light KIA OPTIMA PLUG-IN HYBRID 2017 Repair Manual

This indicator light blinks:
• When the battery of the smart key is weak.- At this time, you can not start the engine. However, you can start the
engine if you press the Engine
Start/Stop Button with the smart
key. (For more details, refer to
L

When the ready indicator goes OFF or
blinks, there is a problem with the sys‐ tem. In this case, we recommend that
you have your vehicle inspected by an
authorized Kia dealer.
Cruise indicator light (if
equipped)
This indicator light illumi‐nates:
• When the cruise control system is enabled.
For more details, refer to L

SPORT mode indicator
light (if equipped)
This indicator light illumi‐nates:
• When you select L

• Inclined roads
• A vehicle loaded with longer or widercargo compared to the vehicle
• Diagonal parking space
• Heavy snow or rain
• Near a circular pillar or narrow pillar, or a pillar surrounded by objects suchas fire extinguisher, etc.
• The sensor is positioned incorrectly by an impact to the bumper
• Bumpy roads
• A vehicle equipped with a snow chain or spare tire
• Tire pressure lower or higher than the standard tire pressure
• A trailer connected to the vehicle
• Slippery or uneven road
• Big vehicles such as buses or trucks parked
• Sensor covered with foreign matter, such as snow or water
• Moisture frozen on the sensor
• A motorcycle or bicycle parked
• A obstacle such as a trash can, bicy‐ cle, shopping cart, etc. is near
• Heavy wind • Wheel changed to an unauthorized
size
• A problem with the wheel alignment
• An accessory installed on the detec‐ tive area the of sensors (such as
number plate holder)
• Vehicle leaned severely to one side
• Strong sunlight or very cold weather
• Ultrasonic interference from other vehicle's. Such as horn sounds of oth‐
er vehicles, motorcycle's engine noise,
air brake noise of heavy vehicles and
with the other vehicle's parking assist
system working.
WARNING
Do not use the Smart Parking AssistSystem in the following conditionsfor unexpected results may occurand cause a serious accident.
(Continued)
(Continued)
0+'-
1.Parking on inclinesThe driver must apply the accel‐erator and brake pedal whenparking on inclines. If the driveris unfamiliar with applying theaccelerator and brake pedal, avehicle accident may occur.
(Continued)

5-97
5
Features of your vehicle

0+'-
When the Smart Parking Assist System
is operating, a message may appear re‐ gardless of the parking order.
The messages will appear according to
the circumstances. Follow the instruc‐
tions provided while parking your vehi‐ cle with the Smart Parking Assist Sys‐
tem.
NOTICE
•In the below conditions the system
will be cancelled. Park your vehicle
manually.
(Continued)
(Continued)
-When the ABS is activated
-When the TCS/ESC is turned off
•When vehicle speed is above
20 km/h while searching for a
parking space a message "Reduce
speed" will appear.
•In the below condition the system
will not activate
-When the TCS/ESC is turned off
System malfunction
0+'-
• If there is a problem with the system, when the system is turned on, the
above message will appear. Also, the indicator on the button will not light
up and a beep sound will be heard 3
times.
• If there is a problem with only the Smart Parking Assist System, the
Parking Assist System will operate after 2 seconds.
If you notice any problem, we recom‐
mend to have the system checked by
an authorized Kia dealer.
How the system works (Exit
mode)
The Exit Mode operates in the below
condition: • When vehicle speed is below 5 km/h the first time after the engine has
been started.
• After parallel parking is completed with the Smart Parking Assist Sys‐
tem.
1. Activate the Smart Parking Assist System
The shift lever should be placed in P
(Park) or N (Neutral).
2. Select Exit Mode
Features of your vehicle
5-106

System malfunction
0+'-
• If there is a problem with the system,when the system is turned on, the
above message will appear.
Also, the indicator on the button will not light up and a beep sound will be
heard 3 times.
• If there is a problem with only the Smart Parking Assist System, the
Parking Assist System will operate
after 2 seconds.
If you notice any problem, we recom‐
mend that the system be checked by
an authorized Kia dealer.
CAUTION
The system may not work properlyby providing incorrect messageswhen the sensors are interfered byother vehicle sensors and noise, or itis on a road that interferes with re‐ceiving signals.

