reset Lexus IS300h 2014 Owner's Guide
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2014, Model line: IS300h, Model: Lexus IS300h 2014Pages: 612, PDF Size: 111.33 MB
Page 452 of 612

4527-3. Do-it-yourself maintenance
IS300h_EE(OM53C61E)
■How to initialize the tire pressure warning system
Park the vehicle in a safe place and turn the power switch off.
Initialization cannot be performed while the vehicle is moving.
Adjust the tire inflation pressure to the specified cold tire inflation pressure
level. (→P. 5 6 8 )
Make sure to adjust the tire pressure to the specified cold tire inflation pressure
level. The tire pressure warning system will operate based on this pressure level.
Turn the power switch to ON mode.
Press and hold the tire pressure
warning reset switch until the tire
pressure warning light blinks
slowly 3 times.
Wait for a few minutes with the power switch in ON mode and then turn
the power switch off.
◆Registering ID codes
The tire pressure warning valve and transmitter is equipped with a unique ID
code. When replacing a tire pressure warning valve and transmitter, it is nec-
essary to register the ID code. Have the ID code registered by any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional.
1
2
3
4
5
IS300h_EE_OM53C61E.book 452 ページ 2014年5月20日 火曜日 午後5時40分
Page 454 of 612

4547-3. Do-it-yourself maintenance
IS300h_EE(OM53C61E)
■Situations in which the tire pressure warning system may not operate properly
●In the following cases, the tire pressure warning system may not operate properly.
• If non-genuine Lexus wheels are used.
• A tire has been replaced with a tire that is not an OE (Original Equipment) tire.
• A tire has been replaced with a tire that is not of the specified size.
• Tire chains etc. are equipped.
• Lock nuts are equipped.
• An auxiliary-supported run-flat tire is equipped.
• If a window tint that affects the radio wave signals is installed.
• If there is a lot of snow or ice on the vehicle, particularly around the wheels or wheel
housings.
• If the tire inflation pressure is extremely higher than the specified level.
• If tires not equipped with tire pressure warning valves and transmitters are used.
• If the ID code on the tire pressure warning valves and transmitters is not registered
in the tire pressure warning computer.
●Performance may be affected in the following situations.
• Near a TV tower, electric power plant, gas station, radio station, large display, air-
port or other facility that generates strong radio waves or electrical noise
• When carrying a portable radio, cellular phone, cordless phone or other wireless
communication device
●When the vehicle is parked, the time taken for the warning to start or go off could be
extended.
●When tire inflation pressure declines rapidly for example when a tire has burst, the
warning may not function.
■The initialization operation
●Make sure to carry out initialization after adjusting the tire inflation pressure.
Also, make sure the tires are cold before carrying out initialization or tire inflation pres-
sure adjustment.
●If you have accidentally turned the power switch off during initialization, it is not neces-
sary to press the reset switch again as initialization will restart automatically when the
power switch has been turned to ON mode for the next time.
●If you accidentally press the reset switch when initialization is not necessary, adjust the
tire inflation pressure to the specified level when the tires are cold, and conduct initial-
ization again.
■Warning performance of the tire pressure warning system
The warning of the tire pressure warning system will change in accordance with the con-
ditions under which it was initialized. For this reason, the system may give a warning even
if the tire pressure does not reach a low enough level, or if the pressure is higher than the
pressure that was adjusted to when the system was initialized.
IS300h_EE_OM53C61E.book 454 ページ 2014年5月20日 火曜日 午後5時40分
Page 455 of 612

4557-3. Do-it-yourself maintenance
7
Maintenance and care
IS300h_EE(OM53C61E)
■When initialization of the tire pressure warning system has failed
Initialization can be completed in a few minutes. However, in the following cases, the set-
tings have not been recorded and the system will not operate properly. If repeated
attempts to record tire inflation pressure settings are unsuccessful, have the vehicle
inspected by any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional.
●When operating the tire pressure warning reset switch, the tire pressure warning light
does not blink 3 times.
●After carrying out the initialization procedure, the tire pressure warning light blinks for 1
minute then stays on after driving for 20 minutes.
■Registering ID codes
The ID codes of the tire pressure warning valve and transmitters for two sets of wheels
can be registered.
It is not necessary to register the ID codes when replacing normal tires with snow tires, if
the ID codes for the wheels of both normal tires and snow tires are registered before-
hand.
For information about changing ID codes, ask any authorized Lexus dealer or repairer,
or another duly qualified and equipped professional.
IS300h_EE_OM53C61E.book 455 ページ 2014年5月20日 火曜日 午後5時40分
Page 457 of 612

