid level up to the requirements described on the brake
fluid reservoir. Fluid level can be expected to fall as thebrake pads wear. The brake fluid level should be checked
when the pads are replaced. However, low fluid level
may be caused by a leak and a checkup may be needed.
NOTE:
If your vehicle is equipped with a manual trans-
mission, the brake fluid reservoir supplies fluid to both
the brake system and the clutch release system. The two
systems are separated in the reservoir, and a leak in one
system will not affect the other system. The manual
transmission clutch release system should not require
fluid replacement during the life of the vehicle. If the
brake fluid reservoir is low and the brake system does
not indicate any leaks or other problems, it may be a
result of a leak in the hydraulic clutch release system. See
your local authorized dealer for service.
Use only manufacturer’s recommended brake fluid. Re-
fer to “Fluids, Lubricants, and Genuine Parts” in “Main-
taining Your Vehicle” for further information.
498 MAINTAINING YOUR VEHICLE

Ethanol............................... .409
Event Data Recorder ........................75
Exhaust Gas Caution ........................39
Exhaust System ...........................97
Exterior Lights .......................... .100
Filters Air Cleaner .......................... .482
Air Conditioning ...................... .312
Engine Oil ........................... .482
Engine Oil Disposal .....................482
Flashers ............................... .435
Hazard Warning ....................... .435
Turn Signal .......................... .100
Flooded Engine Starting ....................322
Fluid, Brake ............................ .523
Fluid Capacities ......................... .521
Fluid Leaks ............................ .100Fluid Level Checks
Automatic Transaxle .....................503
Automatic Transmission ..................501
Cooling System ........................ .492
Power Steering ........................ .356
Fluids, Lubricants and Genuine Parts ...........522
Fog Lights ............................. .165
Folding Rear Seat ........................ .160
Folding Rear Seat (Sedan) ...................160
Four Wheel Drive ........................ .345
Systems ............................. .345
Four Wheel Drive Operation .................345
Freeing A Stuck Vehicle .....................463
Fuel .................................. .408
Adding ............................. .413
Additives .............................411
Capacity ............................ .521
Clean Air ............................ .409
Ethanol ............................. .409
10
INDEX 551

Fluid Level Check...................... .504
Frequency of Fluid Change ................504
Lubricant Selection ..................... .504
Map/Reading Lights ...................... .168
Master Cylinder (Brakes) ....................498
Methanol .............................. .409
Mini-Trip Computer ...................... .228
Mirrors ............................... .106
Automatic Dimming .....................107
Electric Powered ....................... .108
Exterior Folding ....................... .108
Heated .............................. .109
Outside ............................. .108
Rearview ............................ .106
Vanity ...............................110
Modifications/Alterations, Vehicle ...............8
Monitor, Tire Pressure System ................398
Mopar Parts ............................ .477
MTBE/ETBE ........................... .409Multi-Function Control Lever
.................164
New Vehicle Break-In Period ..................95
Occupant Restraints ........................67
Occupant Restraints (Sedan) ..................39
Octane Rating, Gasoline (Fuel) ................408
Odometer .............................. .223
Trip ................................ .221
Oil Change Indicator ...................... .234
Oil Change Indicator, Reset ..................234
Oil, Engine ............................. .479
Capacity ............................ .521
Change Interval ....................... .480
Checking ............................ .479
Disposal ............................. .482
Filter ............................... .482
Filter Disposal ........................ .482
Identification Logo ..................... .481
556 INDEX