instrument panel Lexus GS430 2006 Scheduled Maintenance Guide / LEXUS 2006 GS430/GS300 FROM JAN. 2006 PROD. (OM30786U) Owner's Guide

OCCUPANT RESTRAINT SYSTEMS
171
G16027a
In the following cases, contact your Lexus dealer as soon as
possible:
The SRS front airbags have been inflated.
 The front of the vehicle (shaded in the illustration) was
involved in an accident that was not severe enough to cause
the SRS front airbags to inflate. 
The pad section of the steering wheel, dashboard or lower
portion of instrument panel (shaded in the illustration) is
scratched, cracked, or otherwise damaged.
NOTICE
Do not disconnect the battery cables before contacting
your Lexus dealer.

TOUCH SCREEN
256
G18037
Depending on the position of the headlight switch, the
screen changes to either day mode or night mode.
To display the screen in the day mode even with the headlight
switch on, touch “DAY MODE” on the adjustment screen for
brightness and contrast control.
However, if the instrument panel light control switch is turned
fully to the right, mode switching cannot be done. It remains in
the day mode. In this case, “DAY MODE” is not shown on the
screen.
If the screen is set in the day mode with the headlight switch
turned on, this condition is memorized in the system even with
the engine turned off.
G18038
Color and tone adjustment
You can adjust the color and the tone while the DVD video and
video CD are being played.
COLOR “RED”: Strengthens the red color of the screen.
COLOR “GREEN”: Strengthens the green color of the screen.
TONE “+”: Strengthens the tone of the screen.
TONE “–”: Weakens the tone of the screen.

AIR CONDITIONING
265
G21005a
Driver side setting
Passenger side setting
Mixed settingSETTING OPERATION—manual control
When one of the manual control switches is depressed
while operating in automatic mode, the mode relevant to
the depressed switch is set. Other conditions continue to
be adjusted automatically.
If manual air flow selection is desired—
G21006
The outlets from which air is delivered can be selected
manually by touching the switch. The function of each mode
is as follows:
1
Panel— Air flows mainly from the instrument panel vents
and rear vents.
2 Bilevel— Air flows from the floor vents, the instrument
panel vents and rear vents.
When you set the temperature selector setting at about
the middle in automatic operation, warm air flows out of
the floor vents and relatively low−temperature air flows
out of the instrument panel vents and rear vents.

AIR CONDITIONING
269
When the windshield air flow button is pushed while operating
in automatic mode, the air conditioning is set to operate and the
OUTSIDE AIR mode is set. This is to clean up the front view
more quickly. If you want
to return the setting to the
RECIRCULATED AIR mode, push the air intake control button
once again.
Touch the “A/C” switch for dehumidified heating or cooling.
This setting clears the front view more quickly.
If you push the windshield air flow button once again while in
the windshield air flow mode, the mode then returns to the last
mode used.
CAUTION
Do not use the windshield air flow button during cooled
air operation in extremely humid weather. The
difference between the temperature of the outside air
and that of the windshield could cause the outer surface
of the windshield to fog up blocking your vision.
(c) Micro dust and pollen filter
This vehicle is equipped with a micro dust and pollen filter
mode. When this mode is activated, air from the vents will
remove pollen on the driver and passengers.
Use this mode to remove pollen quickly carried by the
driver or passengers or through the window in the days
with much pollen.
G21073
Push the micro dust and pollen filter button.
The indicator light comes on and RECIRCULATED AIR mode
is turned on. Air is delivered from the instrument panel vents
to the areas near the driver and passengers to remove pollen
on them. When the interior is purified sufficiently with fresh air
after about 3 minutes, this mode will be turned off automatically
and the indicator light will go out.

DRIVING TIPS
463
CARGO AND LUGGAGE
Stowage precautions
When stowing cargo and luggage in the vehicle,
observe the following:
Put cargo and luggage in the trunk when at all
possible. Be sure all items are secured in place.
 Be careful to keep the vehicle level. Placing the
weight as far forward as possible helps maintain
vehicle balance.
 For better fuel economy, do not carry unnecessary
weight.
CAUTION
Do not place anything on the package tray
behind the rear seatback. Such items may be
thrown about and possibly injure people in the
vehicle during sudden braking or an accident.
 Do not drive with objects left on top of the
instrument panel. They may interfere with the
driver’s field of view. Or they may move during
sharp vehicle acceleration or turning, and
impair the driver’s control of the vehicle. In an
accident they may injure the vehicle occupants.
NOTICE
Do not load the vehicle beyond the vehicle
capacity weight specified on the tire and loading
information label.

INTRODUCTION
508
VEHICLE IDENTIFICATION
G61001
The vehicle identification number (VIN) is the legal
identifier for your vehicle. This number is on the left top
of the instrument panel and can be seen through the
windshield from outside.
This is the primary identification number for your Lexus. It is
used in registering the ownership of your vehicle.
G61008
The vehicle identification number (VIN) is also on the
Certification Label.
G61009
GS430 GS300
The engine number is stamped on the engine block as
shown.

BODY
606
Carpets, Windows and Seat Belts
Begin by vacuuming thoroughly to remove as much dirt as
possible. Several types of foam cleaners are available; some
are in aerosol cans and others are powders or liquids which
you mix with water to produce a foam. To shampoo the
carpets, use a sponge or brush to apply the foam. Rub in
overlapping circles. Do not apply water − the best results are
obtained by keeping the carpet as dry as possible. Read the
shampoo instructions and follow them closely.
The seat belts may be cleaned with mild soap and water
or with lukewarm water.
Use a cloth or sponge. As you are cleaning, check the belts
for excessive wear, fraying or cuts.
NOTICE
 Use a good foamtype shampoo to clean the carpets.
 Do not use dye or bleach on the belts it may weaken
them.
 Do not use the belts until they become dry.
 The windows may be cleaned with any household
window cleaner.
 When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires.
Air Conditioning Control Panel, Audio
System, Instrument Panel, Console Panel,
and Switches
Use a soft damp cloth for cleaning.
Soak a clean soft cloth in water or lukewarm water then lightly
wipe off any dirt.
NOTICE
 Do not use organic substances (solvents, kerosene,
alcohol, gasoline, etc.) or alkaline or acidic solutions.
These chemicals can cause discoloring, staining or
peeling of the surface.
 If you use cleaners or polishing agents, make sure
their ingredients do not include the substances
mentioned above.
 If you use a liquid car freshener , do not spill the liquid
onto the vehicle’s interior surfaces. It may contain
the ingredients ment ioned above. Immediately clean
any spill using the method mentioned above.
If you have any questions about the cleaning of your
Lexus, your local Lexus dealer will be pleased to answer
them.