remote start Lexus CT200h 2015 Quick Guide (in English)

15
CT200h_QG_OM76185U_(U)
●How to display on the multi-information display
Press the “DISP” switch on the steering wheel several times to select the energy monitor
display.
■Fuel consumption (vehicles with a navigation system or Lexus Display
Audio system)
● Trip information
Navigation system
Press the “MENU” button on the Remote Touch, then select “Info” on the “Menu” screen,
and then select “Fuel Consumption”.
If the “Energy Monitor” or “Past Record” screen is displayed, select “Trip Information”.
Resetting the consumption data
Fuel consumption in the past 15 minutes
Current fuel consumption
Regenerated energy in the past 15
minutes
One symbol indicates 30 Wh. Up to 5
symbols are shown.
Average vehicle speed since the hybrid
system was started.
Elapsed time since the hybrid system
was started.
Cruising range
The flow of energy is indicated by the movement of the arrows
on the multi-information display.
The displayed energy flow, battery level, etc. will change in response to the current driving
conditions.
1
2
3
4
5
6
7

16
CT200h_QG_OM76185U_(U)
Lexus Display Audio system
Press the “MENU” button on the Lexus Display Audio controller, then select “Info” on the
“Menu” screen, and then select “Fuel Consumption”.
If the “Trip Information” screen does not appear, move the controller to the right and
select “Trip Information”.
Fuel consumption in the past 15 minutes
Current fuel consumption
Regenerated energy in the past 15
minutes
One symbol indicates 30 Wh. Up to 5
symbols are shown.
Average vehicle speed since the hybrid
system was started.
Elapsed time since the hybrid system
was started.
Cruising range
● Pa s t re c o r d
Navigation system
Press the “MENU” button on the Remote Touch, then select “Info” on the “Menu” screen,
and then select “Fuel Consumption”.
If the “Energy Monitor” or “Trip Information” screen is displayed, select “Past Record”.
Resetting the past record data
Best recorded fuel consumption
Average fuel consumption
Previous fuel consumption record
Updating the average fuel consump-
tion data
1
2
3
4
5
6
1
2
3
4
5

78
CT200h_QG_OM76185U_(U)
■Programming HomeLink®
Point the remote control transmitter for
the device 1 to 3 in. (25 to 75 mm)
from the HomeLink
® buttons.
Keep the HomeLink
® indicator light in
view while programming.
For U.S.A. owners Press and hold the HomeLink
® button
you want to program and the remote
control transmitter button simulta-
neously. When the HomeLink
® indica-
tor light changes from slowly flashing
orange to rapidly flashing green (roll-
ing code) or continuously lit green
(fixed code), release both buttons.
Programming an entry gate (for U.S.A. owners)/Programming a device in the
Canadian market With one hand, press and hold the HomeLink
® button you want to program. With your
other hand, press and release the remote control transmitter every 2 seconds and
repeat this cycle until the HomeLink
® indicator light starts to flash rapidly. Then,
release the buttons.
Test the HomeLink
® operation by pressing the newly programmed button and observ-
ing the indi cator light:
● If the indicator light is solid/continuous, programming has been completed and your
device should activate when the HomeLink
® button is pressed and released.
● If the indicator light blinks rapidly for 2 seconds and then turns into a solid/continu-
ous light, proceed to the heading “Programming a Rolling Code System”.
Repeat the steps above to program another device for any of the remaining
HomeLink
® buttons.
1
2
2
3
4