ignition KIA OPTIMA 2014 Features and Functions Guide
[x] Cancel search | Manufacturer: KIA, Model Year: 2014, Model line: OPTIMA, Model: KIA OPTIMA 2014Pages: 46, PDF Size: 0.98 MB
Page 9 of 46
7
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFET Y WARNINGS.
*IF EQUIPPED
Active ECO System*The Active ECO system helps improve fuel
efficiency by controlling several vehicle
components. When activated, it optimizes
drivetrain operations such as engine power
and transmission for better fuel economy.
To turn ON, press the ECO button
B. The
button light will turn on and the green
ECO indicator light
C
in the instrument
cluster will illuminate (indicating that you
are getting optimal fuel efficiency). The
Active ECO System will remain on even
when the engine is turned off and restarted.
To turn the Active ECO System OFF, press
ECO button
B again.
CANCEL OKECO
B
Optima Active ECO
Video
To view a video on your
mobile device, SNAP this
QR code or visit the listed
website.
Refer to page 2 for more
information.
QR CODE
www.KuTechVideos.com/qf13/2014•
To help improve your
fuel efficiency:
• Drive at a moderate
speed, accelerating
smoothly and at a
moderate rate
• Keep tires inflated to
the recommended
pressure
• Be sure the wheels are
properly aligned
For more information on Active ECO, refer to your
Owner’s Manual or contact your local dealership.
C
CANCEL OK
SET
ECO
Drive Mode Integrated
Control System*Drive Mode:
The Drive Mode may
be selected depending on driver’s
preferences and road conditions.
To scroll through the different Drive
Modes, press the DRIVE MODE button A. The Instrument Cluster will display
SPORT or ECO when selected. When in
Normal mode, it will not display in the
Instrument Cluster.
REMINDER: The system is turned ON and to
Normal Mode when ignition is in the ON position
A
(located on Steering Wheel)
(located on Steering Wheel)
(located on Instrument Cluster)
QUICK TIPS
INSTRUMENT CLUSTER
Page 11 of 46
9
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFET Y WARNINGS.
*IF EQUIPPED Blind Spot Detection / Lane Change Assist
1st-stage alert: When another vehicle is detected within the
BSD System boundary, a yellow light will illuminate on the
outside rearview mirrors.
2nd-stage alert: When 1st stage alert is on and a turn signal is
turned on, an alarm will sound.
RCTA (Rear Cross Traffic Alert)
When the vehicle is in Reverse and moves backwards from a
parking position, the sensor detects approaching vehicles on
the left or right side.Blind Spot Detection (BSD) System* The BSD system uses radar sensors to help alert the
driver while changing lanes or while in Reverse moving
backwards.
When the BSD button is pressed ON, the BSD indicator
on the button
A
will illuminate. The outside rearview
mirror warning lights will also illuminate for 3 seconds.
The system will become active when the vehicle is
traveling more than 18 mph and will alert the driver if
another vehicle is detected by the radar sensor.
A
Blind Spot Detection
System Video
To view a video on your
mobile device, snap this
QR code or visit the listed
website.
Refer to page 2 for more
information.www.KuTechVideos.com/vg13/2014
REMINDER:
• The BSD system will not show a warning if the vehicle speed is only 6mph above the surrounding vehicles
• When the BSD is ON and the ignition is cycled to OFF then ON again, the BSD system returns to ON
• The RCTA feature can be turned OFF/ON in User Settings
For more information on the Blind Spot Detection System, please refer to the Owner’s Manual.
QUICK TIPS
DRIVER’S PANEL
Page 12 of 46
OPTIMA
FEATURES & FUNCTIONS GUIDE
10
*IF EQUIPPED REMINDERS:
• As a bulb check, the EPB malfunction indicator will illuminate for
approximately 3 seconds when the ignition switch is turned ON
• If the warning light does not illuminate temporarily, or continues to
remain lit, take your vehicle to an authorized Kia dealer and have the
system checked
• The EPB should not be operated while the vehicle is moving, unless
there is an emergency situation
• A click or electric brake motor sound may be heard while operating or
releasing the EPB, but these conditions are normal and indicate that the EPB
is functioning properly
Electric Parking Brake (EPB)*The Electric Parking Brake (EPB) system utilizes an electric motor to engage the parking brake.
Applying the Parking Brake
Depress the brake pedal and pull up the EPB switch
A. Ensure that the indicator light
is
illuminated on the instrument cluster.
Releasing the Parking Brake
The EPB will automatically release when the shifter is placed in Reverse or Drive .
To release EPB manually, depress the brake pedal, then press the EPB switch
A, with the
ignition switch in the ON position. Ensure that the indicator light
is OFF.
