ABS Lancia Flavia 2012 Owner handbook (in English)
[x] Cancel search | Manufacturer: LANCIA, Model Year: 2012, Model line: Flavia, Model: Lancia Flavia 2012Pages: 233, PDF Size: 2.61 MB
Page 194 of 233

The A/C Air Filter is located in the
fresh air inlet behind the glove box.
Perform the following procedure to
replace the filter:
1. Open the glove box and remove all
contents.
2. Push in on the sides of the glove
box and lower the door.
3. Disconnect the glove box door
dampener from the slot on the side of
the box. This is done by grasping the
dampener connector (on the outside
of the box) and the end of the connec-
tor pin (on the inside of the box) with
your thumb and forefinger and pull-
ing outward while lightly lifting up-
ward on the door with your other
hand. Once disconnected, the damp-
ener will retract underneath the in-
strument panel if you release it.
4. Pivot the glove box downward.
5. Disengage the two retaining tabs
that secure the filter cover to the
HVAC housing and remove the cover.6. Remove the A/C Air Filter by pull-
ing it straight out of the housing.
7. Install the A/C Air Filter with the
arrow on the filter pointing toward
the floor. When installing the filter
cover, make sure the retaining tabs
fully engage the cover.
CAUTION!
The A/C Air Filter is identified with
an arrow to indicate airflow direc-
tion through the filter. Failure to in-
stall the filter properly will result in
the need to replace it more often.
8. Reinstall the glove box door damp-
ener and glove box. BODY LUBRICATION
Locks and all body pivot points, in-
cluding such items as seat tracks, door
hinge pivot points and rollers, and
hood hinges, should be lubricated pe-
riodically with a lithium based grease
to assure quiet, easy operation and to
protect against rust and wear. Prior to
the application of any lubricant, the
parts concerned should be wiped
clean to remove dust and grit; after
lubricating excess oil and grease
should be removed. Particular atten-
tion should also be given to hood
latching components to ensure proper
function. When performing other un-
derhood services, the hood latch, re-
lease mechanism and safety catch
should be cleaned and lubricated.
The external lock cylinders should be
lubricated twice a year, preferably in
the Fall and Spring. Apply a small
amount of a high quality lubricant
directly into the lock cylinder.
A/C Air Filter Replacement
187
Page 201 of 233

Master Cylinder – Brake Fluid
Level Check
Check the fluid level in the master
cylinder immediately if the brake sys-
tem warning light indicates system
failure.
Check the fluid level in the master
cylinder when performing underhood
services.
Clean the top of the master cylinder
area before removing the cap. If nec-
essary, add fluid to bring the fluid
level up to the requirements described
on the brake fluid reservoir.
Overfilling of fluid is not recom-
mended because it may cause leaking
in the system.
Fluid level can be expected to fall as
the brake pads wear. Brake fluid level
should be checked when pads are re-
placed. However, low fluid level may
be caused by a leak and a checkup
may be needed.
Use only manufacturer's recom-
mended brake fluid. Refer to “Fluids,
Lubricants, and Genuine Parts” in
“Maintaining Your Vehicle” for fur-
ther information.
WARNING!
Use the manufacturer’s recom- mended brake fluid or a quality-
equivalent product. Refer to “Flu-
ids, Lubricants, and Genuine
Parts” in “Maintaining Your Ve-
hicle” for further information. Us-
ing the wrong type of brake fluid
can severely damage your brake
system and/or impair its perfor-
mance.
To avoid contamination from for-
eign matter or moisture, use only
new brake fluid or fluid that has
been in a tightly closed container.
Keep the master cylinder reservoir
cap secured at all times. Brake
fluid in a open container absorbs
moisture from the air resulting in
a lower boiling point. This may
cause it to boil unexpectedly dur-
ing hard or prolonged braking,
resulting in sudden brake failure.
This could result in a collision.
(Continued)
WARNING!(Continued)
Overfilling the brake fluid reser-
voir can result in spilling brake
fluid on hot engine parts, causing
the brake fluid to catch fire. Brake
fluid can also damage painted and
vinyl surfaces, care should be
taken to avoid its contact with
these surfaces.
Do not allow petroleum based
fluid to contaminate the brake
fluid. Brake seal components
could be damaged, causing partial
or complete brake failure. This
could result in a collision.
AUTOMATIC
TRANSMISSION
The automatic transmission and dif-
ferential assembly are contained
within a single housing.
The fluid level in the automatic trans-
mission should be checked whenever
the vehicle is serviced. Operation with
an improper fluid level will greatly
reduce the life of the transmission and
the fluid.
194
Page 209 of 233

