phone JEEP WRANGLER 2016 JK / 3.G Workshop Manual

UconnectAdvanced Phone Connectivity ..............133
Phone Call Features .....................125
Phone Features ........................ .128
Uconnect 130 Operating Instructions Auxiliary Mode ........366
Operating Instructions Radio Mode .......358, 367
Uconnect 130 With Satellite Radio Multimedia Satellite Radio .............379, 399
Operating Instructions CD Mode ............373
Operating Instructions Radio Mode ..........367
Playing MP3 Files ...................... .375
Uconnect (Hands-Free Phone) ................115
Uniform Tire Quality Grades .................679
Universal Consumer Interface (UCI) Connector . . . .404
Unleaded Gasoline ....................... .534
Untwisting Procedure, Seat Belt ................56
Vanity Mirrors ...........................114 Variance, Compass
.....................340, 350
Vehicle Identification Number (VIN) .............8
Vehicle Loading ...................... .506, 541
Vehicle Modifications/Alterations ...............9
Vehicle Storage ....................... .426, 654
Viscosity, Engine Oil ...................... .602
Voice Command Commands ........................... .148
System Operation ...................... .146
Voice Training ........................ .152
Voice Recognition System (VR) ................146
Warnings And Cautions ......................8
Warranty Information ..................... .677
Washers, Windshield ...................... .621
Washing Vehicle ......................... .639
Wheel And Wheel Trim .....................641
Wheel And Wheel Trim Care .................641
Wind Buffeting ............................46
700 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.