battery location Lexus ES300 2001 Owner's Manuals (in English)

INTERIOR EQUIPMENT
89
The battery side of the hand±held transmitter must be
pointed away from the HomeLink
 during the
programming process.
For Canadian users, follow the procedure in
ªProgramming an entrance gate/Programming all
devices in the Canadian marketº.
1. Decide which of 3 HomeLink
 buttons you want to
program.
2. Place your hand±held garage transmitter 25 to 75
mm (1 to 3 in.) away from the surface of the HomeLink
.
Keep the indicator light on the HomeLink
 in view while
programming.
3. Simultaneously press and hold the hand±held garage
transmitter button along with the selected HomeLink

button.
4. When the indicator light on the HomeLink
 changes
from a slow to a rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
 by pressing the
newly programmed button. If programming a garage
door opener, check to see if the garage door opens and
closes. If the garage door does not operate, identify if your
garage transmitter is of the ªRolling Codeº type. Press
and hold the programmed HomeLink
 button. The
garage door has the rolling code feature if the indicator
light (on the HomeLink
) flashes rapidly and then
remains lit after 2 seconds. If your garage transmitter is
the ªRolling Codeº type, proceed to the heading
ªProgramming a rolling code systemº.
6. Repeat steps 2 through 5 for each remaining
HomeLink
 button to program another device.
Programming a rolling code system
If your device is ªRolling Codeº equipped, it is
necessary to follow steps 1 through 4 under the
heading ªProgramming the HomeLink
º before
proceeding with the steps listed below.
1. Locate the ªtrainingº button on the ceiling mounted
garage door opener motor. The exact location and color
of the button may vary by brand of garage door opener.
Refer to the owner's guide supplied by the garage door
opener manufacturer for the location of this ªtrainingº
button.
2. Press the ªtrainingº button on the ceiling mounted
garage door opener motor.
Following this step, you have 30 seconds in which to
initiate step 3 below.