CavityCartridge Fuse Mini Fuse Description
31 —10 Amp RedHeadlamp Washer (for versions/markets,
where provided)
32 30 Amp Pink —Auto Shutdown (ASD) Relay 1
33 —10 Amp RedSwitch Bank/Diagnostic Link Connector/
Powertrain Control Module (PCM)
34 30 Amp Pink —Anti-Lock Brakes (ABS) Module (for
versions/markets, where provided)/
Electronic Stability Control (ESC) Module
(for versions/markets, where provided)
35 40 Amp Green —Anti-Lock Brakes (ABS) Module (for
versions/markets, where provided)/
Electronic Stability Control (ESC) Module
(for versions/markets, where provided)
36 30 Amp Pink —Passenger Door Module (PDM)/Driver Door
Module (DDM)
37 —25 Amp Natural Power Top Module (for versions/markets,
where provided)
CAUTION!
When installing the Integrated
Power Module cover, it is impor-
tant to ensure the cover is properly
positioned and fully latched. Fail-
ure to do so may allow water to get
into the Integrated Power Module,
and possibly result in an electrical
system failure.
(Continued)
CAUTION!(Continued)
When replacing a blown fuse, it is
important to use only a fuse hav-
ing the correct amperage rating.
The use of a fuse with a rating
other than indicated may result in
a dangerous electrical system
overload. If a properly rated fuse
continues to blow, it indicates a
problem in the circuit that must
be corrected.
202
Page 223 of 233

About Your Brakes . . . . . . . . . 145
ABS
(Anti-Lock Brake System) . . . 146
Adding Engine Coolant
(Antifreeze) . . . . . . . . . . . . . . 191
Adding Washer Fluid . . . . . . . 188
Additives, Fuel . . . . . . . . . . . 160
Air Cleaner, Engine
(Engine Air Cleaner Filter) . . . 184
Air Conditioner
Maintenance . . . . . . . . . . . . . 186
Air Conditioning Filter . . . 128,186
Air Conditioning Refrigerant . . 186
Air Conditioning
System . . . . . . . . . . . . . . 124,186
Air Conditioning, Operating
Tips . . . . . . . . . . . . . . . . . . . 129
Air Pressure, Tires . . . . . . . . . 151
Airbag . . . . . . . . . . . . . . . . . . 30
Airbag Deployment . . . . . . . . . 34
Airbag Light . . . . 32,33,36,46,108
Airbag Maintenance . . . . . . . . . 35
Airbag, Side . . . . . . . . . . 31,32,33
Airbag, Window
(Side Curtain) . . . . . . . . . . . . . 32
Alarm (Security Alarm) . . . . . . 14
Alarm System
(Security Alarm) . . . . . . . . 14,112Alterations/Modifications,
Vehicle . . . . . . . . . . . . . . . . . . . 7
Anti-Lock Brake System
(ABS) . . . . . . . . . . . . . . . . . . 146
Anti-Lock Warning Light . . . . 146
Anti-Theft Security Alarm
(Theft Alarm) . . . . . . . . . . . . . 14
Antifreeze
(Engine Coolant) . . . . . . . 191,206
Disposal . . . . . . . . . . . . . . 192
Appearance Care . . . . . . . . . . 196
Ashtray . . . . . . . . . . . . . . . . . 100
Auto Down Power Windows . . . 19
Auto Unlock, Doors . . . . . . . . . 18
Automatic Door Locks . . . . . . . 18
Automatic Headlights . . . . . . . 91
Automatic Oil Change
Indicator . . . . . . . . . . . . 110,117
Automatic Temperature
Control (ATC) . . . . . . . . . . . . 124
Automatic Transaxle . . . . . 12,134 Adding Fluid . . . . . . . . . . . 207
Selection Of Lubricant . . . . 207
Automatic Transmission . . 135,194 Adding Fluid . . . . . . . . . . . 195
Fluid and Filter Changes . . . 195
Fluid Level Check . . . . . . . 195
Fluid Type . . . . . . . . . . . . . 195
Gear Ranges . . . . . . . . . . . 137 Special Additives . . . . . . . . 195
Autostick . . . . . . . . . . . . . . . 141
Battery . . . . . . . . . . . . . . . . . 185
Keyless Transmitter
Replacement (RKE) . . . . . . . 17
Location . . . . . . . . . . . . . . 185
Belts, Seat . . . . . . . . . . . . . 23,45
Body Mechanism
Lubrication . . . . . . . . . . . . . . 187
Brake Assist System . . . . . . . . 148
Brake Fluid . . . . . . . . . . . . . . 207
Brake System . . . . . . . . . . . . 193 Anti-Lock (ABS) . . . . . . . . 146
Fluid Check . . . . . . . . 194,207
Master Cylinder . . . . . . . . . 194
Parking . . . . . . . . . . . . . . . 145
Warning Light . . . . . . . . . . 108
Brake, Parking . . . . . . . . . . . 145
Brake/Transmission
Interlock . . . . . . . . . . . . . . . . 136
Brakes . . . . . . . . . . . . . . . . . 193
Break-In Recommendations,
New Vehicle . . . . . . . . . . . . . . 44
Bulb Replacement . . . . . . . . . 203
Bulbs, Light . . . . . . . . . . . 47,203
Calibration, Compass . . . . . . . 118
216