oil dipstick lexus LC500 2018 Owner's Manual

318
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
LC500
Fuse box ( P.350)
Engine oil level dipstick ( P.319)
Engine coolant reservoir ( P.322)
Engine oil filler cap ( P.320)
Washer fluid tank ( P.324)
Electric cooling fan
Condenser ( P.323)
Radiator ( P.323)
For right-hand drive vehicles:
The fuse box is located on the opposite side of the engine compartment.
Engine compartment
Components
A
B
C
D
E
F
G
H

319
6
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
Maintenance and care
LC500h
Engine oil level dipstick ( P.319)
Power control unit coolant reservoir ( P.323)
Engine oil filler cap ( P.320)
Fuse boxes ( P.350)
Washer fluid tank ( P.324)
Engine coolant reservoir ( P.322)
Electric cooling fan
Condenser ( P.323)
Radiator ( P.323)
For right-hand drive vehicles:
One of the fuse boxes is located on the opposite side of the engine compartment.
■12-volt battery
 P.325
With the engine at operating tempera-
ture and turned off, check the oil level
on the dipstick.
A
B
C
D
E
F
G
H
I
Checking and adding the engine
oil

320
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
■Checking the engine oil
1 Park the vehicle on level ground.
LC500
After warming up the engine and turning it
off, wait more than 5 minutes for the oil to
drain back into the bottom of the engine.
LC500h
After warming up the engine and turning
off the hybrid system, wait more than 5
minutes for the oil to drain back into the
bottom of the engine.
2 Holding a rag under the end, pull
the dipstick out.
LC500
LC500h
3 Wipe the dipstick clean.
4 Reinsert the dipstick fully.
5 Holding a rag under the end, pull
the dipstick out and check the oil
level.
Low
Normal
Excessive
The shape of the dipstick may differ
depending on the type of vehicle or engine.
6 Wipe the dipstick and reinsert it
fully.
■Checking the oil type and prepar-
ing the items
Make sure to check the oil type and
prepare the items needed before add-
ing oil.
 Engine oil selection
P.413, 414
Oil quantity (Low  Full)
1.5 L (1.6 qt., 1.3 Imp. qt.)
Item
Clean funnel
■Adding engine oil
If the oil level is below or near the low
level mark, add engine oil of the same
type as that already in the engine.
A
B
C

321
6
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
Maintenance and care
LC500
LC500h
1 Remove the oil filler cap by turning
it counterclockwise.
2 Add engine oil slowly, checking the
dipstick.
3 Install the oil filler cap by turning it
clockwise.
■Engine oil consumption
A certain amount of engine oil will be con-
sumed while driving. In the following situa- tions, oil consumption may increase, and engine oil may need to be refilled in
between oil maintenance intervals.
●When the engine is new, for example
directly after purchasing the vehicle or after replacing the engine
●If low quality oil or oil of an inappropriate viscosity is used
●When driving at high engine speeds or with a heavy load, or when driving while accelerating or decelerating frequently
●When leaving the engine idling for a long time, or when driving frequently through heavy traffic
■After changing the engine oil (LC500h)
The engine oil maintenance data should be reset. Perform the following procedures:
1 While the vehicle is stopped, press
of the meter control switches.
2 Press or of the meter control
switches, and select .
3 Press or of the meter control
switches, select “Vehicle Settings”, and
then press “OK”.
4 Press or of the meter control
switches, select “Oil Maintenance”, and
then press “OK”.
5 Select “Yes” and then press “OK”.
A message will be displayed on the multi- information display.
WARNING
■Used engine oil
●Used engine oil contains potentially harmful contaminants which may cause skin disorders such as inflamma-
tion and skin cancer, so care should be taken to avoid prolonged and repeated contact. To remove used
engine oil from your skin, wash thor- oughly with soap and water.