4577-3. Do-it-yourself maintenance
7
Maintenance and care
IS300h_EE(OM53C61E)
CAUTION
■When inspecting or replacing tires
Observe the following precautions to prevent accidents.
Failure to do so may cause damage to parts of the drivetrain as well as dangerous han-
dling characteristics, which may lead to an accident resulting in death or serious injury.
●Do not mix tires of different makes, models or tread patterns.
Also, do not mix tires of remarkably different treadwear.
●Do not use tire sizes other than those recommended by Lexus.
●Do not mix differently constructed tires (radial, bias-belted or bias-ply tires).
●Do not mix summer, all season and snow tires.
●Do not use tires that have been used on another vehicle.
Do not use tires if you do not know how they were used previously.
●Vehicles with an emergency tire puncture repair kit: Do not tow anything if a tire that
has been repaired using the emergency tire puncture repair kit is installed. The load
on the tire may cause unexpected damage to the tire.
■When initializing the tire pressure warning system
Do not operate the tire pressure warning reset switch without first adjusting the tire
inflation pressure to the specified level. Otherwise, the tire pressure warning light may
not come on even if the tire inflation pressure is low, or it may come on when the tire
inflation pressure is actually normal.
IS300h_EE_OM53C61E.book 457 ページ 2014年5月20日 火曜日 午後5時40分
Page 518 of 612

5188-2. Steps to take in an emergency
IS300h_EE(OM53C61E)
(If equipped)
Indicates that all maintenance listed in the maintenance
schedule*1 corresponding to the current vehicle mile-
age is necessary.
(The indicator will not work properly unless the mainte-
nance data has been reset.)
→Perform the necessary maintenance. Please reset
the maintenance data after the maintenance is per-
formed (→P. 4 4 2 )
(If equipped)
Indicates that the Automatic High Beam switch is
pressed while the headlights are in low beam.
→Turn the high beam on and press the Automatic
High Beam switch again.
(If equipped)
Indicates that, since the VSC (Vehicle Stability Control)
system was turned off, the pre-crash brake system oper-
ation is stopped
→Tu r n t h e V S C o n . (→P. 2 8 8 )
(If equipped)
Indicates that the PCS (Pre-Crash Safety system) is not
currently functional because the grille cover or the sen-
sor is dirty
→Check the grille cover and the sensor and clean
them if they are dirty.
Indicates that operation of large electricity consuming
systems such as the air conditioning system are sus-
pended
→Stop using unnecessary electric components to
reduce electricity consumption. Wait a while until
the electric power supply is restored.
(If equipped)
Indicates that the LDA (Lane Departure Alert) system
cannot be used because the vehicle speed is lower than
approximately 50 km/h (32 mph)
→Drive the vehicle at 50 km/h (32 mph) or higher.
Wa r n i n g m e s s a g eDetails/Actions
(Flashes)
IS300h_EE_OM53C61E.book 518 ページ 2014年5月20日 火曜日 午後5時40分
Page 520 of 612

5208-2. Steps to take in an emergency
IS300h_EE(OM53C61E)
■Warning messages
The warning message illustrations used are intended as examples, and may differ from
the image that is actually displayed on the multi-information display.
■Warning message in radar cruise mode (if equipped)
In the following situations, the warning message may not be displayed even if vehicle-to-
vehicle distance decreases:
●When your vehicle and the vehicle ahead are traveling at the same speed or the vehicle
ahead is traveling more quickly than your vehicle
●When the vehicle ahead is traveling at a very low speed
●Immediately after cruise control speed is set
●At the instant the accelerator pedal is depressed
■The LDA (Lane Departure Alert) lane departure warning function (if equipped)
In the following situations, the warning message will not be displayed even if a lane line is
crossed.
●When the vehicle speed deviates from the operating range of the LDA system func-
tions
●When the lane lines cannot be recognized
■After changing the engine oil (if equipped)
Make sure to reset the oil change system. (→P. 4 4 2 )
■Warning buzzer
→P. 5 0 7
IS300h_EE_OM53C61E.book 520 ページ 2014年5月20日 火曜日 午後5時40分
Page 574 of 612

