battery KIA Rio 2005 2.G User Guide

4. Turn off all unnecessary electrical loads.
5. Connect the jumper cables in the exact sequence
shown in the illustration on the previous page.
First, connect one end of a jumper cable to the
positive terminal (+) of the discharged battery ,
then the other end of the same cable to the positive
terminal (+) on the booster battery . Next,
connect one end of the other jumper cable to the
negative terminal (–) of the booster battery , then
the other end to a solid, stationary, metallic point
(for example, the engine lifting bracket) away
from the battery. Do not connect the jumper cable
to or near any part that moves when the engine is
cranked. Do not connect the jumper cable from the
negative terminal (–) of the booster battery to the
negative terminal (–) of the discharged battery. Do
not allow the jumper cables to contact anything
except the correct battery terminals or the correct
ground. Do not lean over the battery when making
connections.6. Start the engine of the vehicle with the booster
battery and run it at 2,000 rpm. Then, start the
engine of the vehicle with the discharged battery.
If the cause of your battery discharging is not apparent
(for example, having left the lights on accidentally),
you should have your vehicle checked by an Authorized
Kia Dealer.
Push-StartingA vehicle equipped with an automatic transaxle cannot
be started by pushing. A vehicle equipped with a
manual transaxle should not be push-started because it
could damage the emission control system. Follow the
directions for jump starting.
In Case Of An Emergency6-6
CAUTION
Never tow a vehicle to start it. A sudden surge
forward when the engine starts could cause a
collision with the tow vehicle.
1
2
3
4
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 6

Electrical Circuit ProtectionFusesA vehicle’s electrical system is protected from
electrical overload damage by fuses.
This vehicle has two fuse panels, one located in the
driver’s side kick panel, the other in the engine
compartment near the battery. A fuse panel chart is
provided later in this section.
If any of your vehicle’s lights, accessories, or controls
do not work, check the appropriate circuit fuse. If a
fuse has blown, the element inside the fuse will be
melted.
Always replace a blown fuse with one of the same
rating.
If the replacement fuse blows out, this indicates an
electrical problem. Avoid using the system involved
and immediately consult an Authorized Kia Dealer.
Two kinds of fuses are used: standard for lower
amperage rating, and main for higher amperage
ratings.
6-7
Standard
Normal
NormalBlown
Blown Main fuse
AS2B06003
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 7

6-11
Engine compartment
DESCRIPTION FUSE PROTECTED
RATING COMPONENT
Engine Compartment
(ABS) 15A ABS
RR FOG 10A Rear fog light (if equipped)
(F/FOG) 15A Front fog light (if equipped)
MAIN 80A Battery is not rechargeable
IG 1 30A (It will be automatically connect
ed to the secondary fuse.) CIGAR
10A, AUDIO 10A, IG COIL 15A,
TURN LAMP 10A, A/BAG 10A,
WIPER(RR) 15A, WIPER(FRT)
15A, RELAY 10A, START 10A
BLOWER 30A Heater
COOLING 30A Cooling fan
(ABS 1) 30A ABS
COND. FAN 20A Condenser fan
HEAD-HI 15A Head lamp high
HEAD-LOW 15A Head lamp low
EMS 10A Engine sensors
INJECTOR 15A Injector, 0
2sensor
F/PUMP 10A Fuel pump
ECU 10A Engine control unit, ECAT unit,
Main relay
RELAY 10A Blower motor, Power window,
Rear window defroster, Head
lamp(Airbag equipped vehicle)
(HLLD) 10A
-
*( ):Optional
STARTWINDOW
POWERFUEL
PUMPFRONT
FOGA/CON
HEAD
LAMPCOOL.FANHORN
TNS MAIN
IG 1 BLOWER
COOL ING(ABS 1) IG 2 COND.F
( )( ) ( )
( )
( )
COND.FAN
ROOM 15A
IG COIL
(ABS)
D/LOCK
BTN
P/WIN
(ABS 2)
RR DEF
HORN
TNS
RR FOG
(HLLD)(F/FOG)
HEAD
S/ROOF
MAIN
RELAY
RELAY
ECU
F/PUMP
INJECT
EMS
HEAD
LOW
HEAD
HI 15A
15A
25A
30A
30A
30A
25A
10A
15A
10A
10A
80A15A
25A
15A
25A
10A
10A
10A
15A
10A
15A
15A
MAIN
30A 30A 30A 30A 30A 20A
* USE THE DESIGNATED FUSE AND RELAY ONLY.
* REFER TO OWNER'S MANUAL FOR FUSE AND RELAY SERVICE.
* ( ) : OPTION
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 11

