tow Lexus ES300 1995 In Case Of An Emergency

SECTION 4
129
IN CASE OF AN EMERGENCY
If your engine stalls while driving130 . . . . . . . . . . . . . . . . . . . . . . . . . . .
If your vehicle will not start130 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If your vehicle overheats133 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If you have a flat tire134 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If your vehicle needs to be towed139 . . . . . . . . . . . . . . . . . . . . . . . . . .
If you cannot shift automatic transmission selector lever142 . . . . . . .
If you lose your keys or lock yourself out143 . . . . . . . . . . . . . . . . . . . .

IN CASE OF AN EMERGENCY
139 10. After changing the wheel, check the air pressure of the
replaced tire. Stow all the tools, jack and flat tire securely.
If the pressure of the replaced tire is low, drive slowly to the
nearest service station and fill to the correct pressure.
Do not forget to reinstall the tire valve cap as dirt and moisture
could get into the valve core and possible cause aire leakage.
If the cap is missing, put a new one on as soon as possible.
This is the same procedure for changing or rotating your tires.
CAUTION:
Before driving, make sure all the tools, jack and flat tire are
securely in place in their storage location to reduce the
possibility of personal injury during a collision or sudden
braking.
IF YOUR VEHICLE NEEDS TO BE
TOWED
If towing is necessary, we recommend you have it done by
your Lexus dealer or a commercial tow truck service.
Proper equipment will help ensure that your vehicle is not
damaged while being towed. Commercial operators are
generally aware of the state / provincial and local laws
pertaining to towing.
Your vehicle can be damaged if it is towed incorrectly. Although
most operators know the correct procedure, it is possible to
make a mistake. To avoid damage to your vehicle, make sure
the following few precautions are observed. If necessary, show
this page to the tow truck driver.TOWING PRECAUTIONS:
Use a safety chain system for all towing, and abide by the
state / provincial and local laws. The wheels and axle on the
ground must be in good condition. If they are damaged, use a
towing dolly.
1. Using flat bed truck
Lexus recommends this as the best method for your vehicle.

IN CASE OF AN EMERGENCY
Front
Rear emergency
towing eyelets
140
Tie down points
If your Lexus is transported by a flat bed, it should be tied
down at locations A and B as shown above.
NOTICE:
Do not use the rear emergency towing eyelets.

Tie down angle
If you use chains or wires to tie down your vehicle, the
angle must be as shown above.

IN CASE OF AN EMERGENCY
141 2. Towing with wheel lift type truck

From front
Release the parking brake.

From rear
Use a towing dolly under the front wheels.
NOTICE:
Never tow a vehicle with an automatic transmission from
the rear with the front wheels on the ground, as this may
cause serious damage to the transmission.
3. Towing with a sling type truck
NOTICE:
Do not tow with a sling type truck, either from the front
or rear. This may cause body damage.

IN CASE OF AN EMERGENCY
Emergency towing eyeletsEmergency towing eyelet
Cover of
shift lock
override button
142
Emergency towing
If towing service is not available in an emergency, your
vehicle may be temporarily towed by a cable secured to
one of the eyelets under the front or rear of the vehicle.
A driver must be in the vehicle to steer it and operate the
brakes. Towing in this manner may be done only on
hard−surfaced roads for a short distance and at low speeds.
Also, the wheels, axles, drive train, steering and brakes must
all be in good condition.
Before towing, release the parking brake and put the
transmission in “N”. The ignition key must be in “ACC” (engine
off) or “ON” (engine running).
CAUTION:
If the engine is not running, the power assist for the brakes
and steering will not work, so steering and braking will be
much harder than usual.
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION
SELECTOR LEVER
If you cannot shift the selector lever out of “P” position to
other positions even though the brake pedal is depressed,
use the shift lock override button as follows:
1. Turn the ignition key to “LOCK”. Make sure the parking
brake is applied.
2. Pry up the cover with a flat−bladed screwdriver or
equivalent.