engine Lexus GS250 2014 Owner's Manual
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2014, Model line: GS250, Model: Lexus GS250 2014Pages: 688, PDF Size: 152.64 MB
Page 627 of 688

6277-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
CAUTION
■When inspecting under the hood of your vehicle
Observe the following precautions.
Failure to do so may result in serious injury such as burns.
●If steam is seen coming from under the hood, do not open the hood until the
steam has subsided. The engine compartment may be very hot.
●Keep hands and clothing (especially a tie, a scarf or a muffler) away from the fans
and belts. Failure to do so may cause the hands or clothing to be caught, resulting
in serious injury.
NOTICE
■When adding engine coolant
Add coolant slowly after the engine has cooled down sufficiently. Adding cool
coolant to a hot engine too quickly can cause damage to the engine.
■To prevent damage to the cooling system
Observe the following precautions:
●Avoid contaminating the coolant with foreign matter (such as sand or dust etc.).
●Do not use any coolant additives.
●Do not loosen the coolant inlet cap or the
coolant reservoir cap while the engine and
radiator are hot.
High temperature steam or coolant could
spray out.
GS350_250_OM_OM30E16E_(EE).book Page 627 Tuesday, July 8, 2014 7:11 PM
Page 628 of 688

6287-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
If the vehicle becomes stuck
Stop the engine. Set the parking brake and shift the shift lever to P.
Remove the mud, snow or sand from around the rear wheels.
Place wood, stones or some other material under the rear wheels to
help provide traction.
Restart the engine.
Shift the shift lever to D or R and release the parking brake. Then, while
exercising caution, depress the accelerator pedal.
■When it is difficult to free the vehicle
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mu d, dirt or snow:
Press to turn off TRC. ( →P. 3 2 2 )
1
2
3
4
5
GS350_250_OM_OM30E16E_(EE).book Page 628 Tuesday, July 8, 201 4 7:11 PM
Page 633 of 688

633
8
8-1. Specifications
Vehicle specifications
GS350_250_OM_OM30E16E_(EE)
■Vehicle identification number
The vehicle identification number (VIN) is the legal identifier for your
vehicle. This is the primary identification number for your Lexus. It is
used in registering the ownership of your vehicle.
This number is stamped on the top left of the instrument panel and in
the engine compartment.
This number is also on the manu-
facturer’s label.
■Engine number
The engine number is stamped
on the engine block as shown.
Vehicle identification
GS350_250_OM_OM30E16E_(EE).book Page 633 Tuesday, July 8, 201
4 7:11 PM
Page 634 of 688

6348-1. Specifications
GS350_250_OM_OM30E16E_(EE)
Engine
GS250GS350
Model4GR-FSE2GR-FSE
Ty p e6-cylinder V type, 4-cycle, gasoline
Bore and stroke83.0 × 77.0 mm
(3.27 × 3.03 in.)94.0 × 83.0 mm
(3.70 × 3.27 in.)
Displacement2500 cm3 (152.6 cu.in.)3456 cm3 (210.9 cu.in.)
Valve clearanceAutomatic adjustmentDrive belt tension
Fuel
Fuel type
EU area:
Unleaded gasoline conforming to European stan-
dard EN228 only
Except EU area:
Unleaded gasoline only
Research Octane Num-
ber95 or higher
Fuel tank capacity
(Reference)66 L (17.4 gal., 14.5 Imp.gal.)
GS350_250_OM_OM30E16E_(EE).book Page 634 Tuesday, July 8, 201 4 7:11 PM
Page 635 of 688

635
8
8-1. Specifications
Vehicle specifications
GS350_250_OM_OM30E16E_(EE)
*: The engine oil capacity is a reference quantity to be used when changing the
engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check
the oil level on the dipstick.
■Engine oil selection (GS250)
XEU area, Nordic countries, Russia, Ukraine, Macedonia, Israel
“Toyota Genuine Motor Oil” is used in your Lexus vehicle. Lexus rec-
ommends the use of approved “Toyota Genuine Motor Oil”. Another
motor oil of matching quality can also be used.
Oil grade:
0W-20, 5W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC multigrade engine oil
15W-40 and 20W-50:
API grade SL, SM or SN multigrade engine oil
Lubrication system
GS250GS350
Oil capacity
(Drain and refill reference
*)
With filter6.2 L
(6.6 qt., 5.5 Imp.qt.)6.4 L
(6.8 qt., 5.6 Imp.qt.)
Without filter5.9 L
(6.2 qt., 5.2 Imp.qt.)6.0 L
(6.3 qt., 5.3 Imp.qt.)
GS350_250_OM_OM30E16E_(EE).book Page 635 Tuesday, July 8, 201 4 7:11 PM
Page 636 of 688

6368-1. Specifications
GS350_250_OM_OM30E16E_(EE)
Recommended viscosity (SAE):
SAE 0W-20 is filled into your
Lexus vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used.
However, it should be replaced
with SAE 0W-20 at the next oil
change.
If you use SAE 10W-30 or a
higher viscosity engine oil in
extremely low temperatures, the
engine may become difficult to
start, so SAE 0W-20, 5W-20 or
5W-30 engine oil is recom-
mended.
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows
cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when the oil is at high temperature. An oil with a higher viscosity (one
with a higher value) may be better suited if the vehicle is operated at
high speeds, or under extreme load conditions.
Temperature range anticipated
before next oil change Preferred
GS350_250_OM_OM30E16E_(EE).book Page 636 Tuesday, July 8, 201
4 7:11 PM