radio JEEP WRANGLER 2004 TJ / 2.G Owners Manual

WARNING!
If the hood is not fully latched, it could fly up when
the vehicle is moving and block your forward vision.
Be sure all hood latches are latched fully before
driving.
LIGHTS
Interior Lights
The overhead light comes on when a door is opened. It
may also be turned on by rotating the control for the
dimmer switch on the muti-function control lever fully
upward.
The overhead light will automatically turn off in about 20
minutes if a door is left open or the dimmer control is left
in the dome light position. Turn the ignition switch ON to
restore the overhead light operation.
Daytime Brightness Feature
Certain instrument panel components (odometer, radio
display) can be illuminated at full brightness during the
daytime. This can be helpful when driving with your
headlights on during the daytime such as in a parade or
a funeral procession. To activate this feature, rotate the
left stalk one detent lower than the dome light.
Multi-Function Control Lever
The multi-function control lever controls the operation of
the parking lights, headlights, headlight beam selection,
passing light, fog lights, instrument panel light dimming,
and turn signals.
56 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

UNDERSTANDING YOUR INSTRUMENT PANEL
CONTENTS
mInstrument Panel And Interior Controls......114
mInstrument Cluster.....................115
mInstrument Cluster Description............116
mElectronic Digital Clock.................120
NClock Setting Procedure.................121
mRadio General Information...............121
NRadio Broadcast Signals.................121
NTwo Types Of Signals..................121
NElectrical Disturbances..................121
NAM Reception.......................121
NFM Reception........................121
mSales Code RADÐAM & FM Stereo Radio
With Graphic Equalizer, Cassette Tape Player
With CD Player
.......................122
NRadio Security Code...................122
NOperating Instructions - Radio Mode.......122
NPower Switch, Volume Control............123
NSeek Button (Radio Mode)...............123
NTuning.............................123
NBalance............................123
NFade..............................123
NTone Control........................123
NAM/FM-Tape/CD/CD-C................123
4

NTo Set The Radio Push-Button Memory......123
NOperating Instructions - RDS Mode........124
NTime Button.........................124
NTA (Traffic Announcement) Button.........125
NPTY (Program Type) Button..............125
NAF LOC (Alternative Frequencies And Local
Frequencies) Button....................126
NOperating Instructions - Tape Mode........126
NChanging Tape Direction................127
NSeek Button.........................127
NFast Forward (FF).....................127
NRewind (RW)........................127
NTape EjectD.........................127
NMetal Tape Selection (70s)..............127
NPinch Roller Release...................128
NDolby Noise Reduction.................128NOperation Instructions Ð CD Player........128
NInserting The Compact Disc..............128
NSeek Button.........................128
NEJT CD (Eject) Button..................129
NFF/Tune/RW Button...................129
NProgram Button 4 (Random Play)..........129
NCD/CDÐC/Tape Button................129
NTime Button.........................129
mSales Code RBBÐAM/FM Stereo Radio
With Cassette Tape Player And CD Changer
Capability
...........................130
NOperating Instructions..................130
NPower Button........................130
NElectronic Volume Control...............130
NSeek..............................130
NTune ..............................131
110 UNDERSTANDING YOUR INSTRUMENT PANEL

NTo Set The Push-Button Memory..........131
NBalance............................131
NFade..............................131
NBass And Treble Tone Control............131
NAM/FM Selection.....................132
NMode Button........................132
NCassette Player Features................132
NCD Changer Control Capability Ð
If Equipped.........................133
NRadio Display Messages................134
mSales Code RBKÐAM/ FM Stereo Radio
With CD Player And CD Changer Controls
...135
NRadio Operation......................135
NCD Player Operation...................137
NCD Changer Control Capability Ð
If Equipped.........................138
NRadio Display Messages................140
mSales Code RBT/RBYÐAM Stereo & FM Stereo
Radio With Graphic Equalizer, Cassette Tape
Player And CD Player
..................140
NOperating Instructions - Radio Mode.......140
NPower Switch, Volume Control............140
NSeek (Radio Mode)....................141
NTune ..............................141
NBalance............................141
NFade..............................141
NTone Control........................141
NAM/FM Selection.....................141
NTo Set The Radio Push-Button Memory......141
NTime ..............................142
NOperating Instructions - Tape Mode........142
N(¹D)...............................142
NTape ..............................142
UNDERSTANDING YOUR INSTRUMENT PANEL 111
4

