wheel Lexus IS300h 2017 Owner's Manual

6068-2. Steps to take in an emergency
IS300h_EE(OM53D89E)
Con-
tinuous
An attempt was made to lock the
doors using the smart entry & start
system while the electronic key was still inside the vehicle.
 Retrieve the electronic key
from the vehicle and lock the doors again.
OnceCon-
tinuous
An attempt was made to lock either
front door by opening a door and
putting the inside lock button into the lock position, then closing the
door by pulling on the outside door
handle with the electronic key still inside the vehicle.
 Retrieve the electronic key
from the vehicle and lock the doors again.
Once
The electronic key has a low battery.
 Replace the electronic key bat-
tery. ( P. 549)
Once
The steering lock could not be
released within 3 seconds of the power switch being pressed.
 Press the power switch while
depressing the brake pedal and moving the steering wheel left
and right.
Interior buzzerExteriorbuzzerWarning messageDetails/Actions
(Vehicles with the entry function)
(Flashes)

6108-2. Steps to take in an emergency
IS300h_EE(OM53D89E)
If you have a flat tire (vehicles with emergency tire
puncture repair kit)
Your vehicle is not equipped with a spar e tire, but instead is equipped with an
emergency tire puncture repair kit.
A puncture caused by a nail or screw passing through the tire tread can be
repaired temporarily with the emer gency tire puncture repair kit.
WARNING
■If you have a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat ti re can damage the tire and the wheel beyond
repair, which could result in an accident.

6118-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
●Stop the vehicle in a safe place on a hard, flat surface.
●Set the parking brake.
●Shift the shift lever to P.
●Stop the hybrid system.
●Turn on the emergency flashers. (P. 566)
●Check the degree of the tire damage.
A tire should only be repaired with
the emergency tire puncture repair
kit if the damage is caused by a nail
or screw passing through the tire
tread.
• Do not remove the nail or screw
from the tire. Removing the
object may widen the opening
and disenable emergency repair
with the kit.
• To avoid sealant leakage, move the vehi cle until the area of the puncture, if
known, is positioned at the top of the tire.
■A flat tire that cannot be repaired with the emergency tire puncture repair kit
In the following cases, the tire cannot be repaired with the emergency tire puncture
repair kit. Contact any authorized Lexus retaile r or Lexus authorized repairer, or any reli-
able repairer.
●When the tire is damaged due to driving without sufficient air pressure
●When the tire lost air pressure due to a crack or damage in the tire sidewall
●When the tire is visibly separated from the wheel
●When the cut or damage to the tread is 4 mm (0.16 in.) long or more
●When the wheel is damaged
●When two or more tires have been punctured
●When there is more than one hole or cut in the damaged tire
Before repairing the vehicle

6168-2. Steps to take in an emergency
IS300h_EE(OM53D89E)
Remove the sticker.
Attach the 2 stickers as shown.
Remove any dirt and moisture from the wheel before attaching the label. If it is
impossible to attach the label, make sure
to tell any authorized Lexus retailer or Lexus authorized repairer, or any reli-
able repairer when you have them
repair and replace the tire that sealant is injected.
8
9

6218-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
■Emergency tire puncture repair kit
●The sealant has a limited lifespan. The expiry date is marked on the bottle. The sealant
should be replaced before the expiry date. Contact any authorized Lexus retailer or Lexus authorized repairer, or any reliable repairer for replacement.
●The sealant stored in the emergency tire puncture repair kit can be used only once to
temporarily repair a single tire. If the sealant in the bottle and other parts of the kit have been used and need to be purchased, cont act any authorized Lexus retailer or Lexus
authorized repairer, or any reliable repairer.
●The sealant can be used when the outside temperature is from -30C (-22F) to 60C (140 F).
●The kit is exclusively designed for size and type of tires originally installed on your vehi-
cle. Do not use it for tires that a different size than the original ones, or for any other purposes.
●If the sealant gets on yo ur clothes, it may stain.
●If the sealant adheres to a wheel or the surface of the vehicle body, the stain may not be removable if it is not cleaned at once. I mmediately wipe away the sealant with a wet
cloth.
●During operation of the kit, a loud operation noise is produced. This does not indicate a malfunction.
■After a tire is repaired with the emergency tire puncture repair kit
●The tire pressure warning valve and transmitter should be replaced.
●Even if the tire inflation pressure is at the recommended level, the tire pressure warning
light may come on/flash.
■Note for checking the emergency tire puncture repair kit
Check the sealant expiry date occasionally.
The expiry date is shown on the bottle. Do not use sealant whose expiry date has already
passed. Otherwise, repairs conducted using the emergency tire puncture repair kit may not be performed properly.

