mirror controls KIA Magnetis 2006 2.G Owner's Manual

KNOWING YOUR VEHICLE
3-20
SPLIT FOLDING REAR
SEATThe rear seatbacks fold forward to
provide additional cargo space and to
provide a access to the trunk area.
• To fold the rear seatback(s) down,
press the unlock button located in the
top of the seatbacks, then fold the
seatback forward and down.
• To raise the seatback, lift and push it
firmly until it clicks into place.
• When you return the seatback to its
upright position, reposition the rear
safety belts so that they can be used
by rear seat passengers.
MMSA3014
WARNING
To drive properly, adjust the
driver’s seat and its headrest
before starting. After doing so,
you should adjust the day/night
rearview mirror and the outside
rearview mirror.
WARNING - Cargo
Cargo should always be
secured to prevent it from
shifting and causing injury to
the vehicle occupants.
CAUTION
Do not remove the floor carpet in
your vehicle, emission controls
cause high exhaust temperatures
under the floor.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 20

3-59
ELECTRIC REMOTE
CONTROLThis switch, located on the armrest of the
driver’s door, controls the adjustments for
both right and left outside mirrors. To
adjust the position of either mirror:
1. Move the selector switch to the right
or left to activate the adjusting
mechanism for the corresponding
mirror.
2. Adjust the mirror angle by depressing
the mirror adjustment control switch
in the desired direction.
MMSA3052
✻
NOTICE
Do not scrape ice off the mirror
face; this may damage the surface
of the glass. If ice should restrict
movement of the mirror, do not
force the mirror to adjust it.
To remove ice, use a de-icer spray,
or a sponge or soft cloth with very
warm water.
✻
NOTICE
The mirrors stop moving when
they reach the maximum adjusting
angles, but the motor continues to
operate while the switch is
depressed. Do not depress the
switch longer than necessary or the
motor may be damaged.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 59

Electric type (if equipped)The electric day/night rearview mirror
automatically controls the glare from the
headlights of the car behind you. Adjust
the rearview mirror to the desired
position.Type APress the “O” button to turn the
automatic- dimming function off. The
mirror indicator light will turn off.
Press the “I” button to turn the
automatic- dimming function on, The
mirror indicator light will illuminate.
Type BWhen the ignition switch is ON, the
automatic-dimming function will turn on
automatically.
Press the ON/OFF button (
➀) to turn the
automatic-dimming function off. The
mirror indicator light will turn off.
Press the ON/OFF button (➀) once again
to turn the automatic-dimming function
on. The mirror indicator light will
illuminate.
3-61
CAUTION
Do not place objects in the rear
seat or cargo area which would
interfere with your vision out the
rear window.✻
NOTICE
When cleaning the mirror, use a
paper towel or similar material
dampened with glass cleaner. Do
not spray glass cleaner directly on
the mirror as that may cause the
liquid cleaner to enter the mirror
housing.
Type A
Type B
➀
MMSA3075/1KMA3084
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 61

DRIVING TIPS
5-4 Do not operate the vehicle when
there are signs of engine malfunction,
such as misfire or a noticeable loss of
performance.
 Do not misuse or abuse the engine.
Examples of misuse are coasting
with the ignition off and descending
steep grades in gear with the ignition
off.
 Do not operate the engine at high idle
speed for extended periods (5
minutes or more).
 Do not modify or tamper with any
part of the engine or emission control
system. All inspections and
adjustments must be made by a
qualified technician.
Failure to observe the above precautions
could result in damage to the catalytic
converter and to your vehicle and could
void your warranties.
BEFORE DRIVINGBefore entering vehicle:
 Be sure that all windows, outside
mirror(s), and outside lights are clean.
 Check the condition of the tires.
 Check under the vehicle for any sign
of leaks.
 Be sure there are no obstacles behind
you if you intend to back up.NECESSARY
INSPECTIONSFluid levels, such as engine oil, engine
coolant, brake/clutch fluid, and washer
fluid should be checked on a regular
basis, with the exact interval depending
on the fluid. Further details are provided
in Maintenance, Section 7.
BEFORE STARTING Close and lock all doors.
 Position the seat so that all controls
are easily reached.
 Adjust the inside and outside
rearview mirrors.
 Be sure that all lights work.
 Check all gauges.
 Check the operation of warning
lights when the ignition switch is
turned to the ON position.
 Release the parking brake and make
sure the brake warning light goes out.
For safe operation, be sure you are
familiar with your vehicle and its
equipment.
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 4