garage door opener Lexus ES300 1998 Owner's Manuals (in English)

INTERIOR EQUIPMENT43
OVERHEAD CONSOLE BOX
Garage door opener box
The box is designed to store a garage door opener transmitter.
14E041
1. Open the cover of the overhead console box.
2. Remove the Velcro loop.
3. Remove the paper strip covering the adhesive on back side of loop.
4. Adhere loop to back side of the transmitter near center.
14E042
Please note if transmitter has wire clip for sun visor, this clip must be removed
prior to adhesion of Velcro.
14E043
5. Place the transmitter, with Velcro loop facing inside of the box, into
overhead console box. Make sure the transmitter button is located above
button pins.
14E044±1
6. Remove spacers from the cover. Place largest spacer on the pin that would
be below the transmitter button when the cover is closed. Close the cover\
.

INTERIOR EQUIPMENT
44
14E035
When the garage door opener is properly installed, you can operate the
transmitter by pushing the center panel of the cover.
14E045
If the center panel does not contact with your garage door opener transmit\
ter;
1. Check to see if spacer is on correct pin.
2. Attach another spacer to the top of original spacer. Check operation. If
required, continue to add spacers until contact is achieved.
If the transmitter is clattering during driving, fill in a piece of felt or pad to
prevent the transmitter from clattering.
CAUTION
To reduce the chance of injury in case of an accident or a
sudden stop, always keep the garage door opener box
closed while driving.
 Keep the remained spacers away from children.