tow KIA Rio 2005 2.G Owner's Guide
[x] Cancel search | Manufacturer: KIA, Model Year: 2005, Model line: Rio, Model: KIA Rio 2005 2.GPages: 238, PDF Size: 2.6 MB
Page 189 of 238

Checking the Coolant Level
Check the condition and connections of all cooling
system hoses and heater hoses. Replace any swollen or
deteriorated hoses.
The coolant level should be full in the radiator
and between F (Full) and L (Low) on the coolant
reservoir dipstick when the engine is cool.
Check the coolant level using the dipstick attached to
the reservoir cap.
7-17
WARNING -Removing
Radiator Cap
Never attempt to remove the radiator cap
while the engine is operating. Doing so
might lead to cooling system and/or engine
damage and could result in serious personal
injury from escaping hot coolant or steam.
Turn the engine off and wait until it has
cooled. Even then, use extreme care when
removing the radiator cap. Wrap a thick
towel around it, and turn it
counterclockwise slowly to the first stop.
Step back while the pressure is released
from the cooling system. When you are sure
all the pressure has been released, press
down on the cap, using a thick towel, and
continue turning counterclockwise to
remove it.
Even if the engine is not operating, do not
remove the radiator cap or the drain plug
while the engine and radiator are hot. Hot
coolant and steam may still blow out under
pressure, causing serious injury.
AS2B07003
Coolant reservoir dipstickLow OK Full
RIO ENG CNA 7-1.qxd 7/29/05 5:16 PM Page 17
Page 201 of 238

1. Raise the wiper arm and turn the wiper blade
assembly to expose the plastic locking clip.
Compress the clip and slide the blade assembly
toward the windshield, then slide it off the arm.
7-29
2. Firmly grasp the end of the rubber blade and pull
until the tabs are free of the metal support.
✻ ✻
NOTICE
Do not allow the wiper arm to fall against the
windshield.
AN7B07016AN7B07017
Plastic locking
clip Push
Metal support
TabsPull out
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 29
Page 202 of 238

3. Remove the metal retainers from the rubber blade
and install them in the new rubber blade.Maintenance7-30
4. Carefully insert a new rubber blade and re-install
the blade assembly in the reverse order of removal.
Install the blade with the tabs facing towards the
bottom of the wiper arm.
✻ ✻
NOTICE
Do not bend the metal retainers.
AN7B07018 AN7B07019
Retainer
Retainer
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 30
Page 232 of 238

Interior Care ....................................................................7-52
Interior Features ..............................................................4-40
Interior Lights .................................................................3-65K
eyless Entry System......................................................3-3
Keys ..................................................................................3-2
Label Information ..........................................................5-13
Lighting ...........................................................................4-33
Lubricant Specifications .................................................7-47
Lubricants and Fluids......................................................7-26
Luggage Net ....................................................................3-68M
aintenance Schedule ...................................................7-5
Maintenance Services .......................................................7-3
Manual Transaxle ..............................................................4-7
Mirrors ............................................................................3-62
O
verheating .....................................................................6-2
Overloading.....................................................................5-13
Owner Maintenance ........................................................7-10
Parking Brake ................................................................7-21
Power Outlet ...................................................................3-70
Power Steering.......................................................4-22, 7-22
R
ear Hatch .....................................................................3-54
Rear Window Defroster ..................................................4-38
Road Warning ...................................................................6-2
Roof Rack .......................................................................3-69
Safety Belts ....................................................................3-20
Seats ................................................................................3-11
Special Driving Conditions...............................................5-7
Specifications ................................................................... 8-2
Starting the Engine............................................................4-4
Steering Wheel ................................................................3-62
Suggestions for Economical Operation ............................5-6
Sunglass Holder ..............................................................3-67Tilt Steering ...................................................................4-22
Tires and Wheels.............................................................7-34
Tonneau Cover ................................................................3-71
Towing ............................................................................6-14
Trailer Towing.................................................................5-12
Trunk Lid ........................................................................3-55V
ehicle Break-In Process ................................................1-3
W
arnings and Indicators ...............................................4-27
Windows ...........................................................................3-8
Index9-2
RIO ENG CNA 9.qxd 7/29/05 5:19 PM Page 9-2