•
• When leaving your keys with parking lot attendants or valet, make
sure to inform them how to operate the EPB
• If parked on a steep incline, pull up the EPB switch for more than 3
seconds for a firmer EPB application•
Pull up and hold EPB switch again to increase brake pressure if parked on a decline or incline.
AB
Electric Parking Break
(EPB)/AUTO HOLD Video
To view a video on your
mobile device, SNAP this
QR code or visit the listed
website.
Refer to page 2 for more
information.
QR CODE
www.KuTechVideos.com/qf13/2014
QUICK TIPSQUICK TIPS
DRIVER’S PANEL
Page 17 of 46
15
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFET Y WARNINGS.
*IF EQUIPPED
If the wiper switch is in AUTO mode when the ignition is ON, the
wiper will operate once to perform a self-check of the system.
Set the wiper to OFF position when the wiper is not in use.
QUICK TIPS
Windshield Wipers & Washers
Rotate lever to adjust
Intermittent Wipe Speed.
MIST: Single wipe
INT: Intermittent wipe
LO: Slow wipe
HI: Fast wipe OFF: Wiper off Move lever Up/Down to
change Wiper modes.
MISTOFFINTLOHI
FRONT
Pull to spray and wipe.Faste r
Slower
STEERING WHEEL CONTROLS
Page 19 of 46
17
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFET Y WARNINGS.
*IF EQUIPPED Heated Steering Wheel Button*Press button
A to turn ON/OFF steering wheel
heater, while the Engine Start/Stop Button is in
the ON position. Steering wheel heater will turn
off automatically in 30 minutes, or when button
is pressed again to deactivate.
If ignition is turned OFF, then ON again, within 30
minutes of steering wheel heater being turned on,
system will automatically be set ON again.
QUICK TIPS
A
D
C
B
To adjust the Steering Wheel, push down the lock-release
lever
B and adjust to desired angle
C and distance
D.
When finished, pull up the lock-release lever
B to lock
Steering Wheel in place.
Tilt/Telescopic Steering Wheel*REMINDER: The telescopic range of motion is approximately 1. 5 inches.
STEERING WHEEL CONTROLS
Page 22 of 46
OPTIMA
FEATURES & FUNCTIONS GUIDE
20
*IF EQUIPPED
Cruise Control* Audio Controls*
•
• Cruise Control is designed to function above approximately
25 mph
• The cruise control system will not activate until the brake
pedal has been depressed at least once after ignition ON or
engine starting
QUICK TIPS
Pressing the Audio Mode button for more than 1 second will
turn Audio Mode ON/OFF.
QUICK TIPS
A Audio Mode button: Press to cycle through FM1-2 / AM
/ SAT 1-3 / CD / USB / AUX / iPod
®
B
Seek/Preset button
Radio Mode: Press to advance through Preset Stations.
Press and hold to AUTO SEEK
CD / USB / iPod
® Mode: Press to move TRACK UP/
DOWN. Press & hold to FF/REW
C Vo l u m e b u t to n: Press up/down to raise/lower volumeD Mute button: Press to mute all audio
E
Cruise Control ON/OFF: Press to turn the
Cruise Control ON/OFFF Resume Cruising Speed: Press to resume or increase
Cruising SpeedF Set Cruising Speed button: Press to set or decrease
Cruising SpeedG Cruise Control Cancel button: To cancel Cruise
Control setting, do one of the following:
• Press the brake pedal
• Press the CANCEL button
G
VOL VOL
MUTEMODE
CRUISECANCEL OK
RESSET
D
AB
C
E
FG
For further audio system operations, refer to pages 16-24 . REMINDER: Your vehicle’s steering wheel buttons may differ from
those in the illustrations. See your Owner’s Manual for more details.
REMINDER: Driving while distracted is dangerous and should be
avoided. Drivers should remain attentive to driving and always exercise
caution when using the steering-wheel-mounted controls while driving.
STEERING WHEEL CONTROLS
Page 27 of 46
25
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFET Y WARNINGS.
*IF EQUIPPED Standard Audio System Clock Setup:
Press the H button
A to advance the time by one hour.
Press the M button B to advance the time by one minute.
UVO System Clock Setup:
Press the CLOCK button to display the Clock setting
screen. Then use the on-screen buttons to navigate
through setup.Navigation System Clock Setup:
Press the Info/Settings key on the Audio Control Unit. Then
press the on-screen Setup button and select the Clock icon.
Aux/USB/iPod
® Port* & Power Outlets*
12V12V
AUXUSB
Kia USB Port Video
To view a video on your
mobile device, SNAP this
QR code or visit the listed
website.
Refer to page 2 for more
information.
