coolant LAND ROVER DEFENDER 1996 Owner's Manual

COOLING SYSTEM
7
REPAIR EXPANSION TANK
Service repair no - 26.15.01
Remove
1.Position container to collect coolant spillage.
2.Slacken retaining clips and disconnect both
hoses from base of expansion tank.
3.Remove 3 bolts securing expansion tank to
inside wing and mounting bracket.
4.Remove expansion tank.
Refit
5.Fit expansion tank to inside wing and mounting
bracket.
6.Fit both hoses to base of tank.
7.Check and top up cooling system
See
SECTION 10, Maintenance, Under bonnet
maintenance

AIR CONDITIONING
1
DESCRIPTION AND OPERATION AIR CONDITIONING SYSTEM
Description
Air conditioning is an optional system which provides
fully integrated climate control for the vehicle interior.
The air conditioning system comprises four major
units as follows:- An evaporator matrix and expansion
valve (1), housed in the heater/ cooler unit (3), an
engine mounted compressor (4), a condenser (5),mounted in front of the radiator, and a receiver/drier
(7) located to the right of the condenser.
Ancillary components in the system comprise a blower
motor (2), also housed in the heater/cooler unit, and
condenser cooling fan motors (6), mounted on a
support frame. The four major units are interconnectd
by preformed metal and flexible refrigerant pipes as
illustrated below (RH drive installation shown).
Coolant flow to a heater matrix, housed in the heater
cooler unit, is controlled by a water valve (8) from a
combined air conditioning panel on the vehicle fascia.
1.Evaporator matrix and expansion valve
2.Blower motor
3.Heater/cooler unit
4.Compressor
5.Condenser6.Condenser fan motors
7.Receiver/drier
8.Water valve
9.Heater matrix feed and return hoses

ELECTRICAL
3
DESCRIPTION AND OPERATION Door and bonnet switches
Perimetric protection for the vehicle is provided by
ECU inputs connected to the starter switch, bonnet
switch and door switches.
Ultrasonic sensor
The ultrasonic sensor operates by emitting an air
pressure carrier wave which is subsequently received
by the sensor as it bounces back from objects inside
the vehicle. Once armed, the alarm will sound if wave
is disturbed by a door opening, or if movement is
detected inside the vehicle.
When the volumetric sensor is activated it monitors
movement within the vehicle for 15 seconds before
detecting and responding to intrusions. If the sensor
detects movement it delays arming until a quiet period
has lapsed; if continuous movement is detected, the
alarm will not arm volumetrically.
NOTE: Interior protection will not operate
until 15 seconds after alarm is set.
The ultrasonic sensor is positioned in a different
location, according to vehicle type, as follows:
·90/110 Station Wagon - RH cantrail trim
·90/110 Pick-up - On headlining, between interior
lamp and rear view mirror
·130 Crewcab - On headlining above RH door
Alarm sounder
Two types of alarm sounder can be fitted, one with a
battery back-up facility and or without battery back-up,
both providing an audible warning whenever the alarm
is triggered. The vehicle horn will also operate if the
alarm sounds.
The alarm sounder is fitted to LH inner front wing in
the engine compartment.
NOTE: Disconnecting the battery on
vehicles fitted with the battery backed-up
facility will result in the alarm sounding, if
correct procedure has not been followed.Engine immobilisation warning light
The engine immobilisation warning light is located on
the instrument panel, and provides a visual indication
that the engine is immobilised.
Anti-theft alarm indicator light
The anti-theft alarm indicator light is located on the
instrument panel, between the fuel and coolant
temperature indicators, and provides a visual
indication of the alarm/ immobiliser status.