5-111
5
Features of your vehicle

REARVIEW CAMERA (IF EQUIPPED)
0+')
The rearview camera will activate when
the back-up light is ON with the ignition switch ON and the shift lever in the R
(Reverse) position. This system is a supplemental system
that shows behind the vehicle through the rearview display mirror while back‐
ing up.
WARNING
•This system is a supplementaryfunction only. It is the responsibili‐ty of the driver to always checkthe inside/outside rearview mirrorand the area behind the vehiclebefore and while backing up be‐cause there is a dead zone thatcan't be seen by the camera.
•Always keep the camera lensclean. If the lens is covered withforeign matter, the camera maynot operate normally.
❈ If your vehicle is equipped with AVN
(Audio, Video and Navigation) sys‐
tem, rearview display will show be‐
hind the vehicle through the AVN
monitor while backing up. Refer to
a separately supplied manual for
detailed information.
Features of your vehicle
5-112

LIGHTING
Battery saver function
• The purpose of this feature is to pre‐vent the battery from being dis‐
charged. The system automatically
turns off the parking lights when the driver removes the ignition key and
opens the driver-side door.
• With this feature, the parking lights will turn off automatically if the driv‐
er parks on the side of the road at
night.
If necessary, to keep the lights on when the ignition key is removed,
perform the following: 1. Open the driver-side door.
2. Turn the parking lights OFF and ON again using the light switch on the
steering column.
CAUTION
If the driver gets out of the vehiclethrough other doors (except driver'sdoor), the battery saver functiondoes not operate. Therefore, It cau‐ses the battery to be discharged. Inthis case, make sure to turn off thelamp before getting out of the vehi‐cle.
Headlight escort function (if
equipped)
If you turn the ignition switch to the
ACC or OFF position with the headlights ON, the headlights remain on for about
5 minutes. However, if the driver's door
is opened and closed, the headlights are turned off after 15 seconds.
The headlights can be turned off by
pressing the lock button on the trans‐
mitter (or smart key) twice or turning the light switch to the OFF position.
Daytime running light (if
equipped)
The Daytime Running Lights (DRL) can
make it easier for others to see the front of your vehicle during the day.
DRL can be helpful in many different
driving conditions, and it is especially helpful after dawn and before sunset.
The DRL system will turn the dedicated
lamp OFF when: 1. The headlight or fog lamp switch is ON.
2. The engine is OFF.
❈
Traffic Change (For Europe)
The low beam light distribution is
asymmetric. If you go abroad to a
country with opposite traffic direc‐ tion, this asymmetric part will daz‐
zle oncoming car driver. To prevent
dazzle, ECE regulation demand sev‐
eral technical solutions (ex. auto‐ matic change system, adhesive
sheet, down aiming). This head‐
lamps are designed to adjust in
user setting mode in cluster.
Lighting control
The light switch has a Headlight and a
Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions: 1. OFF position
2. Auto light / AFLS position
Features of your vehicle
5-114

3. Parking light position
4. Headlight position
Parking light position ()
When the light switch is in the parking
light position (3rd position), the tail, li‐ cense and instrument panel lights will
turn ON.
Headlight position ()
When the light switch is in the head‐
light position (4th position), the head, tail, license and instrument panel lights
will turn ON.
NOTICE
The ignition switch must be in the
ON position to turn on the head‐
lights.
Auto light/AFLS position (if
equipped)
When the light switch is in the AUTO
light position, the tail lights and head‐ lights will be turned ON or OFF auto‐
matically depending on the amount of
light outside the vehicle.
If your vehicle is equipped with the adaptive front lighting system (AFLS),
it will also operate when the headlamp
is ON.

5-115
5
Features of your vehicle

CAUTION
•Never place anything over the sen‐sor (1) located on the instrumentpanel. This will ensure better au‐to-light system control.
•Don’t clean the sensor using a win‐dow cleaner. The cleaner mayleave a light film which could inter‐fere with sensor operation.
•If your vehicle has window tint orother types of metallic coating onthe front windshield, the Autolight system may not work prop‐erly.
High beam operation
To turn on the high beam headlamp,
push the lever away from you. The lev‐ er will return to its original position.
The high beam indicator will light when
the headlight high beams are switched
on.
To prevent the battery from being dis‐ charged, do not leave the lights on for a
prolonged time while the engine is not
running.
WARNING
Do not use high beam when thereare other vehicles. Using high beamcould obstruct the other driver’s vi‐sion.
To flash the headlights, pull the lever
towards you. It will return to the nor‐ mal (low beam) position when released.
The headlight switch does not need to
be on to use this flashing feature.
Features of your vehicle
5-116