high beam Lexus GS300 2006 Electrical Components
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2006, Model line: GS300, Model: Lexus GS300 2006Pages: 26, PDF Size: 0.68 MB
Page 8 of 26
ELECTRICAL COMPONENTS
570
No.FUSEAMPERECIRCUIT
70 A/F15Multi−port fuel injection
system/sequential multiport fuel
injection system
71 ETCS10Multi−port fuel injection
system/sequential multiport fuel
injection system
72 ALT−S7.5Charging system
73 EM VLV10No circuit
74 H−LP CLN30Headlight cleaner system
75 A/C COMP7.5Air conditioning system
76 DEICER25No circuit
77 FR
CTRL−AM30“FR TAIL”, “FR FOG” and
“WASHER”
78 IG210Starting system
79 EFI NO.210
Multi−port fuel injection
system/sequential multiport fuel
injection system, Evaporative
system
80 H−LP R
LW R15Right−hand headlight (low
beam)
81 H−LP L
LW R15Left−hand headlight (low beam)
82 F/PMP25Fuel pump
No.FUSEAMPERECIRCUIT
83 EFI
GS430:
25
GS300:
25Multi−port fuel injection
system/sequential multiport fuel
injection system
84 INJ20Multi−port fuel injection
system/sequential multiport fuel
injection system
85 H−LP UPR15Headlights (high beam)
86 HORN10Horn
87 WASHER20Windshield wipers and washer
88 FR TAIL10Parking lights, Side marker
lights
89 FR FOG15Front fog lights
90 RR
S/SHADE7.5Rear electric sunshade
91 PSB30Pre−collision system
92 RR−IG210No circuit
93 RR−IG110Pre−collision system, Rear
electric sunshade, Seat belt
pretensioners
94 RR−B10Luggage compartment light,
Noise filter
95 RR FOG7.5Rear fog lights
96 STOP LP L10Stoplights, Back up lights
Page 17 of 26
ELECTRICAL COMPONENTS
579
ADDING WASHER FLUID
If the washer tank becomes nearly empty, add washer
fluid.
You may use plain water as washer fluid. However, in cold
areas where temperatures range below the freezing point, use
washer fluid containing antifreeze. This product is available at
your Lexus dealer and most auto parts stores. Follow the
manufacturer’s directions for how much to mix with water.
NOTICE
Do not use engine antifreeze or any other substitute
because it may damage your vehicle’s paint.
CHECKING THE HEADLIGHT AIM
G64020
1
Beam angle gauge
(horizontal movement for high beam)
2
Beam angle gauge
(vertical movement for high beam)
3
Beam angle gauge
(vertical movement for low beam)
4
Beam angle gauge
(horizontal movement for low beam)
Before checking the headlight aim:
1. Be sure that the body around the headlight is not deformed.
2. Park the vehicle on a level spot.
3. The driver gets into the driver’s seat and puts the vehicle in
a state readying for a driving (with a full tank).
4. Bounce the vehicle several times.
Page 20 of 26
ELECTRICAL COMPONENTS
582
Adjusting the headlight aiming (high beam)
G64025
1
Adjusting bolt A
2
Adjusting bolt B
G64026
1
Bubble 2
Acceptable range
Vertical movement gauge: The bubble of the gauge should
not deviate from the center of the gauge by more than 2 marks
to either side of the gauge.
If the bubble is out of the acceptable range of the beam angle
gauge, adjust it using bolt A.
Page 23 of 26
ELECTRICAL COMPONENTS
585
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights such as headlights may
temporarily fog up when the lens becomes wet in the rain or in
a car wash. This is not a problem because the fogging is
caused by the temperature difference between the outside and
inside of the lens, just like the windshield fogs up in the rain.
However, if there is a large drop of water on the inside of the
lens, or if there is water pooled inside the light, contact your
Lexus dealer.LIGHT LOCATION
G64017
Light Bulbs Bulb No. W Type
1 Headlight (High beam) HB3 60 A
2 Parking light−−−5D
3 Front turn signal light−−−21 E
4 Headlight (Low beam) D4S 35 B
5 Front side marker light 194 5 D
6 Fog light HB4 51 C