ECU KIA OPTIMA PLUG-IN HYBRID 2017 Owner's Guide

4. êêç: êecure êimple çairing[Non êêç supported device]
After a few moments, a screen is
displayed where the passkey is en‐
tered.
Enter the passkey L

Bluetooth® Wireless Technology
(Type B-2)
When No Devices have been Paired
1. çress the /PHONE button or
the button on the steering
wheel controls. The following
screen is displayed.
2. çress the [OK] button to enter the çair çhone screen.
• Car name: Name of device asshown when searching from your Bluetooth ®
Wireless Technology
device
• çasskey: çasskey used to pair the device
3. From your Bluetooth ®
Wireless
Technology device (i.e. Mobile
çhone), search and select your car
audio system. 4. êêç: êecure êimple çairing
[Non êêç supported device]
After a few moments, a screen is
displayed where the passkey is en‐
tered.
Enter the passkey L

4. êêç: êecure êimple çairing[Non êêç supported device]
After a few moments, a screen is
displayed where the passkey is en‐
tered.
Enter the passkey L

NOTICE
•In manual mode, the driver must
execute upshifts in accordance
with road conditions, taking care
to keep the engine speed below
the red zone.
•In manual mode, only the 6 for‐
ward gears can be selected. To re‐
verse or park the vehicle, move
the shift lever to the R (Reverse)
or P (Park) position as required.
•In manual mode, downshifts are
made automatically when the ve‐
hicle slows down. When the vehicle
stops, 1st gear is automatically
selected.
•In manual mode, when the engine
rpm approaches the red zone shift
points are varied to upshift auto‐
matically.
•To maintain the required levels of
vehicle performance and safety,
the system may not execute cer‐
tain gearshifts when the shift lev‐
er is operated.
(Continued)
(Continued)
•When driving on a slippery road,
push the shift lever forward into
the + (up) position. This causes the
transaxle to shift into the 2nd
gear which is better for appropri‐
ate driving on a slippery road.
Push the shift lever to the -
(down) side to shift back to the
1st gear.
Shift lock system
For your safety, the automatic trans‐
axle has a shift lock system which pre‐ vents shifting the transaxle from P
(Park) into R (Reverse) unless the brake
pedal is depressed.
To shift the transaxle from P (Park) in‐ to R (Reverse): 1. Depress and hold the brake pedal.
2. Start the hybrid system or turn the ignition switch to the ON position.
3. Move the shift lever. If the brake pedal is repeatedly de‐
pressed and released with the shift lev‐
er in the P (Park) position, a chattering noise & vibration near the shift lever
may be heard. This is a normal condi‐
tion.
WARNING
Always fully depress the brake pedalbefore and while shifting out of theP (Park) position into another posi‐tion to avoid inadvertent motion ofthe vehicle which could injure per‐sons in or around the vehicle.
0+'-#
Driving your vehicle
7-14

(Continued)
•For your safety, depress the brake
pedal and release the parking
brake manually with the EPB
switch when you drive downhill or
when backing up the vehicle.
CAUTION
•If the parking brake warning lightis still on even though the EPB hasbeen released, we recommendthat the system be checked by anauthorized Kia dealer.
•Do not drive your vehicle with theEPB applied. It may cause exces‐sive brake pad and brake rotorwear.
EPB (Electronic Parking Brake) may beautomatically applied when:
• The EPB is overheated
• Requested by other systems
• The hybrid system is turned off with the EPB applied
NOTICE
If the driver turns the hybrid system
off while Auto Hold is operating, EPB
will be automatically applied. Howev‐
er, if you press the EPB switch with‐
in one second after the hybrid sys‐
tem is turned off, the EPB will not
be applied.
System warning
0+'-
• If you try to drive off depressing theaccelerator pedal with the EPB ap‐
plied, but doesn't release automati‐ cally, a warning will sound and a mes‐
sage will appear.
• If the driver's seat belt is not fas‐ tened and the engine hood or trunk is
opened, a warning will sound and a
message will appear.
• If there is a problem with the vehicle, a warning may sound and a message
may appear.
If the above situation occurs, depress
the brake pedal and release EPB by pressing the EPB switch.
WARNING
•To prevent unintentional move‐ment when stopped and leavingthe vehicle, do not use the shiftlever in place of the parking brake.Set the parking brake and makesure the shift lever is securelypositioned in P (Park).
(Continued)

