belt Lexus ES300 1994 Comfort Adjustment

COMFORT ADJUSTMENT
63
Front airbag sensorWarning lightFront airbag sensor
Passenger airbag module
(airbag and inflator)
Center airbag sensor assembly
Steering wheel
pad assembly
(airbag and
inflator)
The center airbag sensor assembly consists of a safing sensor
and center airbag sensor. In a severe frontal impact, a front
airbag sensor and safing sensor, or center airbag sensor and
safing sensor detect the shock and the center airbag sensor
assembly triggers the inflators. Then the inflators fill the
airbags to help restrain forward motion of the occupants.
When the SRS airbags operate, they produce an operating
noise and release a small amount of smoke-like gas. This gas
is harmless and does not indicate a fire.CAUTION:

The SRS airbag system is designed only as a
supplement to the conventional seat belt systems of
the driver and front passenger. The front seat
occupants are particularly susceptible to injury if they
do not wear their seat belts; when sudden braking or a
collision occurs, they may be thrown forward. To obtain
further protection in an accident, the driver and all
passengers in the vehicle should always wear their seat
belts when driving. For instructions and precautions
concerning the seat belt system, see “SEAT BELTS” on
page 55.

A baby or small child who is too small to use a seat belt
should be properly secured in a rear seat using a child
restraint system.

COMFORT ADJUSTMENT
64
Far back

Do not use a rear-facing child restraint system in the
front seat because the force of the rapid inflation of the
passenger airbag may cause severe injury to the child.
When using a forward-facing child restraint system in
the front seat, the seat must be moved as far back as
possible. For instructions concerning the installation
of a child restraint system, see “CHILD RESTRAINT” on
page 67.
Do not sit on the edge of the seat or lean over the
instrument panel when the vehicle is in use. The airbag
inflates with considerable speed and force; you may be
severely injured. Sit up straight and well back in the
seat, and always use your seat belt.

COMFORT ADJUSTMENT
67
The front part of the vehicle (shaded in the illustration) was
involved in an accident not of the extent to cause the SRS
airbags to inflate.

The pad section of the steering wheel or front passenger
airbag cover (shaded in the illustration) is scratched,
cracked, or otherwise damaged.
CHILD RESTRAINT
Child restraint precautions
Lexus strongly urges the use of child restraint system for
children small enough to use it.
The laws of all fifty states in the U.S.A. and Canada now
require the use of a child restraint system.
CAUTION:
For effective protection in automobile accidents and
sudden stops, children must be properly restrained.
Holding a child in your arms is not a substitute for a child
restraint system. In an accident, the child can be crushed
against the windshield, or between you and the vehicle’s
interior if you are unrestrained.
Child restraint system
A child restraint system for a small child or baby must
itself be restrained on the seat with either the lap belt or
the lap portion of the lap / shoulder belt.
The child restraint system should conform to the size of the
child and properly fit the vehicle seat. For greater safety, the
child restraint system should be installed in the rear seat.
According to accident statistics, children are safer when
properly restrained in the rear seat than in the front seat.
When installing a child restraint system, refer to the
instructions provided by its manufacturer and follow the
directions under the following illustrations.
CAUTION:
After installing the child restraint system, make sure it is
secured in place. If it is not restrained securely, it may
cause injury to the child in the event of a sudden stop or
accident.
When not using the child restraint system, keep it secured with
the seat belt or place it in the trunk or somewhere other than
in the vehicle. This will prevent it injuring passengers in the
event of a sudden stop or accident.

COMFORT ADJUSTMENT
69 3. Insert a 15 mm (0.6 in.) spacer for either outside anchor or
a 10 mm (0.4 in.) spacer for the center anchor, and tighten
down the anchor bracket for your child restraint system with a
bolt. Torque the bolt to 16.5 − 24.7 N
.m (1.68 − 2.52 kgf.m, 12.2
− 18.2 ft.lb).
To comply with Canada Motor Vehicle Safety Standards,
vehicles sold in Canada are provided with a bracket set in the
glovebox, designed for use with the center location shown in
the illustration. If you want to install the bracket set on either
outside anchor, replace the spacer (Part No. 90560-08064)
with one that is 15 mm (0.6 in.) thick. This can be puchased
from your Lexus dealer.
INSTALLATION ON CENTER REAR SEAT
When installing a rear-facing child restraint system, follow the
same procedure to install a forward-facing child restraint
system.
Fasten the center lap belt over the child restraint system
following the instructions provided by its manufacturer.
Make sure the belt is tight by pulling its free end while you firmly
push down the child restraint system.

COMFORT ADJUSTMENT
71
Fasten the lap and shoulder belt over the child restraint system
following the instructions provided by its manufacturer. Keep
the lap portion of the belt tight.
Fully extend the shoulder belt to put it in the lock mode.
Place the shoulder belt between the vehicle seatback and the
child restraint system and allow it to retract. To hold the child
restraint system securely, let the shoulder belt retract as far as
it will go while firmly pushing down the child restraint system.
If your child restraint system requires the use of a top strap,
latch the hook onto the anchor bracket and tighten the top
strap.

COMFORT ADJUSTMENT
72
CAUTION:
Make sure the seat belt is securely locked. Also make sure
the child restraint system is secure by pushing and
pulling it in different directions.
To remove the child restraint system, press the buckle release
button and allow the belt to retract. Unhook the top strap.INSTALLATION ON FRONT SEAT
Far back
CAUTION:
Do not use a rear-facing child restraint system in the front
seat because the force of the rapid inflation of the
passenger airbag may cause severe injury to the child.
When using a forward-facing child restraint system, move
the seat as far back as possible.

COMFORT ADJUSTMENT
73
Fasten the lap and shoulder belt over the child restraint system
following the instructions provided by its manufacturer. Keep
the lap portion of the belt tight.
Fully extend the shoulder belt to put it in the lock mode.
Place the shoulder belt between the vehicle seatback and child
restraint system and allow it to retract. To hold the child
restraint system securely, let the shoulder belt retract as far as
it will go while firmly pushing down the child restraint system.
If your child restraint system requires the use of a top strap,
latch the hook onto the tab of the rear center seat belt and
tighten the top strap.

COMFORT ADJUSTMENT
74
CAUTION:
Make sure the seat belt is securely locked. Also make sure
the child restraint system is secure by pushing and
pulling it in different directions.
To remove the child restraint system, press the buckle release
button and allow the belt to retract. Unhook the top strap.