remove seats Lancia Delta 2015 Owner handbook (in English)

SAFETY181
2
With ignition key inserted, at MAR, even if
the engine is off, the airbags can activate al-
so with the car stopped, if it is hit by anoth-
er vehicle. Therefore, even if the car is stationary,
when an active passenger airbag is fitted, DO NOT
install rear facing child restraint systems on the
front passenger seat. Deployment of the airbag fol-
lowing an impact could cause fatal injuries to the
child. Therefore, always deactivate the passenger
airbag when a rear facing child restraint system
is installed on the front passenger seat. The front
passenger seat must also be positioned back as far
as possible in order to avoid the child restraint sys-
tem from coming into contact with the dashboard.
Immediately reactivate the passenger airbag as soon
as the child restraint system has been removed. Al-
so remember that, if the key is turned to STOP, none
of the safety devices (airbags or pretensioners) will
be deployed in the event of collision. Non-deploy-
ment in such cases does not indicate a system mal-
function.When the ignition key is turned to MAR, the
“ warning light turns on and blinks for a few
seconds to remind you that the passenger
airbag will activate in the event of a collision. Then
it should turn off.
Do not wash the seats with water or pres-
surised steam (by hand or at automatic car
seat washing stations).
The front airbags deploy in the event of more
severe collisions than those required for de-
ploying the pretensioners. For impacts in the
range between the two activation thresholds, pre-
tensioner activation alone is normal.
Do not hook rigid objects to clothes hangers
and support handles.
The airbag does not replace seat belts; it in-
creases their effectiveness. Furthermore, since
front airbags are not deployed in low speed
collisions, side collisions, rear-end shunts or roll-
overs, the passengers are only protected by the seat
belts which must be fastened at all times.
155-182 Delta GB 1ed 26/08/13 11.29 Pagina 181

STARTING AND DRIVING187
3
HANDBRAKE
The handbrake lever is located between the front seats.
Pull the lever upwards to operate the handbrake, until the
car is braked.
The car should be braked after a few clicks
of the lever; if it is not, contact a Lancia Deal-
ership to have it adjusted.
When the handbrake is on and the ignition key is at MAR,
the instrument panel xwarning light will come on.
Proceed as follows to release the handbrake:
❍ slightly lift the lever and press release button A - fig. 1;
❍ keep button A pressed and lower the lever. The x
warning light on the instrument panel turns off.
Press the brake pedal when carrying out this operation
to prevent the car from moving accidentally.
PARKING
Proceed as follows:
❍ stop the engine and engage the handbrake;
❍ engage a gear (on a slope, engage first gear if the car
is facing uphill or reverse if it is facing downhill) and
leave the wheels steered.
Block the wheels with a wedge or a stone if the car is
parked on a steep slope.
Do not leave the ignition key on MAR to avoid draining
the battery. Always remove the key when you leave the
car.
Never leave children unattended in the car. Always remove
the ignition key when leaving the car and take it out with
you.
fig. 1L0E0072m
183-194 Delta GB 1ed 26/08/13 12.15 Pagina 187

256MAINTENANCE AND CARE
INTERIORS
Periodically check that water is not trapped under the mats
(due to water dripping off shoes, umbrellas, etc.) which
could cause oxidisation of the sheet metal.
Never use flammable products, such as
petrol ether or rectified petrol to clean the
inside of the car. The electrostatic charges
which are generated by rubbing during cleaning
may cause a fire.
Do not keep aerosol cans in the vehicle: these
could explode. Aerosol cans must not be ex-
posed to temperatures exceeding 50°C. When
the vehicle is exposed to sunlight, the temperature
inside can greatly exceed this value.
SEATS AND FABRIC PARTS
Remove dust with a soft brush or a vacuum cleaner. It is
advisable to use a moist brush on velvet upholstery.
Rub the seats with a sponge moistened with a solution of
water and neutral detergent.
PLASTIC PARTS
It is advisable to clean interior parts with a moist cloth and
a solution of water and non-abrasive mild soap. Use spe-
cific products for cleaning plastic, without solvents and
specifically designed to prevent damage to the appearance
and colour of the treated parts, to remove grease and tough
stains.
IMPORTANT Do not use alcohol, petrols or derivatives to
clean the instrument panel lens.
233-256 Delta GB 1ed 03/04/14 13:28 Pagina 256