7-21
7
Driving your vehicle

(Continued)
•Even if the warning chime is notactivated, always pay attention tothe driving conditions to preventdangerous situations from occur‐ring.
Collision alert
0+'
When the ASCC system is on, and there
is a high risk of collision due to sudden braking of the vehicle in front or not
securing enough space with the vehicle
in front, the driver needs to control the brake system or the steering wheel
manually. In this case, the collision alert
warning displays on the instrument cluster and warning sounds. Decrease
vehicle speed immediately.
WARNING
•Even when the indicator displayingthe distance with the vehicle infront does not blink or the collisionalert does not sound, always drivesafely.
•Depending on the use of radio,sound quality, and driving condi‐tions, you may not be able to hearthe warning sound. Therefore, al‐ways pay close attention to trafficin front.
0+'-
Driving your vehicle
7-66

IF THE ENGINE WILL NOT START
If engine doesn't turn over or
turns over slowly
1. Be sure the shift lever is in N (Neu‐tral) or P (Park) and the emergency
brake is set.
2. Check the battery connections to be sure they are clean and tight.
3. Turn on the interior light. If the light dims or goes out when you
operate the starter, the battery is
discharged.
4. Check the starter connections to be sure they are securely tightened.
5. Do not push or pull the vehicle to start it. See instructions for L

2. Place the transaxle shift lever in N(Neutral).
3. Release the parking brake.
CAUTION
Failure to place the transaxle shiftlever in N (Neutral) may cause inter‐nal damage to the transaxle.
Removable towing hook (if
equipped)
1. Open the trunk, and remove the towing hook from the tool case. 2. Remove the hole cover pressing the
lower part of the cover on the
bumper.
3. Install the towing hook by turning it clockwise into the hole until it is
fully secured.
4. Remove the towing hook and install the cover after use.
Emergency towing
'SPOU
3FBS
What to do in an emergency
8-22

If towing is necessary, we recommendyou to have it done by an authorizedKia dealer or a commercial tow truckservice.
If towing service is not available in an
emergency, your vehicle may be tem‐ porarily towed using a cable or chain
secured to the emergency towing hook
under the front (or rear) of the vehicle. Use extreme caution when towing the
vehicle. A driver must be in the vehicle
to steer it and operate the brakes.
Towing in this manner may be done on‐ ly on hard-surfaced roads for a short
distance and at low speed. Also, the
wheels, axles, power train, steering and brakes must all be in good condition. • Do not use the tow hooks to pull a vehicle out of mud, sand or other
conditions from which the vehicle
cannot be driven out under its own
power.
• Avoid towing a vehicle heavier than the vehicle doing the towing.
• The drivers of both vehicles should communicate with each other fre‐
quently.
CAUTION
•Attach a towing strap to the towhook.
•Using a portion of the vehicle oth‐er than the tow hooks for towingmay damage the body of your ve‐hicle.
•Use only a cable or chain specifi‐cally intended for use in towingvehicles. Securely fasten the cableor chain to the towing hook provi‐ded.
• Before emergency towing, check if the hook is not broken or damaged.
• Fasten the towing cable or chain se‐ curely to the hook.
• Do not jerk the hook. Apply it steadily and with even force.
• To avoid damaging the hook, do not pull from the side or at a vertical an‐
gle. Always pull straight ahead.
WARNING
Use extreme caution when towingthe vehicle.•Avoid sudden starts or erratic driv‐ing maneuvers which would placeexcessive stress on the emergencytowing hook and towing cable orchain. The hook and towing cableor chain may break and cause seri‐ous injury or damage.
•If the disabled vehicle is unable tobe moved, do not forcibly continuethe towing. We recommend thatyou contact an authorized Kiadealer or a commercial tow truckservice for assistance.
•Tow the vehicle as straight aheadas possible.
•Keep away from the vehicle duringtowing.

8-23
8
What to do in an emergency

PARKING BRAKE (IF EQUIPPED)
Checking the parking brake
0+'
Check whether the stroke is within
specification when the parking brake pedal is depressed with 30 kg (66 lb,
294N) of force. Also, the parking brake
alone should securely hold the vehicle on a fairly steep grade. If the stroke is
more or less than specified, we recom‐
mend that the system be serviced by an authorized Kia dealer.
Stroke : 6~7 notch
Maintenance
9-32