NSeek..............................142
NFast Forward (FF).....................143
NRewind (RW)........................143
NEJTTape ...........................143
NMetal Tape Selection (70s)..............143
NPinch Roller Release...................143
NDolby Noise Reduction.................143
NOperation Instructions Ð CD Player........144
NInserting The Compact Disc..............144
NSeek..............................144
NEJTCD ............................144
NFF/Tune/RW........................144
NRND (Random Play)...................144
NCD/CD-C..........................145
NTime ..............................145mSatellite Radio Ð If Equipped.............145
NSystem Activation.....................145
NElectronic Serial Number/Sirius Identification
Number (ENS/SID)....................145
NSelecting Satellite Mode In RBB And
RBK Radios.........................146
NSelecting Satellite Mode In RBP, RBU,
RAZ, And RBQ Radios.................146
NSelecting a Channel....................146
NStoring And Selecting Pre-Set Channels......147
NUsing The PTY (Program Type) Button
(If Equipped)........................147
NPTY Button9Scan9.....................147
NPTY Button9Seek9.....................147
NSatellite Antenna......................147
NReception Quality.....................147
112 UNDERSTANDING YOUR INSTRUMENT PANEL

mCassette Tape And Player Maintenance......148
mCD/DVD Disc Maintenance..............149
mRadio Operation And Cellular Phones.......149
mClimate Controls......................149
NHeater Only Ð If Equipped..............150NAir Conditioning Ð If Equipped..........151
NOperating Tips.......................154
mRear Window Features Ð Hard Top Only....154
NRear Window Defogger.................154
NRear Window Wiper/Washer.............155
UNDERSTANDING YOUR INSTRUMENT PANEL 113
4

If the parking brake is applied and the vehicle is in
motion, the red BRAKE warning light will ªflashº and a
chime will sound.
The operation of the BRAKE warning light can be
checked by turning the ignition switch from the OFF
position to the ON position. The light should illuminate
for approximately two seconds. The light should then
turn off unless the parking brake is applied or a brake
fault is detected. If the light does not illuminate, have the
light inspected by an authorized dealer.
23. Low Fuel Warning Light
When the fuel level reaches approximately 2 U.S.
Gallons (7.6L) this light will come on and remain
on until fuel is added. The ªLow Fuel Warning
Lightº may turn on and off again, especially during
and after hard braking, accelerations, or turns. This
occurs due to the shifting of the fuel in the tank.
24. Fuel Cap Indicator
This symbol indicates the side of the vehicle
where the fuel cap is located.25. Fuel Gauge
The pointer shows the level of fuel in the fuel tank. When
the fuel gauge pointer initially moves to E, for your
safety, approximately 2 U.S. Gallons (7.6L) of fuel remain.
NOTE:When the ignition switch is turned to OFF, the
fuel gauge, voltmeter, oil pressure and temperature
gauges may not show accurate readings. When the
engine is not running, turn the ignition switch to ON to
obtain accurate readings.
ELECTRONIC DIGITAL CLOCK
The clock and radio each use the display panel built into
the radio. A digital readout shows the time in hours and
minutes whenever the ignition switch is in the ON or
ACC position and the time button is pressed.
When the ignition switch is in the OFF position, or when
the radio frequency is being displayed, time keeping is
accurately maintained.
120 UNDERSTANDING YOUR INSTRUMENT PANEL

