AUX Lancia Ypsilon 2012 Owner handbook (in English)

CAR INACTIVITY
In the event of car inactivity, special attention
must be paid due to the disconnection of the
battery power supply.
Proceed as follows: detach the connector A fig. 72
(by pressing button B) from sensor C for
monitoring the status of the battery installed on
the negative battery pole D. This sensor should
never be disconnected from the pole except if the
battery is replaced.
WARNING
When replacing the battery, always
contact a Lancia Dealership. Replace
the battery with one of the same type
(HEAVY DUTY) and with the same
specifications.JUMP STARTING
When jump starting, never connect the negative
lead (-) of the auxiliary battery to the negative
pole A fig. 73 of the car battery, but rather to an
engine/gearbox earth point.
fig. 72
L0F0083
fig. 73
L0F0084
96GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

In addition to the electrical branches, the car's
electrical system can be connected only to the
supply cable for an electric brake and to the cable
for an internal trailer light, though not more
than 15 W. To connect, use the preset control unit
with a battery cable with cross-section no less
than 2.5 mm
2.
IMPORTANT The use of auxiliary loads other
than external lights (electric brake, winch, etc.)
must occur with engine running.
IMPORTANT To install a tow hook contact a
Lancia Dealership.
WARNING
The ABS with which the car may be
equipped will not control the braking
system of the trailer. Particular caution is
required on slippery roads.
WARNING
Never modify the braking system of
the car to control the trailer brake.
The trailer braking system must be fully
independent of the car’s hydraulic system.
SNOW TYRESUse snow tyres of the same size as the normal
tyres provided with the car.
A Lancia Dealership will be happy to provide
advice concerning the most suitable type of tyre
for the customer's requirements.
For the type of tyre to be used, inflation pressures
and the specifications of snow tyres, follow the
instructions given in paragraph "Wheels" in
section "Technical specifications".
The winter performance of these tyres is
considerably reduced when the tread thickness is
less than 4 mm. Replace them in this case.
Due to their specific features, the performance of
snow tyres is much lower than that of normal
types in normal conditions or long motorway
stretches. Their usage should therefore be
restricted in accordance with their type approval.
IMPORTANT When using snow tyres with a
maximum speed index below the one that can be
reached by the car (increased by 5%), place a
notice in the passenger compartment, plainly in
view, which states the maximum speed allowed by
the snow tyres (as per EC Directive).
All four tyres should be the same (brand and
track) to ensure greater safety when driving and
braking and better driveability. Remember that
you should not change the rotation direction of the
tyres.
151GETTING TO KNOW
YOUR CAR
SAFETYSTARTING AND
DRIVINGWARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

IN AN EMERGENCY
In an emergency we recommend that you call the free-phone number found on the Warranty
Booklet. It is also possible to go to the www.lancia.com website to find the closest Lancia
Dealership.STARTING THE ENGINEGo to a Lancia Dealership immediately if
instrument panel warning light
remains on
constantly.
JUMP STARTING
If the battery is flat, the engine may be started
using an auxiliary battery with the same capacity
or a little higher than the flat one.To start the vehicle, proceed as follows:
❒connect the positive terminals (sign + near the
terminal) of the two batteries with a jump lead
fig. 114;
❒with a second lead, connect the negative
terminal – of the auxiliary battery to an
earthing point
on the engine or the gearbox of
the car to be started;
❒start the engine;
❒when the engine has been started, remove the
leads reversing the order above.
For versions with Start&Stop system, in case of
starting by auxiliary battery, refer to the
paragraph “Start&Stop system” in the chapter
“Getting to know your car”.
If after a few attempts the engine does not start,
do not persist but contact a Lancia Dealership.
IMPORTANT Do not directly connect the negative
terminals of the two batteries: sparks could ignite
explosive gas released from the battery. If the
auxiliary battery is installed on another car,
prevent accidental contact between metallic parts
of the two cars.
fig. 114
L0F0084
168
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGESIN AN EMERGENCYSERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