6238-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
WARNING
■When fixing the flat tire
●Stop your vehicle in a safe and flat area.
●Do not touch the wheels or the area around the brakes immediately after the vehicle
has been driven. After the vehicle has been driven, the wheels and the area around the brakes may be
extremely hot. Touching these areas with hands, feet or other body parts may result in
burns.
●Connect the valve and hose securely wi th the tire installed on the vehicle.
●If the hose is not properly connected to the valve, air leakage may occur or sealant
may be sprayed out.
●If the hose comes off the valve while inflating the tire, there is a risk that the hose will
move abruptly due to air pressure.
●After inflation of the tire ha s completed, the sealant may splatter when the hose is dis- connected or some air is let out of the tire.
●Follow the operation procedure to repair the tire. If the procedure is not followed, the
sealant may spray out.
●Keep back from the tire while it is being re paired, as there is a chance of it bursting
while the repair operation is being performed. If you notice any cracks or deforma-
tion of the tire, turn off the compressor sw itch and stop the repair operation immedi- ately.
●The kit may overheat if operated for a long period of time. Do not operate the com-
pressor continuously for more than 10 minutes.
●Parts of the kit become hot during operatio n. Be careful handling the kit during and
after operation.
●Do not attach the vehicle speed warning stic ker to an area other than the one indi- cated. If the sticker is attached to an area where an SRS airbag is located, such as the
pad of the steering wheel, it may prevent the SRS air bag from operating properly.
■Driving to spread the liquid sealant evenly
●Drive the vehicle carefully at a low speed. Be especially careful when turning and cor-
nering.
●If the vehicle does not drive straight or you feel a pull through the steering wheel, stop the vehicle and check the following:
• Tire condition. The tire may have separated from the wheel.
• Tire inflation pressure. If tire infl ation pressure is 130 kPa (1.3 kgf/cm2 or bar, 19 psi) or below, this may indi cate severe tire damage.

6258-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
■Run-flat tires (A “RFT” or “DSST” mark is molded on the sidewall)
Take your vehicle to the nearest
Lexus dealer or authorized tire
dealer as soon as possible if any tire
goes flat.
The vehicle can be driven for a maxi- mum of 300 km (186 miles) at a
speed below 60 km/h (37 mph)
after the tire pressure warning light comes on. ( P. 578)
■In some conditions (such as at high temperatures)
You cannot continue driving for up to 300 km (186 miles).
■For the detailed informat ion on run-flat tires
See the tire warranty booklet.
If you have a flat tire (vehicles with run-flat tires)
Your vehicle is not equipped with a sp are tire, but instead you can continue
driving the vehicle with run-flat tires even if any tire goes flat.In this case, slow
down and drive with extra caution.
NOTICE
■When replacing the tires
When removing or fitting the wheels, tires or the tire pressure warning valve and trans-
mitter, contact any authorized Lexus retailer or Lexus authorized repairer, or any reli- able repairer as the tire pressure warning valve and transmitter may be damaged if not
handled correctly.
■When driving over bumps
If a vehicle has a flat tire, the vehicle height will be lower than usual. Ensure that nothing
strikes the bottom of the vehicle.
■To avoid damage to the tire pressure warning valves and transmitters
When a tire is repaired with liquid sealants , the tire pressure warning valve and trans-
mitter may not operate properly. If a liqui d sealant is used, contact any authorized
Lexus retailer or Lexus authoriz ed repairer, or any reliable repairer or other qualified service shop as soon as possible. Make sure to replace the tire pressure warning valve
and transmitter when replacing the tire. ( P. 526)

6418-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53D89E)
Stop the hybrid system. Set the parking brake and shift the shift lever to P.
Remove the mud, snow or sand from around the rear wheels.
Place wood, stones or some other materi al under the rear wheels to help pro-
vide traction.
Restart the hybrid system.
Shift the shift lever to D or R and release the parking brake. Then, while exer-
cising caution, depress the accelerator pedal.
■When it is difficult to free the vehicle
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt or snow:
Press to turn off TRC.
1
2
3
4
5

6428-2. Steps to take in an emergency
IS300h_EE(OM53D89E)
WARNING
■When attempting to free a stuck vehicle
If you choose to push the vehicle back and forth to free it, make sure the surrounding
area is clear to avoid striking other vehicles, objects or people. The vehicle may also
lunge forward or lunge back suddenly as it becomes free. Use extreme caution.
■When shifting the shift lever
Be careful not to shift the shift lever with the accelerator pedal depressed.
This may lead to unexpected rapid acceleration of the vehicle that may cause an acci- dent resulting in death or serious injury.
NOTICE
■To avoid damaging the transmission and other components
●Avoid spinning the rear wheels and depre ssing the accelerator pedal more than nec-
essary.
●If the vehicle remains stuck even after th ese procedures are performed, the vehicle may require towing to be freed.

644
IS300h_EE(OM53D89E)
9-1. Specifications
*1: Unladen vehicle
*2: Vehicles with 255/35R18 tires
*3: AVE30L-AEXEHW and AVE30R-AEXEHW models
*4: AVE30L-AEXLHW and AVE30R-AEXLHW models
The model code is indicated on the manufacturer’s label. (P. 645)
*5: Vehicles with a towing package
Maintenance data (fuel, oil level, etc.)
Dimensions and weights
Overall length 4680 mm (184.3 in.)
Overall width 1810 mm (71.3 in.)
Overall height*11430 mm (56.3 in.)
Wheelbase 2800 mm (110.2 in.)
Tread*1
Front 1535 mm (60.4 in.)
Rear 1550 mm (61.0 in.)
1540 mm (60.6 in.)*2
Gross vehicle mass*52130 kg (4696 lb.)*3
2145 kg (4729 lb.)*4
Maximum permissi-
ble axle capacity*5
Front 1090 kg (2403 lb.)
Rear 1200 kg (2646 lb.)
Drawbar load*575 kg (165 lb.)
Towing capacity*5With brake 750 kg (1653 lb.)
Without brake 750 kg (1653 lb.)