Clock Setting Procedure
1. Turn the ignition switch to the ON or ACC position
and press the time button. Using the tip of a ballpoint pen
or similar object, press either the hour (H) or minute (M)
buttons on the radio.
2. Press the H button to set hours or the M button to set
minutes. The time setting will increase each time you
press a button.
RADIO GENERAL INFORMATION
Radio Broadcast Signals
Your new radio will provide excellent reception under
most operating conditions. Like any system, however, car
radios have performance limitations, due to mobile op-
eration and natural phenomena, which might lead you to
believe your sound system is malfunctioning. To help
you understand and save you concern about these ªap-
parentº malfunctions, you must understand a point or
two about the transmission and reception of radio sig-
nals.
Two Types of Signals
There are two basic types of radio signals... AM or
Amplitude Modulation, in which the transmitted sound
causes the amplitude, or height, of the radio waves to
vary... and FM or Frequency Modulation, in which the
frequency of the wave is varied to carry the sound.
Electrical Disturbances
Radio waves may pick up electrical disturbances during
transmission. They mainly affect the wave amplitude,
and thus remain a part of the AM reception. They
interfere very little with the frequency variations that
carry the FM signal.
AM Reception
AM sound is based on wave amplitude, so AM reception
can be disrupted by such things as lightning, power lines
and neon signs.
FM Reception
Because FM transmission is based on frequency varia-
tions, interference that consists of amplitude variations
can be filtered out, leaving the reception relatively clear,
which is the major feature of FM radio.
UNDERSTANDING YOUR INSTRUMENT PANEL 121
4

SALES CODE RADÐAM & FM STEREO RADIO
WITH GRAPHIC EQUALIZER, CASSETTE TAPE
PLAYER WITH CD PLAYER
Radio Security Code
This radio is equipped with an anti-theft feature which
requires that a four digit code number be entered when-
ever the power supply is interrupted (such as a discon-
nected battery). The four digit code can be found on the
last page of this manual. Please remove this page from
the manual and store it in a safe place outside of the
vehicle.To enter the code, turn the key to the ON or ACC position
and press the ON/VOL control. The word CODE will
appear on the display. Enter your four digit code by
pressing the appropriate preset buttons in sequence. Your
radio is now ready for basic operation.
If an invalid code is entered into the radio, the radio will
allow two more attempts. After a third attempt of enter-
ing an invalid code, the radio will go into a lockup mode.
This is to prevent continuous attempts at entering the
wrong code until the right code is found.
Once a radio is in this lockup mode, it must be in a state
where battery is applied for approximately 30 minutes.
During this time, if the radio is on, the display will show
ªWAITº. After approximately 30 minutes, (radio on)
radio will display ªCODEº thereby again querying the
operator for the 4 digit anti-theft code.
Operating Instructions - Radio Mode
NOTE:
Power to operate the radio is supplied through
the ignition switch. It must be in the ON or ACC position
to operate the radio.
122 UNDERSTANDING YOUR INSTRUMENT PANEL

Power Switch, Volume Control
Press the ON/VOL control to turn the radio on. Turn the
volume control to the right to increase the volume.
Seek Button (Radio Mode)
Press and release the Seek button to search for the next
station in either the MW/LW or FM mode. Press the top
of the button to seek up and the bottom to seek down.
The radio will remain tuned to the new station until you
make another selection. Holding the button in will by-
pass stations without stopping until you release it.
Tuning
Press the TUNE control up or down to increase or
decrease the frequency. If you press and hold the button,
the radio will continue to tune until you release the
button. The frequency will be displayed and continu-
ously updated while the button is pressed.
Balance
The Balance control adjusts the left-to-right speaker bal-
ance. Push in the button and it will pop out. Adjust the
balance and push the button back in.
Fade
The Fade control provides for balance between the front
and rear speakers. Push in the button and it will pop out.
Adjust the balance and push the button back in.
Tone Control
Slide the Bass and/or Treble controls up or down to
adjust the sound for the desired tone.
AM/FM-TAPE/CD/CD-C
Press the top of this button to switch between MW, FM,
and LW. Press the bottom of this button to switch
between Tape, CD, and optional CD changer control
operation.
To Set The Radio Push-button Memory
You can store a total of 10 FM, 5 MW and 5 LW stations
into memory.
When you are receiving a FM station that you wish to
commit to push-button memory, press the SET button.
SET 1 will appear in the radio display window. Select the
push button you wish to lock on this station and press
and release that button. If a button is not selected within
UNDERSTANDING YOUR INSTRUMENT PANEL 123
4