322
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
The coolant level is satisfactory if it is
between the “F” and “L” lines on the
reservoir when the engine tem> is cold.
■Engine coolant reservoir
LC500
Reservoir cap
“F” line
“L” line
If the level is on or below the “L” line, add
coolant up to the “F” line. ( P.400)
LC500h
Reservoir cap
“F” line
“L” line
If the level is on or below the “L” line, add
coolant up to the “F” line. ( P.403)
WARNING
●Dispose of used oil and filters only in a safe and acceptable manner. Do not dispose of used oil and filters in house-
hold trash, in sewers or onto the ground. Call any authorized Lexus retailer or
Lexus authorized repairer, or any reli- able repairer, service station or auto parts store for information concerning
recycling or disposal.
●Do not leave used engine oil within the reach of children.
NOTICE
■To prevent serious engine damage
Check the oil level on a regular basis.
■When replacing the engine oil
●Be careful not to spill engine oil on the vehicle components.
●Avoid overfilling, or the engine could
be damaged.
●Check the oil level on the dipstick every time you refill the vehicle.
●Be sure the engine oil filler cap is prop-erly tightened.
Checking the coolant
A
B
C
A
B
C

413
8
-$@-$I@0.@0.&@ &&

8-1. Specifications
Vehicle specifications
LC500
■Oil capacity (Drain and refill [Ref-
erence*])
*: The engine oil capacity is a reference
quantity to be used when changing the
engine oil. Warm up and turn off the
engine, wait more than 5 minutes, and
check the oil level on the dipstick.
■Engine oil selection
“Toyota Genuine Motor Oil” is used in
your Lexus vehicle. Lexus recom-
mends the use of approved “Toyota
Genuine Motor Oil”. Another motor
oil of matching quality can also be
used.
Oil grade:
5W-30 and 10W-30:
API grade SL “Energy-Conserving”,
SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC
multigrade engine oil
15W-40:
API grade SL, SM or SN multigrade
engine oil
Recommended viscosity (SAE):
SAE 5W-30 is filled into your Lexus
vehicle at manufacturing, and the best
choice for good fuel economy and
good starting in cold weather.
If you use SAE 10W-30 or a higher vis-
cosity engine oil in extremely low tem-
peratures, the engine may become
difficult to start, so SAE 5W-30 engine
oil is recommended.
Temperature range anticipated
before next oil change.
Preferred
Oil viscosity (5W-30 is explained here
as an example):
• The 5W in 5W-30 indicates the
characteristic of the oil which allows
cold startability. Oils with a lower
value before the W allow for easier
starting of the engine in cold
weather.
• The 30 in 5W-30 indicates the vis-
cosity characteristic of the oil when
the oil is at high temperature. An oil
with a higher viscosity (one with a
Capacity3.6 Ah
Quantity84 cells
Overall voltage310.8 V
Lubrication system
With filter8.6 L (9.1 qt., 7.6 Imp.qt.)
Without filter7.9 L (8.4 qt., 7.0 Imp.qt.)
A
B

414
-$@-$I@0.@0.&@ &&

8-1. Specifications
higher value) may be better suited if
the vehicle is operated at high
speeds, or under extreme load con-
ditions.
How to read oil container labels:
Either or both API registered marks
are added to some oil containers to
help you select the oil you should use.
API Service Symbol
Top portion: “API SERVICE SN” means the
oil quality designation by American Petro-
leum Institute (API).
Center portion: “SAE 5W-30” means the
SAE viscosity grade.
Lower portion: “Resource-Conserving”
means that the oil has fuel-saving and envi-
ronmental protection capabilities.
ILSAC Certification Mark
The International Lubr icant Specification
Advisory Committee (ILSAC) Certifica-
tion Mark is displayed on the front of the
container.
LC500h
■Oil capacity (Drain and refill [Ref-
erence*])
*: The engine oil capacity is a reference
quantity to be used when changing the
engine oil. Warm up the engine and turn
off the hybrid system, wait more than 5
minutes, and check the oil level on the
dipstick.
■Engine oil selection
“Toyota Genuine Motor Oil” is used in
your Lexus vehicle. Lexus recom-
mends the use of approved “Toyota
Genuine Motor Oil”. Another motor
oil of matching quality can also be
used.
Oil grade:
0W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving”,
SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC
multigrade engine oil
15W-40:
API grade SL, SM or SN multigrade
engine oil
Recommended viscosity (SAE):
SAE 0W-20 is filled into your Lexus
vehicle at manufacturing, and the best
choice for good fuel economy and
good starting in cold weather.
If SAE 0W-20 oil is not available, SAE
5W-30 oil may be used. However, it
should be replaced with SAE 0W-20
at the next oil change.
If you use SAE 10W-30 or a higher vis-
cosity engine oil in extremely low tem-
peratures, the engine may become
difficult to start, so SAE 0W-20 or
5W-30 engine oil is recommended.With filter5.7 L (6.0 qt., 5.0 Imp.qt.)
Without filter5.5 L (5.8 qt., 4.8 Imp.qt.)
A
B