MAINTENANCE
157
Explanation of scheduled maintenance items
ENGINE COMPONENTS AND EMISSION CONTROL
SYSTEMS
Timing belt
(Applicable to Schedule A only.) When scheduled, replace the
belt and inspect the ignition timing. A qualified technician must
perform these operations.
Valve clearance
Adjust the valve clearances to factory specifications. A
qualified technician should perform this operation.
Drive belts
Inspect the drive belts for cracks, excessive wear or oiliness.
Replace belt if damaged. Check the auto tensioner operation.
Engine oil and oil filter
Change the engine oil and oil filter when scheduled. Use API
SG or SH, Energy-Conserving II multigrade engine oil or
ILSAC multigrade engine oil. For recommended viscosity, see
page 177. A qualified technician should perform this operation.Engine coolant
Drain and flush the cooling system when scheduled. Refill only
with an ethylene-glycol type coolant. A qualified technician
should perform this operation.
Exhaust pipes and mountings
Visually inspect the exhaust pipes, muffler and hangers for
cracks, deterioration, or damage. Start the engine and listen
carefully for any exhaust gas leakage. Tighten connections or
replace parts as necessary.
Air cleaner filter
Replace the air cleaner filter when scheduled. Do-it-yourself
instructions are given on page 179. If you mainly operate your
vehicle on dusty roads, additionally inspect and clean the air
cleaner filter when scheduled. Visually check for dirt or
damage. It may be cleaned with compressed air.
Fuel lines and connections
Visually inspect the lines, connections and tank band for
corrosion, damage, cracks, and loose or leaking connections.
Tighten connections or replace parts as necessary.
Fuel tank cap gasket
Make sure the new gasket is correctly installed.
