fuel cap release LAND ROVER DISCOVERY 1995 User Guide

Mpi
7
REPAIR FUEL RAIL AND INJECTORS
Service repair no - 19.60.04 - Rail
Service repair no - 19.60.10 - Injectors
Remove
1.Remove inlet manifold chamber gasket.
See
MANIFOLD AND EXHAUST SYSTEM, Repair,
Manifold Chamber Gasket - Mpi
2.Remove pressure regulator.
3.Remove 4 bolts securing fuel feed hose flange
stiffening bracket, remove stiffening bracket.
4.Release fuel feed hose from fuel rail.
5.Discard 'O' ring.
6.Disconnect 4 injector multiplugs.
7.Move injector harness aside.
8.Remove 2 bolts securing fuel rail to inlet
manifold.
9.Release 4 injectors from inlet manifold.
10.Remove fuel rail complete with injectors.
11.Discard outlet 'O' rings from injectors.
12.Fix protective cap to each injector.
Do not carry out further dismantling if component
is removed for access only.
13.Remove clip(s) securing injector(s) to fuel rail.
14.Remove injector(s).
15.Discard inlet 'O' ring(s) from injector(s).
16.Remove fuel temperature sensor.

86ELECTRICAL
50
REPAIR DIGITAL DIESEL SHUT-OFF VALVE (DDS) - 97 MY
Service repair no - 86.77.00
Remove
1.Remove fuel injection pump.
See FUEL
SYSTEM, Repair, fuel injection pump and
timing
2.Drill into 2 break-off screws to a depth of
approximately 5 mm using a 3.2 mm drill.
CAUTION: Use a drill bushing to guide the
drill during the above.
3.Using an 'Easy-out' remove 2 valve retaining
screws and discard.
4.Release DDS valve from fuel shut-off solenoid.
5.Remove protective cap from fuel shut-off
solenoid electrical connection.
6.Remove fuel shut-off solenoid terminal nut and
remove DDS valve.
Refit
7.Position DDS terminal lead to fuel shut-off
solenoid and secure with nut tightened to
2Nm.
8.Position DDS valve to fuel shut-off solenoid .
9.Position clamping plate to DDS valve and tighten
shear bolts simultaneously until heads shear.
10.Fit fuel injection pump.
See FUEL SYSTEM,
Repair, fuel injection pump and timing; Refit
ANTENNA AMPLIFIER - 97 MY
Service repair no - 86.50.29
Remove
1.Remove RH alpine light trim casing.
See
CHASSIS AND BODY, Repair, alpine light
trim casing
2.Release amplifier to sixth light connector and
seal finisher.
3.Remove screw securing amplifier to body and
release from location.
4.Disconnect co-axial cable from amplifier.
5.Disconnect Lucar from amplifier.
6.Remove amplifier.
Refit
7.Fit amplifier, connect co-axial cable and Lucar to
amplifier.
8.Position amplifier to location and secure with
screw.
9.Secure amplifier lead through seal finisher and
connect to sixth light.
10.Fit RH alpine light trim casing.
See CHASSIS
AND BODY, Repair, alpine light trim casing;
Refit