SUSPENSIONVersions Front Rear
0.9 TwinAir 85 HP
Independent, MacPherson type with
lower transversal wishbones secured to
an auxiliary crossmemberInterconnected wheels by means of tor-
sion beam 1.2 8V 69 HP
1.3 16V MultiJet
234
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

TABLE OF CONTENTS
INTRODUCTION.....................................................255
TIPS ......................................................................255
TECHNICAL CHARACTERISTICS .......................258
Speakers for Basic Audio specification....................258
Speakers for 360° HI-FI MUSIC specification ........258
QUICK GUIDE ........................................................260
General functions ...................................................261
Radio functions ......................................................262
CD functions ..........................................................263
Media Player functions (only withBlue&Me™) ...264
STEERING WHEEL CONTROLS ..........................265
INTRODUCTION.....................................................267
FUNCTIONS AND ADJUSTMENTS ........................269
SWITCHING ON THE CAR RADIO ......................269
SWITCHING OFF THE CAR RADIO.....................270
SELECTING THE RADIO FUNCTIONS ...............270
SELECTING CD FUNCTION ................................270
AUDIO SOURCE MEMORY FUNCTION ...............270
VOLUME ADJUSTMENT ......................................270
MUTE/PAUSE FUNCTION....................................271
AUDIO SETTINGS ................................................271
TONE ADJUSTMENT (bass/treble) .......................272
BALANCE ADJUSTMENT.....................................272
FADER ADJUSTMENT ..........................................273
LOUDNESS FUNCTION .......................................273
EQ FUNCTION .....................................................273
USER EQ SETTINGS FUNCTION ........................274
MENU....................................................................275
AF SWITCHING function .....................................276
TRAFFIC INFORMATION function ......................277REGIONAL MODE function .................................278
MP3 DISPLAY function ........................................279
SPEED VOLUME function ...................................280
RADIO ON VOLUME function .............................281
SPEECH VOLUME function .................................282
AUX OFFSET function .........................................282
RADIO OFF function ............................................282
SYSTEM RESET function......................................283
PHONE SET-UP ....................................................283
ANTI-THEFT PROTECTION ................................283
RADIO (TUNER) .....................................................286
INTRODUCTION...................................................286
FREQUENCY BAND SELECTION ........................286
PRESET BUTTONS...............................................287
STORING THE LAST STATION LISTENED TO...287
AUTOMATIC TUNING ..........................................287
MANUAL TUNING ................................................287
AUTOSTORE FUNCTION ....................................288
EMERGENCY ALARM RECEPTION ....................289
EON FUNCTION (Enhanced Other Network) ........289
STEREOPHONIC BROADCASTERS .....................289
CD PLAYER ............................................................290
INTRODUCTION...................................................290
SELECTING THE CD PLAYER ............................290
LOADING/EJECTING A CD..................................290
DISPLAY INFORMATION .....................................291
TRACK SELECTION (forward/back) ....................291
TRACK FAST FORWARD/REWIND ......................292
PAUSE FUNCTION ...............................................292
CD MP3 PLAYER ....................................................293
253
SOUND-SYSTEM

INTRODUCTION...................................................293
MP3 MODE ...........................................................293
SELECTING MP3 SESSIONS ON HYBRID
DISCS ....................................................................294
DISPLAY INFORMATION .....................................294
SELECTING NEXT/PREVIOUS FOLDER ............295
STRUCTURE OF THE FOLDERS.........................29AUX (only with theBlue&Me™ system) ................295
INTRODUCTION...................................................295
AUX MODE ...........................................................295
TROUBLESHOOTING ...........................................296
GENERAL .............................................................296
CD PLAYER ..........................................................29
MP3 FILE READING.............................................29
254
SOUND-SYSTEM
6
6 5

