change time Lexus IS300 2005 Basic Functions / LEXUS 2005 IS300 (OM53489U) User Guide

AUDIO
212(b) Presetting a station
SV22073
1. Tune in the desired station.
2. Push
one of the station selector buttons ( 1±6 ) and hold
it until a beep is heard. This sets the station to the button
and the button number ( 1±6 ) appears on the display.
Each button can store one AM station and two FM stations. To
change the preset station to a different one, follow the same
procedure.
The preset station memory is cancelled when the power
source is interrupted by battery disconnection or a blown fuse. (c) Selecting a station
Tune in the desired station using one of the following methods.
SV22074
Preset
tuning: Push the button ( 1±6 ) for the station you want.
The button number ( 1±6 ) and station frequency appear on the
display.
Manual tuning: Turn the ªAUDIO CONTROLº knob clockwise
to step up the frequency. Turn the knob counterclockwise to
step down the frequency. (See page 211.)
Seek tuning: Push the ªSEEKº button. The radio will begin
seeking up or down for a station of the nearest frequency and
will stop on reception. Each time you push the button, the
stations will be searched automatically one after another.
04 06.30

AUDIO
214(d) RDS (Radio Data System)
SV22077
This function is operative at any time. Under the ªFMº mode,
ªRDSº appears on the display as long as the audio system
picks up RDS stations. When the audio system is in other than
ªFMº mode, or it can not pick up RDS stations, ªRDSº is off.
TYPE (Program type):
When you push the ªTYPE
º or ªTYPE  º button while
receiving an RDS station, the current program type appears on
the display.
If you push the ªTYPE º or ªTYPE  º button when ªRDSº is
off on the display, ªNO_PTYº appears.
Each time you push the ªTYPE º or ªTYPE º button, the
program type changes as in the following:
 ROCK
 EASY LIS (Easy listening)
 CLS/JAZZ (Classical music and jazz)
 R&B (Rhythm and Blues)
 INFORM (Information)
 RELIGION
 MISC
 ALERT (Emergency message)
TRAF (Traffic) function: A station that regularly
broadcasts traffic information is automatically located.
When you push the ªTRAFº button in the ªFMº mode, ªTRAF
SEEKº appears on the display and the radio will start seeking
any traffic program station.
If no traf fic program station is found, ªNO TRAF INFOº appears
on the display for a few seconds and the display returns to the
previous mode.
04 06.30

AUDIO
222(c) Selecting a desired CD (with six CD changer only)
SV22087
Push the ªDISC 
º or ªDISC º button to select the CD
number.
Push the button several times until the desired CD number
appears on the display. When you release the button, the
player will start playing the selected CD from the first track. (d) Searching for a desired track
SV22088
Push the ªSCANº button briefly.
ªSCANº will appear on the display. The CD player will play the
next track for 10 seconds, then scan again. To select a track,
push the ªSCANº button a second time. If the player reaches
the end of the CD, it will continue scanning at track 1.
After all the tracks are scanned in one pass, normal play
resumes.
04 06.30

AUDIO
223
(e) Searching
for a desired CD (with six CD changer only)
SV22089
Push the ªSCANº button until you hear a beep.
With ªD´SCANº on the display, the program at the beginning of
each CD will be played for 10 seconds. To continue listening
to the program of your choice, push the ªSCANº button a
second time.
After all the CDs in the player are scanned in one pass, the
scan function is cancelled. (f) Selecting a desired track
SV22090
ªTRACKº button: Use for direct access to a desired track.
Push either side of the ªTRACKº button several times until the
desired track number appears on the display. As you release
the button, the player will start playing the selected track from
the beginning.
ªFast forwardº button.
Push
the ª

º button and hold it to fast forward the CD. When
you release the button, the CD player will resume playing from
that position.
ªReverseº button.
Push the ª º button and hold it to reverse the CD. When you
release the button, the CD player will resume playing.
04 06.30