QR CODE
www.KuTechVideos.com/qf13/2014
Press and hold both for more than 5 seconds to switch from 12
to 24 hour formats.
QUICK TIPS
Press the DONE button* on the Navigation screen to ensure
changes are saved.
Digital Clock
H
MH
MAB
QUICK TIPS
The power outlets are inactive when ignition
is in the OFF position
QUICK TIPS
CENTER PANEL
Page 31 of 46
29
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFET Y WARNINGS.
*IF EQUIPPED SEATING
Seatback Lumbar Seat forward/
backwardSeat Cushion
Driver Position Memory System*To store a seating position into memory, first place the
shifter into P (Park) while the ignition switch is ON. Then:
1. Adjust the driver’s seat
2. Press the SET button
A on the control panel. System
will beep once
3. Press one of the memory buttons
B within 5 seconds. The
system will beep twice when memory has been stored
4. “Driver (1 or 2) set is memorized” will appear on the
instrument cluster LCD display
Power Adjustable Driver’s Seat*Move/Press controls to adjust Seat forward/backward, Seat Cushion, Seatback or Lumbar
B
C
A
A
B
C
A
SET
1
2
AB
Driver Position Memory
System Video
To view a video on your
mobile device, SNAP this
QR code or visit the listed
website.
Refer to page 2 for more
information.
QR CODE
www.KuTechVideos.com/qf13/2014
Page 32 of 46
OPTIMA
FEATURES & FUNCTIONS GUIDE
30
*IF EQUIPPED
SEATING
• With the seat
warmer switch in
the ON position,
the heating
system in the seat
turns OFF or ON
automatically
depending on the
seat temperature
• System defaults to
the OFF position
whenever the
ignition switch is
turned ON
QUICK TIPS
Seat Warmers* Press button once for high
setting (2 LEDs lit), again
for low setting (1 LED lit)
and again to turn OFF.
Seat Warmers — Press
top of button once for high
setting (2 LEDs lit), again for
low setting (1 LED lit) and
again to turn OFF.
Ventilated Seats — Press
bottom of button once
for high setting (2 LEDs
lit), again for low setting
(1 LED lit) and again
to turn OFF.
RR
Ye l l o w C o l o r :
Warming Ye l l o w C o l o r :
Warming
Blue Color:
Ventilating
Seat Warmers/
Ventilated Seats*
Seat Warmers Video
To view a video on your
mobile device, SNAP this
QR code or visit the listed
website.
Refer to page 2 for more
information.
QR CODE
www.KuTechVideos.com/qf13/2014
C
B
A
6-Way Manual Adjustable Driver’s SeatPull lever
A to slide Seat forward/backward
Pull/press lever
B to adjust Seat Height
Pull lever
C to adjust Seatback Recline
Page 38 of 46
OPTIMA
FEATURES & FUNCTIONS GUIDE
36
*IF EQUIPPED
•
• To stop the Sunroof/Sunshade at any position, push or pull
the sunroof control lever in any direction
QUICK TIPS
Panoramic Sunroof Operation*The sunroof and sunshade operation is controlled through
a multidirectional switch/lever and the ignition needs to
be in the ON position to operate the sunroof/sunshade.
Slide the Sunshade and Sunroof:• Auto Open: Slide lever
A
backward to the farthest
position and release.
• Auto Close: Slide the lever
A
forward to the
farthest position and release.
Slide the Sunshade:• Open: Slide the lever
A
partially backward to the first detent position.
• Auto Close: Slide the lever
A forward to the farthest
position.
Warning! Check your surroundings for safety
Rear-Camera Display*The Rear-Camera Display system is not a safety device.
It is a supplemental system that displays
the view behind the vehicle through the Navigation* or
UVO* screen while the vehicle is in Reverse.
The Rear- Camera Display activates when the:
• Engine Start/Stop* button is in the ON position
(G re e n L ig ht)
• Gear Shift Lever is in the R (Reverse) position
A
REMINDER:
• The Rear-Camera Display is not a substitute for proper and safe backing-
up procedures. The Rear-Camera Display may not display every object
behind the vehicle. Always drive safely and use caution when backing up
• While camera is active, only the volume controls on the Audio System can
be operated. REMINDER: Sunshade needs to remain OPEN while Sunroof is open and
vehicle is moving.Slide the Sunroof (with sunshade open):• Open: Slide the lever
A backward and release.
• Close: Slide the lever A partially forward to
the first detent position or pull the lever downward.
Tilt the Sunroof:• Raise: Push lever
A upward.
• Lower: Pull lever
A downward.
• Auto Close: Slide the lever
A forward to the
farthest position.
OTHER KEY FEATURES