6-13 Memory Fuse (If Equipped)
Your vehicle is equipped with a “Memory Fuse” to
prevent battery discharge if the vehicle is parked for
prolonged periods without being operated. Use the
following procedures before parking the vehicle for a
prolonged period.
1. Turn off the engine.
2. Turn off the headlights and tail lights.
3. Open the main fuse box cover in the engine compartment
and pull up the “ROOM FUSE 15A” using the fuse
puller; push the fuse to the side. This will change the
MEMORY FUSE mode to prevent battery discharge.
FUEL
PUMPFRONT
FOGA/CON
HEAD
LAMPCOOL.FANHORN
TNS MAIN
COND.F( ) ( )
( )
( )
COND.FAN
ROOM 15A
IG COIL
(ABS)(F/FOG)
HEAD 15A
15A15A
25A
20A
* REFER TO OWNER'S MANUAL FOR FUSE AND RELAY SERVICE.
* ( ) : OPTION
RIOMEMORY
CAUTION
•If the memory fuse is pulled up from the fuse
box housing, the radio and dome light will not
operate. After reinstalling the “Memory Fuse”,
the radio “anti-theft”code (Optional) must be
entered again and the preset radio stations
must be reselected.
Even though the memory fuse is pulled up, the
battery can still be discharged by operation of
the headlights or other electrical devices.
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 13

7-1
MAINTENANCEMaintenance Services . . . . . . . . . . . . . . . . . . . . . . . . .7-3
Maintenance Schedule . . . . . . . . . . . . . . . . . . . . . . . .7-5
Owner Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . .7-10
Engine Compartment . . . . . . . . . . . . . . . . . . . . . . . . .7-13
Engine Oil and Oil Filter . . . . . . . . . . . . . . . . . . . . . . .7-14
Engine Cooling System . . . . . . . . . . . . . . . . . . . . . . .7-16
Brakes and Clutch . . . . . . . . . . . . . . . . . . . . . . . . . . .7-20
Parking Brake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-21
Power Steering . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-22
Automatic Transaxle . . . . . . . . . . . . . . . . . . . . . . . . . .7-23
Lubricants and Fluids . . . . . . . . . . . . . . . . . . . . . . . . .7-26
Air Cleaner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-27
Wiper Blades . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-28
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-31
Tires and Wheels . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-34
Bulb Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . .7-42
Lubricant Specifications . . . . . . . . . . . . . . . . . . . . . . .7-47
7
RIO ENG CNA 7-1.qxd 7/29/05 5:16 PM Page 1

Engine Compartment
7-13
Engine coolant reservoir Radiator cap Engine oil fill capAir cleanerAuto transaxle fluid
dipstick (if equipped)Brake/clutch
fluid reservoir
Engine oil dipstick Windshield
washer
fluid
reservoir Power steering
fluid reservoir
(if equipped)Fuse box
Battery
2FDA604
RIO ENG CNA 7-1.qxd 7/29/05 5:16 PM Page 13