STARTING AND DRIVING
233

To ensure that the three±way catalytic converter and
the entire emission control system operate properly,your vehicle must receive the periodic inspectionsrequired by the Lexus Maintenance Schedule . Forscheduled maintenance information, refer to theªOwner's Manual Supplement/ScheduledMaintenanceº.ENGINE EXHAUST CAUTION
CAUTION
 Avoid i nhaling the engine exhaust. It contains carbon
monoxide, which is a colorless and odorless gas. It
can cause unconsciousness or even death.
 Make sure the exhaust system has no holes or loose
connections. The system should be checked from
time to time. If you hit something, or notice a change
in the sound of the exhaust, have the system checked
immediately.
 Do not run the engine in a garage or enclosed area
except for the time needed to drive the vehicle in or
out. The exhaust gases cannot escape, making this
a particularly dangerous situation.
 Do not remain for a long time in a parked vehicle with
the engine running. If it is unavoidable, however, do
so only in an unconfined area and adjust the heating
or cooling system to force outside air into the vehicle.
 Keep the trunk lid or back door closed while driving.
An open or unsealed trunk lid or back door may
cause exhaust gases to be drawn into the vehicle.
04 06.30

STARTING AND DRIVING
244
3Shift into the ª2º position. The transmission will downshift
to second gear when the vehicle speed is or becomes
lower than the speed listed below and stronger engine
braking than that of ª3º position will be obtained.
4Shift into the ªLº position. The transmission will downshift
to first gear when the vehicle speed is or becomes lower
than the speed listed below and maximum engine braking
will be enabled.
ª4º 177 km/h (110 mph)
ª3º 123 km/h (76 mph)
ª2º 81 km/h (51 mph)
ªLº 17 km/h (11 mph)
CAUTION
Be careful when downshifting on a slippery surface. The
abrupt change in engine speed could cause the vehicle
to skid or spin.
(d) Using the ª3º, ª2º and ªLº positions
The ª3º, ª2º and ªLº positions are used for strong eng\
ine
braking as described previously.
With the selector lever in ª3º, ª2º or ªLº, you can start t\
he vehicle
in motion as with the lever in ªDº.
With the selector lever in ª3º or ª2º, the vehicle will star\
t in the
first gear and automatically shift to third or second gear.
With the selector lever in ªLº, the transmission is engaged in
the first gear.
NOTICE
Be careful not to over±rev the engine. Watch the tachometer to keep engine rpm from going into thered zone. The approximate maximum allowablespeed for each position is given below for yourreference:
ª3º 124 km/h (78 mph)
. . . . . . . . . . . . . . . . . . .
ª2º 81 km/h (51 mph)
. . . . . . . . . . . . . . . . . . .
ªLº 52 km/h (33 mph)
. . . . . . . . . . . . . . . . . . .
Do not continue hill climbing or hard towing for a long
time in the ª3º, ª2º or ªLº position. This may causesevere automatic transmission damage from
overheating. To prevent such damage, ª4º positionshould be used in hill climbing or hard towing.
04 06.30

ENGINE
332The amount of engine oil consumed depends on the
viscosity of the oil, the quality of the oil and the way the
vehicle is driven.
More oil is consumed under driving conditions such as high
speeds and frequent acceleration and deceleration.
A new engine consumes more oil, since its pistons, piston rings
and cylinder walls have not become conditioned.
Oil consumption:
Max. 1.0L per 1000 km (1.1 qts./600 miles,
0.9 Imp. qts./600 miles)
When judging the amount of oil consumption, keep in
mind that the oil may have become diluted, making it
difficult to judge the true level accurately.
For example, if a vehicle is used for repeated short trips and
consumes a normal amount of oil, the dipstick may not show
any drop in the oil level at all, even after 1000 km (600 miles)
or more. This is because the oil is gradually becoming diluted
with fuel or moisture, making it appear that the oil level has not
changed.
The diluting ingredients evaporate out when the vehicle is then
driven at high speeds, as on an expressway, making it appear
that oil is excessively consumed after driving at high speeds.
Importance of engine oil level check
One of the most important points in proper vehicle
maintenance is to keep the engine oil at the optimum level so
that oil function will not be impaired. Therefore, it is essential
that the oil level be checked regularly. Lexus recommends that
the oil level be checked every time you refuel the vehicle.
NOTICE
Failure to check the oil level regularly could lead to serious engine trouble due to insufficient oil.
For detailed information on oil level check, see ªChecking the
engine oil levelº on page 333.
04 06.30