General functionsButton Functions Method
On short button press
Off short button press
Volume adjustment LH/RH knob rotation
FM ASFM1, FM2, FM Autostore radio source
selectionshort cyclical button press
AMMW1, MW2 radio source selection short cyclical button press
MEDIACD/Media Player source selection (only with
Blue&Me
™
) / AUX (only with
Blue&Me
™
, for versions/markets, where
provided)short cyclical button press
Volume activation/deactivation
(Mute/Pause)Short button pressAudio adjustments: low tones (BASS), high
tones (TREBLE), RH / LH balance
(BALANCE), front / rear balance (FADER)Menu activation: short button press
Selection of type of adjustment: pressing
or
buttons
Adjustment of values: pressing
or
buttons
MENUAdvanced functions adjustmentMenu activation: short button press
Selection of type of adjustment: pressing
or
buttons
Adjustment of values: pressing
or
buttons.
261
SOUND-SYSTEM

STEERING WHEEL CONTROLS(for versions/markets, where provided)Button Functions Method
AudioMute on/off (Radio mode) or Pause
function (MP3 or Media Player mode only
withBlue&Me
™
)Short button press
+Increasing volume Button press
-Decreasing volume Button press
SRCSelection of Radio frequency range (FM1,
FM2, FMT, FMA, MW1, MW2) and listening
sources; Radio, MP3 or Media Player (only
withBlue&Me
™
) /AUX (only with
Blue&Me
™
, for versions/markets, where
provided)Button press
NOTE: Starting from the FM or AM source set
on the radio (e.g. FM1 or MW1), if you cycle
through the audio sources using the SRC
button (stopping on a source other than radio)
when the radio source is selected (FM or AM)
using the commands on the radio panel, the
radio always switches to the last radio source
(FMA or MW2).
SRC
fig. 2
L0F0049
265
SOUND-SYSTEM

Media Player section (only with Blue&Me™)
For the Media Player functions see, the
Blue&Me™ supplement.
AUX section (only with Blue&Me™)
(for versions/markets, where provided)
❒AUX source selection;
❒AUX Offset function: alignment of the portable
device volume with that of the other sources;
❒Portable player playback.
FUNCTIONS AND ADJUSTMENTSSWITCHING ON THE CAR RADIO
The car radio comes on when the button/knob
(ON/OFF) is pressed briefly.
When the car radio is turned on, the volume is
limited to value 20 if it was set to a higher value
when previously used or to value 5 if it was
previously set to value 0 or to Mute/Pause. The
previously set value is maintained in all other
cases.
When the radio is switched on with the key
extracted from the ignition, it switches off
automatically after about 20 minutes. After the
radio has switched itself off automatically it can be
turned on for a further 20 minutes by pressing the(ON/OFF) button/knob.
269
SOUND-SYSTEM

MUTE/PAUSE FUNCTION
(volume reset)
Press the
button briefly to activate the Mute
function. The volume will gradually decrease and
the words "RADIO Mute" (in radio mode) or
"PAUSE" (in CD mode) will appear on the
display.
Press thebutton again to deactivate the Mute
function. The volume will gradually increase until
it reaches the level previously set.
When the volume level is changed using the
dedicated controls, the Mute function is
deactivated and the volume is adjusted to the new
level selected.
With the Mute function activated, it will be
ignored when there is an incoming traffic alert (if
the TA function is activated), or if an emergency
alarm is received. The function will be reactivated
when the alert is over.AUDIO SETTINGS
The functions in the audio menu differ according
to the activated source: AM/FM/CD/Media Player
(only withBlue&Me™) /AUX (only with
Blue&Me™, for versions/markets, where
provided).
Press the
button briefly to change the Audio
functions.
After thebutton is first pressed, the display will
show the bass level value for the source activated
at that time (e.g. in FM mode the display will
show the wording "FM Bass +2").
Use theor
buttons to scroll the menu
functions. To change the setting of the function
selected use the
or
buttons. The current status
of the selected function appears on the display.
271
SOUND-SYSTEM