Battery
7-31
WARNING - Battery dangers
Always read the following instructions
carefully when handling a battery.
Keep lighted cigarettes and all other
flames or sparks away from the
battery.
Hydrogen, which is a highly
combustible gas, is always present in
battery cells and may explode if
ignited.
Keep batteries out of the reach of
children because batteries contain
highly corrosive SULFURIC ACID.
Do not allow battery acid to contact
your skin, eyes, clothing or paint finish.
Wear eye protection when charging or
working near a battery. Always provide
ventilation when working in an
enclosed space.
(Continued)
(Continued)
If any electrolyte gets into your eyes,
flush your eyes with clean water for at
least 15 minutes and get immediate
medical attention. If possible, continue
to apply water with a sponge or cloth
until medical attention is received.
If electrolyte gets on your skin,
thoroughly wash the contacted area. If
you feel a pain or a burning sensation,
get medical attention immediately.
• When lifting a plastic-cased battery,
excessive pressure on the case may cause
battery acid to leak, resulting in personal
injury. Lift with a battery carrier or with
your hands on opposite corners.
 Never attempt to charge the battery when
the battery cables are connected.
 The electrical ignition system works with
high voltage. Never touch these components
with the engine running or the ignition
switched on.
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 31

Battery MaintenanceFor best battery service:
 Keep the battery securely mounted.
 Keep the battery top clean and dry.
 Keep the terminals and connections clean, tight, and
coated with petroleum jelly or terminal grease.
 Immediately rinse any spilled electrolyte from the
battery with a solution of water and baking soda.
 If the vehicle is not going to be used for an extended
period of time, disconnect the battery cables.Maintenance7-32Battery Recharging
Your vehicle has a maintenance-free, calcium-based
battery.
 If the battery becomes discharged in a short time
(headlights or interior lights were left on while the
vehicle was not in use), recharge it by slow (trickle)
charging for 10 hours.
 If the battery gradually discharges because of high
electric load while the vehicle is being used,
recharge it at 20-30A for two hours.
AS2B07020
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 32

7-33
WARNING - Recharging Battery
When recharging the battery, observe the
following precautions:
 The battery must be removed from the
vehicle and placed in an area with good
ventilation.
 Do not allow cigarettes, sparks, or flame
near the battery.
 Watch the battery during charging, and stop
or reduce the charging rate if the battery
cells begin gasing (boiling) violently or if the
temperature of the electrolyte of any cell
exceeds 49°C (120°F).
 Wear eye protection when checking the
battery during charging.
(Continued)
(Continued)
 Disconnect the battery charger in the
following order.
1. Turn off the battery charger main switch.
2. Unhook the negative clamp from the
negative battery terminal.
3. Unhook the positive clamp from the
positive battery terminal.✻ ✻
NOTICE
 Before performing battery maintenance or
recharging, turn OFF all accessories and stop
the engine.
 When remounted battery, disconnect the
negative (–) battery cable first. When re-
installing the battery, reconnect the negative (–)
battery cable last.
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 33

CAPACITIES
M/T: Manual Transaxle
A/T: Automatic Transaxle ENGINE
ELECTRICAL SYSTEM
Specifications8-4
Item
Borex Stroke1.6 DOHC
Displacement 1594 cc (97.2 cu. in.)
Compression Ratio
10.0:1 78 mmx 83.4 mm
(3.07 in.x 3.28 in.)
Item liter/US qt.
Item 1.6 DOHC
Battery
Alternator 12V-80 Amp
StarterM/T 12V-0.85 kw12 volt MF
60 AH
A/T 12V-0.85 kw
Spark
plugsGap1.0-1.1 mm
(0.028-0.032 in.)TypeBKR6ES-II (NGK)
RC8YC4 (CHAMPION)
Engine Oil w/Filter 3.4/3.59
Engine Oil w/o Filter 3.2/3.38Coolant 2.6+/0.38+
liter/US gal.
Fuel Tank 45/11.7Transaxle OilM/T
A/T2.8/2.9
5.9/6.2
RIO ENG CNA 8.qxd 7/29/05 5:19 PM Page 8-4