fuse JEEP PATRIOT 2017 1.G User Guide

General Information........................ .390
Glass Cleaning ........................... .326
Gross Axle Weight Rating .....................223
Gross Vehicle Weight Rating ...................222
GVWR ................................. .220
Hands-Free Phone (Uconnect) ..................367
Hazard Warning Flasher ..................... .243
Headlights .............................. .244
Cleaning .............................. .323
High Beam/Low Beam Select Switch ...........47
On With Wipers ....................... .49, 53
Passing ................................47
Replacing ............................. .244
Switch .................................46
Head Restraints ......................... .39, 40
Heated Mirrors .............................46
Heated Seats ...............................37
Heater ...................................55
Heater, Engine Block ....................... .197
High Beam/Low Beam Select (Dimmer) Switch ......47
Hill Descent Control ....................... .139
Hill Start Assist ........................... .132
Hitches Trailer Towing .......................... .224HomeLink (Garage Door Opener)
................77
Hood Release ..............................71
Ignition ..................................21
Key ............................... .19, 21
Ignition Key Removal ........................21
Immobilizer (Sentry Key) ......................25
Inside Rearview Mirror .......................43
Instrument Cluster ..........................113
Instrument Panel Lens Cleaning ................326
Integrated Power Module (Fuses) ...............246
Interior And Instrument Lights ..................49
Interior Appearance Care .....................325
Interior Lights ..............................49
Intermittent Wipers (Delay Wipers) ...............52
Introduction ................................4
iPod/USB/MP3 Control Bluetooth Streaming Audio ..............366, 393
Jacking Instructions ........................ .251
Jack

Location ............................ .250
Jack Operation ..................... .249, 251, 302
Jump Starting ............................ .265
Key-In Reminder ............................2312
INDEX 409

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.