5749-2. Customization
IS300h_EE(OM53C61E)
Some function settings are changed simultaneously with other functions being
customized. Contact any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
Vehicles with a Remote Touch or Lexus Display Audio controller: Settings that
can be changed using the Remote Touch or Lexus Display Audio controller
Vehicles with a Remote Touch or Lexus Display Audio controller: Settings that
can be changed using the meter control switches
Vehicles without a Remote Touch or Lexus Display Audio controller: Settings
that can be changed using the meter control switches
Settings that can be changed by any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional
Definition of symbols: O = Available, — = Not available
■Gauges, meters and multi-information display (→P. 104, 109, 115)
Customizable features
1
2
3
4
Function*1Default settingCustomized setting
Language*2English
French
—OO—
German
Spanish
Italian
Russian
Units*2km (L/100 km)km (km/L)—OO—miles (MPG)
Maintenance system
initializationOFFON—OO—
EV indicatorON
(Self-lighting)OFF—OO—
switch settings*3Drive
information 1Desired status
screen
*4—OO—
Drive information 1
Current fuel
economy
*5—OO—Average fuel
economy (after
reset)
1234
IS300h_EE_OM53C61E.book 574 ページ 2014年5月20日 火曜日 午後5時40分
Page 575 of 612

575
9 9-2. Customization
Vehicle specifications
IS300h_EE(OM53C61E)
*1: For details about each function: →P. 1 1 7
*2: The default setting varies according to country.
*3:Except F SPORT models
*4: Some status screens cannot be registered (indicated on multi-information display).
*5: 2 of the following items: current fuel consumption, average fuel economy (after reset),
average fuel economy (after refuel), average fuel economy (after start), average vehi-
cle speed (after reset), average vehicle speed (after start), distance (driving range),
distance (after start), elapsed time (after reset), elapsed time (after start), blank.
*6:F SPORT models
*7: The customized setting varies according to country.
Drive information 2
Distance
(range)
*5—OO—Average speed
(after reset)
Pop-up displayONOFF—OO—
Accent color*3BlueRedOOO—
Tachometer settingsON (Self-
changing)
Hybrid System Indi-
cator (Always)
—OO—Tachometer
(Always)
Needle*6BlueRed—OO—White
Speed indicator*6OFF
50 to 200 km/h
(30 to 125 mph)
*7
—OO—50 to 160 km/h
(30 to 100 mph)*7
REV indicator*64000 r/min
2000 to 6000
r/m i n
—OO—
OFF
REV peak*6ONOFF—OO—
Function*1Default settingCustomized setting1234
IS300h_EE_OM53C61E.book 575 ページ 2014年5月20日 火曜日 午後5時40分
Page 608 of 612

608Alphabetical index
IS300h_EE(OM53C61E)
Outside rear view mirror
switches................................................ 180
Paddle shift switches ......................... 218
PCS OFF switch ................................ 293
Power door lock switch ...................139
Power switch .......................................209
Power window switches ................. 184
Rear sunshade switch...................... 422
Rear window and outside rear
view mirror defoggers
switch....................................................404
Seat heater switches ......................... 410
Seat ventilator switches ................... 410
Snow mode switch ............................. 217
Talk switch ............................................. 378
Telephone switches.......................... 378
Tilt and telescopic steering
control switch .....................................176
Tire pressure warning reset
switch.................................................... 452
Trunk opener switch ..........................143
Trunk opener main switch ..............145
Vehicle-to-vehicle distance
button ................................................... 252
VSC OFF switch .............................. 288
Window lock switch.......................... 184
Windshield wiper de-icer
switch................................................... 405
Windshield wipers
and washer switch ......................... 235Tachometer ............................................. 109
Tachometer settings .............................. 117
Tail lights................................................... 226
Light switch............................................226
Replacing light bulbs ....................... 490
Talk switch ............................................... 378
Telephone switches ............................. 378
Theft deterrent system
Alarm .......................................................... 96
Double locking system...................... 95
Immobilizer system ............................. 90
Intrusion sensor and tilt sensor...... 99
Tire inflation pressure ......................... 465
Maintenance data .............................568
Tire inflation pressure display
function ................................................. 451
Warning light.......................................505
Tire pressure warning system ...........451
Function.................................................... 451
Initializing ................................................. 451
Installing tire pressure warning
valves and transmitters ................. 451
Registering ID codes....................... 452
Tire pressure warning reset
switch ................................................... 452
Warning light.......................................505T
IS300h_EE_OM53C61E.book 608 ページ 2014年5月20日 火曜日 午後5時40分