tow bar JEEP WRANGLER 2005 TJ / 2.G Owners Manual

5. Unsnap and remove the black boot cover. This cover
should be discarded. It was intended as a protective
cover for shipping only.
NOTE:A visual instruction sheet is enclosed in the dual
top wrap.6. Open the tailgate.
7. Remove the tailgate bar (black bar with end caps) that
is located in the soft top and set aside.
NOTE:Be sure the wire harness is not attached to the
soft top bows before you lift the top.
8. Lift the soft top fabric up and away from the plastic
header with latches.
9. Pull all of the soft top fabric toward the rear of the
vehicle and wrap around the plastic header.
10. Pull the soft top fabric around the ends of the plastic
header so that the fabric has a tight, smooth appearance.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 77
3

6. Pull the retainer bar straight out from the tailgate clips.
•Remove the rear window entirely. This is done by
unzipping the window by bringing both the right
zipper and left zipper tabs all the way to the end of
the zipper track at the bottom left corner. Both
zipper tabs will remain on the zipper track attachedto the top. Pull up on the window to disengage
zipper end. Stow the windows carefully to avoid
scratching.
7. Beginning from the rear, moving forward, partially
unzip the side window and untuck the bottom retainers.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 95
3

5. Grip and rotate the retainer bar up towards you to
release it from the upper portion of the tailgate clips. The
retainer bar runs along the bottom of the rear window.
6. Remove the rear window entirely. This is done by
unzipping the window, bringing both the right zipper
and the left zipper tabs all the way to the end of the
zipper track at the bottom left corner. Both zipper tabswill remain on the zipper track attached to the top. Pull
up on the window to disengage zipper end. Stow win-
dow carefully to avoid scratching.
7. Undo the Velcrothat runs along the top and rear
edge of the side window. Beginning from the rear and
moving forward, partially unzip the side window and
untuck the bottom retainer.
112 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To Lower
1. Remove strap from header and sport bar.
2. Release header latches from header retainer.
3. Unclip and move the sun visors to the side.
4. Grasp the front header and pull to the front of the
vehicle.
5. Slide plastic sleeve rearward over Sunrider link.
6. Tuck drip rail retainers into the door frame slots.
7. Close the header latches, and return sun visors to their
original position.
NOTE:Sunrider is a trademark of Bestop, Inc.DOOR FRAME
WARNING!
Do not drive your vehicle on-pavement with the
door frame removed or the windshield down as you
lose the protection these structural elements can
provide. These two procedures are furnished for use
during off-road operation only.
Door Frame Removal
1. Unscrew and remove the door frame attachment
knobs. Place one hand in the upper rear and one hand on
the upper front of the door frame. Pull the frame towards
you with your rearward hand to remove the frame from
the vehicle.
128 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

5. Shift automatic transmission into D (Drive) or manual
transmission into gear.
6. Release brake pedal and ensure that there is no vehicle
movement.
7. Shut the engine off and place the ignition key into the
unlocked OFF position.
8. Shift automatic transmission into P (Park).
9. Apply parking brake.
10. Attach vehicle to the tow vehicle with tow bar.
11. Release parking brake.CAUTION!
Damage to the transmission may occur if the trans-
mission is shifted into P (Park) with the transfer case
in N (Neutral) and the engine running. With the
transfer case in N (Neutral) ensure that the engine is
off prior to shifting the transmission into P (Park)
(refer to steps7 – 8 above).
Shifting Out Of Neutral (N)
Use the following procedure to prepare your vehicle for
normal usage.
1. Shift automatic transmission into N (Neutral) or de-
press clutch pedal on manual transmission.
2. Shift transfer case lever into desired position.
3. Shift automatic transmission into D (Drive) or release
clutch on manual transmissions.
STARTING AND OPERATING 233
5

NOTE:When shifting out of transfer case N (Neutral)
on automatic transmission equipped vehicles, turning
the engine off may be required to avoid gear clash.
WARNING!
You or others could be injured if you leave the
vehicle unattended with the transfer case in the N
(Neutral) position without first fully engaging the
parking brake. The transfer case N (Neutral) position
disengages both the front and rear driveshafts from
the powertrain and will allow the vehicle to move
despite the transmission position. The parking
brake should always be applied when the driver is
not in the vehicle.
CAUTION!
•Do not use a bumper mounted clamp-on tow bar
on your vehicle. The bumper face bar will be
damaged.
234 STARTING AND OPERATING