light Lexus GS300 2006 Audio

AUDIO
312Searching for a desired track or a disc—
G22061
Touch the “SCAN” switch.
The bar on the upper side will be highlighted in yellow. The
player will play the next track for 10 seconds, then scan again.
To select a track, touch the “SCAN” switch a second time. If
the player reaches the end of the disc, it will continue scanning
at track 1.
After all the tracks are scanned in one pass, normal play
resumes.
Touch the “DISK SCAN” switch.
The bar on the upper side will be highlighted in yellow. The
program at the beginning of each disc will be played for 10
seconds. To continue listening to the program of your choice,
touch the “DISC SCAN” switch a second time.
After all the audio disc are scanned in one pass, normal play
resumes.Other functions—
G22111
“RPT” switch: Use it for automatic repeat of the track you are
currently listening to.
Touch the switch while the track is playing. When the track is
finished, the player will automatically go back to the beginning
of the track and play the track again. To cancel it, touch the
switch once again.
“DISC RPT” switch: Use it for automatic repeat of the disc
you are currently listening to.
Touch the switch while the disc is playing. When the disc is
finished, the player will automatically go back to the beginning
of the disc and play the disc again. To cancel it, touch the
switch once again.
“RAND” switch: Use it for automatic and random selection
of the disc which you are currently listening to.

AUDIO
333
Audio system operating hints
NOTICE
To ensure correct audio system operations:
Be careful not to spill beverages over the audio
system.
Do not put anything other than a cassette tape or disc
into the cassette tape slot or disc slot.
The use of a cellular phone inside or near the vehicle
may cause a noise from the speakers of the audio
system which you are listening to. However, this
does not indicate a malfunction.
Radio reception
FM broadcasts have a range of about 40 km or 25 miles. When
driving away from a station, you may have to fine−tune your
radio and turn up the volume as the station gets weaker.
Because FM uses a line−of−sight signal, tall buildings or hills
may sometimes block reception. These are all normal
characteristics of FM reception and do not indicate any
problem with the radio itself.Caring for your cassette player and tapes
For the best performance for your cassette player and tapes:
Clean the tape head and other parts regularly.
A dirty tape head or tape path can decrease sound quality
and tangle your cassette tapes. The easiest way to clean
them is by using a cleaning tape. (A wet type is
recommended.)
Use high−quality cassettes:
Low−quality cassette tapes can cause many problems,
including poor sound, inconsistent playing speed, and
constant auto−reversing. They can also get stuck or
tangled in the cassette player.
Do not use a cassette if it has been damaged or tangled or
if its label is peeling off.
Do not leave a cassette in the player if you are not listening
to it, especially if it is hot outside.
Store cassettes in their cases and out of direct sunlight.
Avoid using cassettes with a total playing time longer than
100 minutes (50 minutes per side). The tape used in these
cassettes is thin and could get stuck or tangled in the
cassette player.

AUDIO
337
20L038

Correct
Wrong
Handle discs carefully, especially when you set them into
the player. Hold them on the edge and do not bend them.
Avoid getting fingerprints on them, particularly on the shiny
side.
Dirt, scratches, warping, pin holes, or other disc damage
could cause the player to skip or to repeat a section of a
track. (To see a pin hole, hold the disc up to the light.)
20L039
To clean a disc: Wipe it with a soft, lint−free cloth that has been
dampened with water. Wipe in a straight line from the center
to the edge of the disc (not in a circle). Do not use a
conventional record cleaner or anti−static device.