sunroof LAND ROVER DEFENDER 1996 Workshop Manual

76CHASSIS AND BODY
30
REPAIR SUN ROOF
Service repair no - 76.83.01
Remove
1.Open sun roof fully.
2.Disengage spring lock from operating handle
catch.
3.Holding sun roof at both sides, release hinges
from locating brackets at front of outer frame.4.Remove sun roof.
5.Starting from centre rear, peel headlining finisher
from inner frame.
6.Remove 18 screws securing inner frame to outer
frame and detach inner frame.
7.Lift outer frame from roof.
NOTE: Assistance may be required to
remove the sun roof assembly.
Refit
8.Clean roof area around outer frame seating.
9.Position outer frame on roof.
10.Fit inner frame to headlining and secure to outer
frame with 18 screws but do not fully tighten.
11.Check alignment of inner and outer frames with
roof mounting and headlining, adjust as
necessary, and fully tighten fixing screws to
10
Nm (7 lbf/ft).
12.Starting from centre rear, fit headlining finisher
lip into locating channel of inner frame.
13.Press finisher firmly over inner frame and
continue around complete frame, ensuring
finisher lies flat on headlining.
14.Fit sun roof hinges fully into locating brackets on
outer frame, and lower the glass panel.
15.Engage operating handle catch with spring lock
of outer frame and close sunroof.

ELECTRICAL
5
DESCRIPTION AND OPERATION REV: 05/99 ALARM SYSTEM OPERATION
Arming alarm
To arm the alarm, aim handset at vehicle and press
the RH button (Padlock symbol). Provided all doors
and or apertures are closed, the direction indicator
lamps will flash three times to confirm that the alarm is
armed. All security features previously described will
be active.
Once armed, the alarm will sound if a door or the
bonnet is opened, or if movement is detected inside
the vehicle.
Disarming alarm
Within range of the vehicle, briefly press the LH
(Plain) button on the handset; the direction indicator
lamps will flash once to indicate that the alarm has
been disarmed and the engine re-mobilised.
NOTE: In some territories, the interior
lamps will illuminate when the alarm is
disarmed.
If the direction indicators fail to flash when the
alarm is armed:
This indicates that a door or the bonnet is not fully
closed, in which case the alarm will be partially armed
and engine immobilised, but interior protection will not
be active.
Once the open door or bonnet is closed, the direction
indicators will flash three times and the alarm will fully
arm as described previously.
If the alarm sounds:
The vehicle horn and alarm sounder will operate
continuously for 30 seconds when the alarm is
triggered. The horn and alarm sounder can be
triggered up to three times.
To silence the alarm, press either handset button. If
the handset is inoperative, the alarm can only be
disarmed by entering the emergency key access
code, seeEngine immobilisation override.Anti-theft alarm indicator light
A RED indicator light on the instrument panel
indicates the status of the alarm system. When the
alarm is armed successfully, the light flashes rapidly.
After 10 seconds, the light adjusts to a slower
frequency and continues flashing as an anti-theft
deterrent.
If the light fails to illuminate during the rapid flash
phase, this indicates a 'mislock' (door or the bonnet
not fully closed or key in starter switch). If this occurs,
the indicator light will still flash at slower frequency as
an anti-theft deterrent.
The indicator light will illuminate continuously under
the following conditions:
1.Alarm system armed and immobilised with
ignition 'on' or driver's door open.
2.Engine immobilised with ignition 'on' or driver's
door open.
Interior protection
Interior protection is activated automatically when the
alarm system is armed; twin sensors inside the
vehicle monitor interior space and will activate the
alarm if an intrusion is detected.
However, if passengers or animals are to be left inside
the vehicle, or if a window or sunroof is to be left
open, the alarm must be armed with the interior
protection DISABLED as follows:
To disable interior protection:
1.Open the driver's door.
2.Use the handset to arm the alarm in normal way.
3.Close the driver's door (the direction indicator
lamps will flash three times and the anti-theft
indicator light commences flashing rapidly). The
alarm system is now armed with the interior
protection disabled.
NOTE: Interior protection will not operate
until 15 seconds after the alarm is set.